Swiftech MCR80 User Manual
MCR80 radiator
#6 X 7/8” Philips screw type B
Nylon washers
1
4
Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Packing list
8
80mm fan guard
80x80x15mm fan
Double snap grip hose clamp size C
1
2
2
*
Note of caution regarding the
The fan guard and nylon washers MUST BE INSTALLED when using the provided self
tapping screws. They are necessary to allow sufficient clearance between the tip of the
screws and the radiator core. Failure to use them will systematically result in permanent
damage to the radiator, as the screws will otherwise punch a hole in the core channels.
Users are advised that such damage is not covered under our warranty.
Likewise, if fans other than the provide 80x80x15mm fans a
carefully check the clearance remaining between the retention screws and the radiator
core.
Page 1 of 2
inlet/outlet side of the radiator:
re installed, users should
-
Sound
Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Installing the tubing:
It is usually easier to install the tubes before the
radiator is fastened to the case. Cut sufficient
length
circuit and tighten the clamps to the radiator
inlet and outlet. There should be only 3 to 4
notches left “open” once the clamp is fully
tightened.
of tubing to connect to the rest of the
Electrical connection:
Once
the radiator is installed inside the case, the final step is to connect the molex connector to your
computer power supply.
Radiator specifications:
Height: 4.1” (104.8mm); Width: 3.25” (82.5mm); Depth:
3.2” (81.6mm)
2-
pass 80 mm rad
CPU and VGA liquid cooling
Double-row high internal volume design
Rated for 236.6 KCal per hour (938.89 BTU per hour) or
275W
80 mm (3 inch) Copper core consisting of flat tubes for
maximum heat conductivity
High-dens
dissipation
3/8" OD inlet and outlet for use with 3/8" ID tubing.
ity copper fin configuration for enhanced heat
iator specifically developed for PC
Fans specifications:
Each fan:
Part #
G8015
Voltage
-
L
(V)
12
Current
(mA)
120
Revolution
(RPM)
3200
Volume
(CFM)
29
Max
Static
pressure
(InH20)
0.11
Noise
(dBA)
32
Page 2 of 2
Loading...