Tannoy CMS 6TDC User Manual

CMS6 TDC ASSEMBLY INSTRUCTIONS

MODEL WITH TRANSFORMER
(SEE FIG. 2)

INSTALLING THE SPEAKER/SUB
PLATE ASSEMBLY

The RED and BLACK wires are connected
to the transformer as follows:

The BLACK lead to the transformer
primary "common" lead. The RED lead is
connected to the desired wattage tap.

WITHOUT TRANSFORMER

The RED wire connects to the crossover
terminal with the red dot. (Positive termi­nal). The BLACK lead connects to the
unmarked terminal. (Negative terminal).

FIGURE 1

CAN DIA.

117/8" 300mm

1

2

After connecting the RED and BLACK
leads to the speaker/sub assembly can
be attached to the enclosure.

Fasten the sub plate to the enclosure by
inserting the silver screws in the holes
labeled 1, 2, 3, and 4, as shown on Fig. 1.

The four remaining holes are used to
fasten the grille to the enclosure. Use the
white painted screws provided. Do not
over-tighten screws. Removable locktite
on these screws is recommended.

Note: A tile bridge is required for most
applications.

FIGURE 2

TO BOX INSTALLED

95/8"

246mm

75/8"

194 mm

MOUNTING

FLANGE

CAN

3

1

/4" 335mm

13

MOUNTING FLANGE DIA.

335 GAGE AVENUE, SUITE 1, KITCHENER, ONTARIO CANADA N2M 5E1

PHONE [phone] • FAX [phone] • E-MAIL: [e-mail]

4

12" 305mm

HOLE

CUT OUT DIA.

EXTENSION

7

/16" 11.5 mm