Tannoy CMS12 TDC User Manual

CMS12 TDC ASSEMBLY INSTRUCTIONS

MODEL WITH TRANSFORMER
(SEE FIG.2)

The 70 volt input wires are connected to
the transformer as follows:

The NEGATIVE lead to the transformer
primary "common" tap. The POSITIVE
lead is connected to the desired wattage
tap.

WITHOUT TRANSFORMER

The POSITIVE INPUT wire connects to
the crossover terminal with the red dot.
The NEGATIVE INPUT wire connects to
the unmarked terminal.

1

14

/2" 368 mm

181/4"

1

6

464mm

2

INSTALLING THE SPEAKER/SUB
PLATE ASSEMBLY

After connecting the INPUT WIRES to the
speaker/sub assembly it can then be
attached to the enclosure.

Fasten the sub plate to the enclosure by
inserting the silver screws in the holes
labeled 1, 2, 3, 4, 5 and 6, as shown on
Fig. 1.
The four remaining holes are used to
fasten the grille to the enclosure. Use the
white painted screws provided. Do not
over-tighten screws. Removable locktite
on these screws is recommended.

FIGURE 2FIGURE 1

231/4" 591mm

121/4"

311mm

141/2" 368mm

5

4

123/8" 315mm

335 GAGE AVENUE, SUITE 1, KITCHENER, ONTARIO CANADA N2M 5E1

PHONE [phone] • FAX [phone] • E-MAIL: [e-mail]

3

254mm

10"

151/4" 387mm