LOCATION OF CONTROLS
S/N:
OUTPUT
(HC)
110-240 V, 50/60 Hz
1
10 11 12 13 14
2
A
3
6
15 16 17 18
19
20
7 98
5 4
Names of controls and indicators
1. STANDBY led indication
2. Skip forward or Next Channel button
3. Play /Pause button
4. Open / Close button
5. Skip backward or Previous Channel button
6. Power /Function button
7. Headphone out
8. SD/MS/MMC card slot
9. USB Connector
10. FM Antenna
11. Aux input left/right (RCA)
12. YUV(Y/Cb/Cr) output
13. Video out
14. AC Power Cable
15. Audio out left/right (RCA)
16. Spdif coaxial digital out
17. S-Video out
18. Spdif optical digital out
19. POWER on/off button
20. Speakers output
A Volume Up/Down control knob
FUNCTION INSTRUCTIONS OF REMOTE CONTROL
1.STANDBY
2. -/-- (2 digits input)
3. Volume Up
4.Title
5.Volume down
6.Direction left
7.ENTER
8.LCD Menu
9.INPUT
10. EQ
11. Play/Pause
12. Stop
13. Fast rewind
14. Fast forward
15. Skip backwards
16. Skip forward
17. Program in DVD mode or Memory function in FM
18. INTRO
19. Repeat A-B in DVD mode
20. Repeat function or select stereo in FM
21. Subtitle
22. Zoom
23. Angle
24. Return
25. Audio
26. Slow
27. Mute
28. Tone
29. DVD setup
30. Direction down
31. Direction right
32. Direction up
33. Previous Channel
34. Display
35. Next Channel
36. MENU
37. Cycle
38. Number
39. Open/Close
PRESET EQUALIZER OPERATION
This unit has four pre-set equalizing effects: FLAT, ROCK, POPS, JAZZ
and CLASSIC. You can get your favorite EQ effect by pressing the
corresponding button on the unit.
EARPHONE OUTPUT OPERATION
Connect the earphone to the socket and adjust the volume as desired.
Once plugged in, the speaker output will be automatically cut off. Please
note that the earphone is 3.5mm diameter.
RADIO OPERATION
This unit can receive FM radio stations. There are three modes for
receiving broadcasts: manual selection, automatic selection and preset
selection.
NOTE:
Before receiving radio broadcast, please check that the antenna has been
correctly connected.
a. Radio station selection
(1) Press the FUNCTION button on the unit or the INPUT button on the
remote control to select TUNER source.
(2) You can choose any of the following ways to select the radio station of
your choice:
MANUAL SELECTION
Press the /TUN+ button or the /TUN- button, and the frequency
will change little by little, till adjust to which you want.
AUTOMATIC SELECTION
If you press the /TU+ button or the /TU- button for more than one
second, the frequency will automatically be adjusted up or down, till find a
station.
PRESET SELECTION (IT CAN ONLY BE USED AFTER THE RADIO
STATION HAS BEEN SET)
Press the NUMBER buttons to select the radio station that you want to
preset. Then LCD will display the band and the frequency of the radio
station which you preset.
b. Preset radio station
You can preset 16 stations.
(1) Press the NUMBER buttons to choose the number firstly. The preset
number will display on the screen.
(2) Tune to the radio station that you wish to store.
(3) Press the PROG/MEM button on the remote control and the word
“MEMORY” will display on the LCD. And the number you choose will
flash on the LCD.
(4) Press the PROG/MEM button on the remote control again and you can
store the frequency of the radio station, on the LCD the word
“MEMORY” will disappear.
Loading...