Tascam ML-32D Specifications

ML-32D

Dec, 2017

Product Spec Sheet

32ch ANALOG/DANTE CONVERTER

ML-32D

■ Specifications
Ratings

・Formats

44.1/48 kHz, 16/24 bit

88.2/96 kHz, 16/24 bit

Input/output ratings

・PRIMARY/SECONDARY connectors

Connector: RJ-45
Transmission protocol: Dante
Gigabit Ethernet standard: 1000BASE-T (IEEE 802.3ab)
Cables: category 5e or faster STP cables

・ANALOG OUTPUTS connectors

Connector: D-sub 25-pin
Locking screws: No. 4-40 UNC (inch type)
Nominal output levels: +4 dBu, +6 dBu (only when maximum output level is +15 dBu)
Maximum output levels: +24 dBu, +22 dBu, +20 dBu, +18 dBu, +15 dBu (set by REF. LEVEL switches)
Output impedance: 200 Ω or lower
Applicable load impedance: 2 kΩ or higher

・ANALOG INPUTS connectors

Connector: D-sub 25-pin
Locking screws: No. 4-40 UNC (inch type)
Nominal input levels: +4 dBu, +6 dBu (only when maximum input level is +15 dBu)
Maximum input levels: +24 dBu, +22 dBu, +20 dBu, +18 dBu, +15 dBu (set by REF. LEVEL switches)
Input impedance: 10 kΩ or higher

●0 dBu = 0.775 Vrms

Audio performance

●ANALOG IN ⇛ DANTE OUT
・Frequency response

+0.1 dB/−0.5 dB: 20 Hz/20 kHz (−16 dBFS input, 44.1/48 kHz sampling frequency, JEITA)
+0.1 dB/−0.5 dB: 20 Hz/40 kHz (−16 dBFS input, 88.2/96 kHz sampling frequency, JEITA)

・Distortion (THD+N)

0.001% or less (-1 dBFS input, 1 kHz, 44.1/48/88.2/96 kHz sampling frequency, JEITA)

・S/N ratio

113 dB or higher (44.1/48/88.2/96 kHz sampling frequency, JEITA)

0064a -1- TEAC CORPORATION

ML-32D

・Crosstalk

115 dB or higher (1 kHz, 44.1/48/88.2/96 kHz sampling frequency, JEITA)

●DANTE IN ⇛ ANALOG OUT
・Frequency response

+0.1 dB/−0.5 dB: 20 Hz/20 kHz (−16 dBFS input, 44.1/48 kHz sampling frequency, JEITA)
+0.1 dB/−1.0 dB: 20 Hz/40 kHz (−16 dBFS input, 88.2/96 kHz sampling frequency, JEITA)

・Distortion (THD+N)

0.001% or less (-1 dBFS input, 1 kHz, 44.1/48/88.2/96 kHz sampling frequency, JEITA)

・S/N ratio

110 dB or higher (44.1/48/88.2/96 kHz sampling frequency, JEITA)

・Crosstalk

115 dB or higher (1 kHz, 44.1/48/88.2/96 kHz sampling frequency, JEITA)

Other

・Power

AC100-240 V, 50/60 Hz

・Power consumption

22 W

・Dimensions (width × height × depth)

483 × 45 × 303.8 mm (W x H x D)

・Weight

3.5 kg

・Operating temperature range

0–40゜C

■ Dimensional drawings

__________________________________________________________________________________________________________ __________________________________________

※TASCAM is trademark of TEAC CORPORATION, registered in the U.S. and other countries.
※Other company names, product names and logos are the trademarks or registered trademarks of their owners.
※Specifications and appearance are subject to change without notice.
※All information included in this document is as of Dec, 2017.

0064a -2- TEAC CORPORATION