Targus AMP01US User Manual

USER GUIDE

Wireless
Multimedia
Presenter with
Trackball

CAUTION

LASER RADIATION. DO NOT STARE INTO
THE BEAM OR VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS. CLASS I LASER
PRODUCT.

NEVER POINT A LASER BEAM INTO A
PERSON’S EYES OR VIEW A LASER BEAM
DIRECTLY, AS PROLONGED EXPOSURE CAN
BE HAZARDOUS TO THE EYES.

MOMENTARY EXPOSURE FROM A LASER
POINTER, SUCH AS AN INADVERTENT
SWEEP OF THE LIGHT ACROSS A PERSON'S
EYES, MAY CAUSE TEMPORARY FLASH
BLINDNESS SIMILAR TO THE EFFECT OF A
CAMERA FLASH BULB. ALTHOUGH THIS
CONDITION IS TEMPORARY, IT CAN
BECOME MORE DANGEROUS IF THE
EXPOSED PERSON IS ENGAGED IN A
VISION-CRITICAL ACTIVITY SUCH AS
DRIVING.

2

Introduction

System Requirements

Hardware

• PC

• USB interface

Operating System

• Windows® 98SE/ME/2000/XP

TARGUS WIRELESS

MULTIMEDIA

PRESENTER WITH

TRACKBALL

Congratulations on your purchase of the Targus Wireless
Multimedia Presenter with Trackball. The presenter is a
combination trackball mouse and multimedia presenter. With
thepresenter you can control cursor movement anywhere
within 20m of its receiver and project ared laser pointer beam.

NOTE: THE ACTUAL EFFECTIVE DISTANCE MAY INCREASE OR DECREASE

DEPENDING ON THE SURROUNDING ENVIRONMENT.

The Targus Wireless Multimedia Presenter also features
primary and secondary buttons (left and right mouse click
buttons) that emulate the page up/down keys when in
Presenter Mode and volume up/volume down keys when in
Multimedia Mode.

• Windows Vista™

3

Installing the Batteries

3 Slide the battery cover back into position until it “clicks”
firmly into place.

Connect Button

Battery Cover

Batteries

1 Remove the battery cover located on the bottom of the
presenter.

2 Insert the supplied batteries, making sure that the
positive (+) and negative (-) ends ofeach battery match the
polarity indicators inside the battery housing.

WARNINGS: WHEN REPLACING THE BATTERIES, YOU MAY USE ALKALINE

OR OTHER HEAVY-DUTY NIMH BATTERIES. NEVER COMBINE ANALKALINE
WITH A NIMH BATTERY IN A DEVICE.

AVOID MIXING NEW AND USED BATTERIES IN A DEVICE.

Targus Wireless Multimedia Presenter with Trackball

4

Targus Wireless Multimedia Presenter with Trackball

OFF

ON

4 Turn the power switch located on the side of the
presenter to the “On” position.

Connecting the Receiver
and Installing theDefault
Device Drivers

1 Plug the USB receiver into an available USB port on your
computer.

Windows®

98

SE/Me Operating Systems

The Add New Hardware Wizard appears.If it does not, the
operating system has installed the default driver automati­cally. No othersteps are necessary.

2 Click Next.The locate driver screen appears.

3 Select Search for the best driver for your device.
(Recommended) and then click Next.The wizard searches for
the appropriate device driver.

4 Click Next, then Finish to complete the driver installation.

5