System Sensor SPH-15R User Manual

D600-02-00 1 I56-1899-000R
3825 Ohio Avenue, St. Charles, Illinois 60174
1-800-SENSOR2, FAX: 630-377-6495
www.systemsensor.com
INSTALLATION AND MAINTENANCE INSTRUCTIONS
SPH-15R Supervised Horn Loud Speaker
General Description
The SPH-15 Series speaker includes a supervisory capacitor and is suitable for installation in systems employing super­vised circuitry.
Specifications
Power: 15 Watts (max.) Sound Level: 102 dB (15 watts input) Frequency Response: 400–4000 Hz Conduit Connection:1⁄2″ NPT
13/4
2
7
/8 Dia.
1
/2 Banding
Slot
9
/32 Dia. 3 Holes 120 Deg. Apart,
on 2.312 Dia. B/C
2
Mounting Dimensions
Power Tap Selector Switch
Note: Terminal #2 is the positive terminal.
Switch 25 V dB @ 70 V dB @ Position Impedance Line 10 ft.* Line 10 ft.*
1 5.0K .9 W 93 2 2.5K 1.8 W 96 3 1.3K .48 W 90 3.8 W 96 4 666 .94 W 90 7.5 W 99 5 333 1.8 W 93 15.0 W 102
6897.5 W 99
74515.0 W 102
*UL 3 dB Increment Rating
Wiring Diagram
To conform with UL requirements, wires must be connect­ed as shown in wiring diagram. Note: The maximum wire size that can be connected to
this device is 12 gauge.
CAUTION: Do not loop wires under screw terminals. Break
wire run to provide supervision of connection.
A78-2717-00
A78-2718-00
A78-2716-00
Three-Year Limited Warranty
System Sensor warrants its enclosed speaker to be free from defects in materials and workmanship under normal use and service for a period of three years from date of manufacture. System Sensor makes no other express war­ranty for this speaker. No agent, representative, dealer, or employee of the Company has the authority to increase or alter the obligations or limitations of this Warranty. The Company’s obligation of this Warranty shall be limited to the repair or replacement of any part of the speaker which is found to be defective in materials or workmanship under normal use and service during the three year period com­mencing with the date of manufacture. After phoning System Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization number, send defective units postage prepaid to: System Sensor, Repair Department, RA
#________, 3825 Ohio Avenue, St. Charles, IL 60174. Please include a note describing the malfunction and suspected cause. The Company shall not be obligated to repair or replace units which are found to be defective because of damage, unreasonable use, modifications, or alterations occurring after the date of manufacture. In no case shall the Company be liable for any consequential or incidental damages for breach of this or any other Warranty, expressed or implied whatsoever, even if the loss or dam­age is caused by the Company’s negligence or fault. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclu­sion may not apply to you. This Warranty gives you specif­ic legal rights, and you may also have other rights which vary from state to state.
7
8
6
5
4
1
3
2
12
Speaker 1 Speaker 2
From Amplifier
1
2
1
2
To Next Speaker or End-of-Line Resistor
Loading...