TOS Platinum SE / TOS Platinum
TOS / TOW Series
OUTDOOR-INDOOR and ON-WALL SPEAKERS
Instruction Manual
Edition 09-18
2
Introduction
Thank you for purchasing TAGA Harmony Speakers.
TAGA Harmony speakers are the ideal solution for outdoor (selected models – conrm
which with your local dealer) and indoor sound systems.
They provide clean, natural, dynamic and powerful sound performance.
Most models are weather, UV and water resistant.
Mounting brackets (selected models) make installation very easy as well as speakers
can be mounted horizontally and vertically.
The SM (stereo / mono) models ensure high quality, dual-channel sound from a single
speaker. The SM models can provide much wider dispersion than traditional speakers
as well as eliminate sound imbalances which can be heard once listeners move around
the area.
This instruction manual provides all of the information that you need to know about
your TAGA Harmony speakers. Please read it carefully before you start using the unit.
Cleaning
Do not use strong or abrasive cleaners. Use a dry, soft cloth for cleaning.
Specications
Full technical specications are available on the www.TagaHarmony.com website.
3
Contents
Speaker Placement 4
Hooking Up the Wires 7
Speaker Mounting 8
Additional Info 10
Notes 11
Speaker Placement
Please spend some time considering placement prior to installing the speaker. Once it is
installed, it is not to be easily moved or repositioned. Each room has its specic acoustics but
there are some general rules:
LOCATION
TAGA Harmony speakers can be installed almost anywhere thanks to our unique sound characteristic
which is strong and powerful, and has a wide dispersion eld.
All TOS speakers are equipped with regulated U mounting brackets. Some TOS models have an
option to use other mounting brackets, which are not included with the speakers (check this option
with your local dealer).
GENERAL NOTES
On-wall On-ceiling (not applicable for TOW Series)
Placing the speakers near a corner will tend to
increase their bass output, but may result in
“boomy” or “muddy” sound.
Corner placement close to the walls provides
a good balance of bass output and accuracy.
Placing the speakers further into the room
will tend to decrease their bass output, but may
result in improved articulation and clarity.
Place the speakers at least 60 cm (2 feet) away from corners an d other surfaces which may
interfere or reect sound (like tall furniture).
To add extra bass and denition to your system we recommend TAGA Harmony Custom
Installations or traditional subwoofers.
On-wall On-ceiling (not applicable for TOW Series)
Place the front left and right speakers at an
equal distance from your listening position,
at ear level while seated.
Place the left and right speakers at an equal
distance from your listening position.
Aim the speaker toward your listening position
(if your speakers have this feature).
If the speakers are installed on a wall which
is around 300 cm (10 feet) away from your
listening position, place them no more than
300 cm (10 feet) apart from each other
and no less than 150 cm (5 feet).
Place the speakers no more than 300 cm
(10 feet) apart from each other and no less
than 150 cm (5 feet).
All speakers except Stereo/Mono
Placement for critical listening in stereo (2 speakers)
On-wall On-ceiling (not applicable for TOW Series)
In rectangular smaller rooms [below 30 square
meters (320 square feet)] usually 1 or 2
speakers should work ne. If you use 2 – place
them near opposite corners. If you use 1 –
place it on the most empty and biggest wall.
In rectangular smaller rooms [below 30 square
meters (320 square feet)] usually 1 or 2
speakers should work ne. If you use 2 – place
them near opposite corners.
If you use 1 – place it in the center .
In irregular or larger rooms use more than 2 speakers and place them evenly across the space
for good sound dispersion.
Placement for entertainment listening or background music (1 or more speakers)
4
5
Speaker Placement
Placement for Home Theatre
(the pictures shown for the listening position in the middle of the room)
On-wall On-ceiling
5.0/5.1 Systems
5.0/5.1 Systems
.
6.0/6.1 Systems 6.0/6.1 Systems
7.0/7.1 Systems 7.0/7.1 Systems
6
Speaker Placement
On-wall On-ceiling (not applicable for TOW Series)
FRONT SPEAKERS
Place the left and right speakers at an equal
distance from your listening position, slightly
above ear level while seated.
If the speakers are installed on a wall which is
around 300 cm (10 feet) away from your
listening position, place them no more than
300 cm (10 feet) apart from each other and no
less than 150 cm (5 feet).
