
MM-2D-X
Product Spec Sheet
AD/DA CONVERTER
MM-2D-X
■ Specifications
General
・Formats and channels
44.1/48/88.2/96 kHz, 16/24-bit, 2 channels
Input/output ratings
・DATA/DATA+PoE connectors
Connector: RJ-45
Transmission protocol: Dante
Gigabit Ethernet standard: 1000BASE-T (IEEE 802.3ab)
Cables: category 5e or faster STP cables
・ANALOG IN connectors
Connector: XLR-3-31 (1: GND, 2: HOT, 3: COLD)
Minimun input level: -74 dBu
Maximum input level: +26 dBu
Input impedance: 2.0 kΩ or higher
・ANALOG OUT connectors
Connector: XLR-3-32 (1: GND, 2: HOT, 3: COLD)
Nominal output levels: +4 dBu (when Ref. Level not -9 dBFS)
+6 dBu (when Ref. Level set to -9 dBFS)
Maximum output level (switchable): +15 dBu (Ref. Level: -9 dBFS)
+18 dBu (Ref. Level: -14 dBFS)
+20 dBu (Ref. Level: -16 dBFS)
+22 dBu (Ref. Level: -18 dBFS)
+24 dBu (Ref. Level: -20 dBFS)
Output impedance: 200 Ω or lower
● 0 dBu = 0.775 Vrms
Jan, 2019
0093a -1-

MM-2D-X
Audio performance
● MIC IN ⇛ DANTE OUT
・Mic amp EIN (equivalent input noise)
-125 dBu (150 Ω, 22 kHz LPF+A, JEITA)
・Frequency response
±0.5 dB: 20 Hz – 20 kHz (44.1/48 kHz sampling frequency, JEITA)
±0.5 dB: 20 Hz – 40 kHz (88.2/96 kHz sampling frequency, JEITA)
・Distortion (THD+N)
0.005 % (when -1 dBFS input, 44.1/48/88.2/96 kHz sampling frequency, JEITA)
・S/N ratio
105 dB (44.1/48/88.2/96 kHz sampling frequency, JEITA)
・Crosstalk
100 dB (44.1/48/88.2/96 kHz sampling frequency, JEITA)
・Dynamic range
105 dB (44.1/48/88.2/96 kHz sampling frequency, JEITA)
● DANTE IN ⇛ LINE OUT
・Frequency response
±0.5 dB: 20 Hz – 20 kHz (44.1/48 kHz sampling frequency, JEITA)
±0.5 dB: 20 Hz – 40 kHz (88.2/96 kHz sampling frequency, JEITA)
・Distortion (THD+N)
0.005 % (when -1 dBFS input, 44.1/48/88.2/96 kHz sampling frequency, JEITA)
・S/N ratio
105 dB (44.1/48/88.2/96 kHz sampling frequency, JEITA)
・Crosstalk
100 dB (44.1/48/88.2/96 kHz sampling frequency, JEITA)
・Dynamic range
105 dB (44.1/48/88.2/96 kHz sampling frequency, JEITA)
Note: JEITA indicates compliance with JEITA CP-2150
Other
・Power
PoE class 0
TASCAM PS-P1220E AC adapter (sold separately)
・Power consumption
6 W
・Dimensions
214 × 44.45 × 136.1 mm (W x H x D, including protrusions)
・Weight
878 g
・Operating temperature range
0゜C – 40゜C
0093a -2-

MM-2D-X
■ Dimensional drawings
・Main unit
・Main unit with brackets installed
____________________________________________________________________________________________________________________________________________________
※TASCAM is trademark of TEAC CORPORATION, registered in the U.S. and other countries.
※Other company names, product names and logos are the trademarks or registered trademarks of their owners.
※Specifications and appearance are subject to change without notice.
※All information included in this document is as of Jan, 2019.
0093a -3-