353SR-5, 353SR-6
Dia™ Curved Shower Rod
Operation & Maintenance Manual
Model Number
Specifications
353SR-5 5' Curved Shower Rod
353SR-6 6' Curved Shower Rod
Dimensions
For 60" Standard Tub
Mount rod approximately 3" inside the point a
straight rod is normally mounted. The midpoint
of the rod should extend several inches past the
outside rim of the tub.
For 60" Oval Tub
Depending upon tub model, mount rod between
6" and 8" from centerline of the tub. The middle
portion of the rod should curve just outside the
contour of the tub.
5' and 6' curved shower rod made from metal materials
plated in standard polished chrome nish.
Warranty
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Measurements
A 60”, 1524 mm
B 2 1/8”, 54 mm
C 10 1/2”, 267 mm
Required for Installation
Phillips head screwdriver
Note: Dimensions are subject to change without notice.
B
B
AA
CC
Installation
1) Position mounting brackets
into desired location. Mark hole
positions with pencil.
2a) Dry Wall Option:
Carefully drill
3/16" holes into wall. Install
anchors into holes.
2b) Stud Option:
Carefully drill 3/16"
holes through wall and into
studs.
3) With mounting brackets in
position, secure to wall using
screws.
4) Insert rod brackets into mounting
brackets and secure with Allen
screws.
1
5) Insert shower rod into rod brackets
and secure with Allen screws.
2
1
2
Care and Cleaning
1) Clean nished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse
with water.
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ Phone: (800) 796-6667 ■ Fax: (800) 961-9621
Copyright © 2015 Symmons Industries, Inc. ■ www.symmons.com ■ gethelp@symmons.com ■ ZV-3015 REV A ■ 032715
Loading...