Place the left and right speakers at an equal
distance from your listening position, in front of
your TV and about 60 – 90 cm (2 – 3 feet)
away from the wall.
If the speakers are installed around 300 cm
(10 feet) away from your listening position,
place them no more than 300 cm (10 feet)
apart from each other and no less than 150 cm
(5 feet).
CENTER SPEAKER
Place the speaker at ear level while seated. If
you have a TV mounted on wall, place the
speaker slightly below it. If you have a TV on
a table, place the speaker above it and angle
the speaker down towards ear level while seated
(if your speaker is equipped with the U bracket).
6.0/6.1 systems – place the second center
speaker (rear center) on the opposite wall to the
rst one – at the same height and angle the
speaker down towards ear level while seated
(if your speaker is equipped with the U bracket).
Place the speaker horizontally in the middle of
the front left and right speakers. Aim the
speaker towards the listening position (if your
speaker is equipped with the U bracket).
6.0/6.1 systems – place the second center
speaker (rear center) behind your listening
position, in line with the front center speaker .
Aim the speaker towards the listening position
(if your speaker is equipped with the U bracket).
SURROUND SPEAKERS
Place the speakers above ear level while seated,
but no higher than ear level while standing.
5.0/5.1/6.0/6.1 systems – place the right and
left surround on the right and left side of your
listening position.
7.0/7.1 systems – place the right and left surround on the right and left side of your listening
position. The two additional rear surround speakers should be placed behind your listening
position. They should be place at equal
distances from your listening position, and about
half as far as the right and left surrounds. All
four surrounds should be mounted at the same
height.
5.0/5.1/6.0/6.1/7.0/7.1 systems – place the
right and left surround on the right and left side
of your listening position, as far apart as your
front left and right speakers.
7.0/7.1 systems – place the rear right and left
surrounds behind your listening position, at
equal distances from your position. They
should be about half as far apart as the right
and left surround speakers positioned on the
sides.
We recommend to use TAGA Harmony in-wall/in-ceiling or traditional subwoofer in all Home
Theatre systems.
7
Speaker Placement
STEREO CONNECTION MONO CONNECTION
SINGLE SPEAKER
In smaller areas where a stereo pair of
speakers cannot be used or where a single
speaker is preferred to be used.
7.0/7.1 systems – use the speaker as rear
center speaker. Position tweeters towards the
left and right sides of the room.
6.0/6.1 systems – use the speaker as rear
center speaker. Position tweeters towards the
left and right sides of the room.
MULTIPLE SPEAKERS
In larger areas to eliminate the sound
imbalances and oer better sound coverage.
7.0/7.1 systems – use two speakers as
surround speakers. Position one tweeter of
each speaker towards the front side of the
room and the other tweeter towards the
back side.
5.0/5.1 systems – use two speakers as
surround speakers. Position one tweeter
of each speaker towards the front side of the
room and the other tweeter towards the back
side.
The speaker terminal can accommodate up to 10 AWG speaker cables (selected models
only - others up to 14 AWG). 10 or 14 AWG speaker cables are recommended for longer
connections (greater than 20 meters / 66 feet)). For shorter lengths you can use 16 or 18
AWG speaker cables. It is recommended to leave about 150 cm (5 feet) of extra cable at the
speaker end to facilitate positioning and installation of the speaker. Do not use staples, nails
or other metal objects to secure the speaker cables. You will get the best sound quality and
least amount of hum by keeping the speaker cables away from other electrical wires and
cables.
Pay attention to connecting the polarity of the speaker correctly with the amplier speakers
output terminals (RED + with RED +, BLACK - with BLACK -). Before connecting the speaker
make sure that your amplier is switched o. Please refer to your amplier’s instruction
manual for more information.
Hooking Up the Wires
WARNING! Check whether your amplier may work with impedance of your TAGA Harmony
speaker. Otherwise you may burn the amplier and damage the speakers - it may void your
warranty.
Placement for Stereo/Mono models
TAGA Harmony Stereo/Mono models oer wider sound dispersion than regular speakers.
8
Stereo/Mono Models
STEREO CONNECTION MONO CONNECTION
Connect a single speaker to two amplier speakers output terminals.
