Swann PPW-250 Specification
Wireless / Wired Security Camera
PPW-250 Easy Setup Guide
A
C
Extension Cable
Receiver Power
Supply
Back of
Receiver
Easy Set up Components
Camera and Stand
Power only Cable for
Wireless Connection
Camera Power
Supply
BNC to RCA
Adapter
Receiver
Power & BNC
Cable for Wired
Connection
Video Cable
Connecting the receiver to your TV
Back of TV
45
B
Connecting the receiver to record on a VCR
Back of TV
45
2
Input
Output
1
Back of VCR
4
13
Video
Inputs
Component
Inputs
Output
3
1. Using supplied video cable, connect one end to receiver
2. Connect other end of video cable to INPUT on VCR
5
3. Using another video cable (not supplied) connect to VCR OUTPUT
4. Connect other end of video cable to INPUT on TV
5. Connect power cable to receiver
Connect the video
cable to the back
of the receiver
13
Video
Component
Inputs
Output
Inputs
Connect one end of the
cable to your TV Input
D
Power on the receiver,
1.
VCR and TV
2. 3. 4.
Using your TV’s remote
control tune your TV to
the correct INPUT*. In our
Viewing the camera and recording to VCR
Using your VCR’s remote
control tune your VCR to
the LINE 1 INPUT*
example above the TV
should be set to INPUT 1
*Some VCR’s and TV ’s will list this as INPUT, A/V, SOURCE, L1, Channel 0 - Consult your manufacturer’s manual for more information
You should now see
your cameras on the
TV screen. Follow
your manufacturer’s
instructions to
record to your VCR
www.swannsecurity.comSwann Communications • Toll Free Technical Support: USA - 1-800-627-2799, Australia - 1300 13 8324 • Email: tech@swannsecurity.com
SR231-WMX-1R005-060409
Cab
le
for
wi
red
cti
on
Wireless / Wired Security Camera
PPW-250 Easy Setup Guide
G
G
Setting up Wireless or Wired options
To Power Supply
Cable for wired connection
conne
To DVR/Monitor
OR
To Power Supply
Cable for wireless connections only
Achieving the highest quality wireless signal
FE
Cordless Phones/Mobiles
Wireless Internet
Note: Wireless and electronic devices such as these can interfere with camera
transmission if they are within the cameras range.
Some Electronic Devices
If possible turn off or keep
the camera and receiver
away from wireless devices
Wireless Camera Positioning
Some wireless devices can
be set to different frequencies.
Consult the manufacturer’s
manual for details
A clear line of sight with little wireless interference
will always give you the strongest picture
Walls and floors can also limit range and image results. Place the receiver in a location that
is relatively close to the camera’s position
H
1. Test the camera signal before permanently installing the cameras.
2. Using battery power is only recommended for testing purposes as the cameras do require constant power to operate.
3. IR or night vision will reflect off of glass or windows and overexpose the picture. Try placing cameras in direct line of
sight of your subject.
4. Never aim the camera directly at the sun as this can permanently damage the lens.
5. Never submerge the camera in water. Some shelter is recommended such as an awning or eave.
General Installation Notes and Tips
www.swannsecurity.comSwann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: tech@swannsecurity.com
Loading...