Connect one amplier speakers output terminal with one speaker input terminal (RED + with
RED +, BLACK – with BLACK -), connect the
other amplier speakers output terminal with
the other speaker input terminal (RED + with
RED +, BLACK – with BLACK -).
Connect a single speaker to a single amplier
speakers output terminal.
Connect one amplier speakers output terminal with one speaker input terminal (RED + with
RED +, BLACK – with BLACK -). Using a short
piece of speaker cable connect Left + (RED)
speaker input terminal with Right + (RED)
speaker terminal. Do the same for - terminals
(BLACK).
Run the speaker cable to location where the speaker is to be installed. Leave about 20 cm
(0.66 feet) of extra cable (if the speaker cable is hidden in a wall or ceiling make a hole in the
center of the location of the speaker).
• TOS using U mounting bracket with horizontal regulation:
- Run the speaker cable through an installation hole in the middle of the U bracket.
- Position the bracket on the wall or ceiling where you want to mount the speaker, and mark
places of mounting the screws.
- Screw the U mounting bracket onto the wall or ceiling where you want to mount the speaker.
WARNING! Depending on the mounting surface use appropriate screws or wall anchors (ask your
local dealer or installer for advice).
- Connect the speaker cable to the speaker terminals.
- Slide the speaker into the U bracket and screw top and bottom bracket knobs to the speaker to
secure the speaker in the bracket.
- Adjust the horizontal position of the speaker and fasten (screw in rmly) the knobs. In the future
the knobs can be loosen to adjust the speaker horizontal position.
Speaker Mounting
Hooking Up the Wires
9
• TOW models:
- Screw a hook in the wall where you want to mount the speaker.
WARNING!
Depending on the mounting surface use appropriate screws or wall anchors (ask your local dealer
or installer for advice).
- Connect the speaker cable to the speaker terminals.
- Hang the speaker on the hook.
Note! Screws, hooks and wall anchors may not be included with your speakers.
TOS using U mounting bracket with horizontal and vertical regulation:
- Using 4 screws install the wall mount (A) on the wall or ceiling where you want to mount the
speaker (Fig. 1).
WARNING! Depending on the mounting surface use appropriate screws or wall anchors (ask your
local dealer or installer for advice).
- Attach the U bracket (C) to the wall mount (A), slide in the locking cover (B) and secure it with 4
screws (Fig. 2).
- Remove the speaker terminal box cover, connect the speaker cable to the speaker terminals
and rmly place the cover back. (Fig. 3)
- Slide the speaker into the U bracket and screw top and bottom bracket knobs to the speaker to
secure the speaker in the bracket. (Fig. 4)
- Adjust the horizontal position of the speaker and fasten (screw in rmly) the knobs. In the future
the knobs can be loosen to adjust the speaker horizontal position (Fig. 5).
- Adjust the vertical position of the speaker and secure the chosen position by installing 2 screws
on the side of the wall mount (A). In the future the side screws can be removed to adjust the speaker vertical position (Fig. 5).
Speaker Mounting
1
2
3
4
5
www.TagaHarmony.com
IMPORTANT!
Your product is marked with the symbol as showed on the left.
For EU (European Union) member users:
According to the WEEE (Waste electrical and electronic equipment)
Directive, do not dispose of this product as household waste or commercial waste.
Waste electrical and electronic equipement should be appropriately collected and
recycled as required by practices established for your country.
For information on recycling of this product, please contact your local authorities, your
household waste disposal service or the shop where you purchased the product.
Your product is marked with the symbol as showed on the left.
For EU (European Union) member users:
This product has been tested and found in compliance with
requirements of the European Community
2014/30/EU (EMC) directive.
TAGA EUROPE
POLPAK POLAND Sp. z o.o.
AL.JEROZOLIMSKIE 333A
05-816 REGUŁY k/WARSZAWY, POLAND
Email: Sales@TagaHarmony.com
Additional Info (not applicable for all models)
• Outdoor Use - most TOS speakers are weather, UV and water resistant and are designed for
use outdoors (selected models – conrm which with your local dealer).
• U Brackets – All TOS speakers are equipped with U mounting brackets which allow horizontal
regulation and selected models additionally have vertical regulation (conrm which with your
local dealer).
We strongly advise to contact a professional installer or dealer in order to install TAGA
Harmony products.
We recommend using high quality TAGA Harmony cables and other installation
accessories.
Notes
Notes
Loading...