Retro 16” (40cm) Stand Fan
Model: SFA12610 (all colours)
Help line
0333 220 6050
SFA12610_IM.indd 1 10/11/2017 11:47
v1.0
IMPORTANT INFORMATION - RETAIN FOR FUTURE USE
When using any electrical appliance, basic safety
precautions should always be followed including the
following:
• Always ensure that the voltage on the rating label
corresponds to the mains voltage in your home
• Incorrect operation and improper use can damage the
appliance and cause injury to the user.
• This appliance can be used by children aged from 8
years and above if they have been given supervision or
instruction concerning use of the appliance in a safe way
and if they understand the hazards involved. Cleaning and
user maintenance shall not be made by children unless
they are older than 8 and supervised. Keep the appliance
and its cord out of reach of children aged less than 8
years. Check the power cord and plug regularly for any
damage. If the cord or the plug is damaged, it must be
replaced by the manufacturer or qualified person in order
to avoid an electrical hazard.
• Appliances can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved.
• Do not use the appliance if it has been dropped or
damaged in any way. In case of damage, take the unit in
for examination and/or repair by an authorised service
agent.
• Never immerse the unit in water or any other liquid for
2
SFA12610_IM.indd 2 10/11/2017 11:47
IMPORTANT INFORMATION - RETAIN FOR FUTURE USE
cleaning purposes.
• Remove the plug from the socket by gripping the plug.
Do not pull on the cord to disconnect the appliance from
the mains. Always unplug the unit when not in use, before
cleaning or when adding or removing parts.
• The use of accessory attachments that are not
recommended or supplied by the manufacturer may
result in injuries, fire or electric shock.
• Do not let the cord hang over the edge of a table or
counter. Ensure that the cord is not in a position where it
can be pulled on inadvertently.
• Do not allow the cord to touch hot surfaces and do not
place on or near a hot gas or electric burner or in a
heated oven.
• Do not use the appliance on a gas or electric cooking top
or over or near an open flame.
• Use of an extension cord with this appliance is not
recommended. However, if it is necessary to use an
extension lead, ensure that the lead is suited to the power
consumption of the appliance to avoid overheating of
extension cord, appliance or plug point. Do not place the
extension cord in a position where it can be pulled on by
children or animals or tripped over.
• This appliance is not suitable for outdoor use. Do not use
the appliance for anything other than its intended use.
• Do not carry the appliance by the power cord.
• Do not leave the appliance unattended during use. Always
unplug the unit when not in use or before cleaning.
• Always operate the appliance on a smooth, even, stable
3
SFA12610_IM.indd 3 10/11/2017 11:47
IMPORTANT INFORMATION - RETAIN FOR FUTURE USE
surface. Do not place the unit on a hot surface.
• Ensure that the unit is switched off after use.
• The manufacturer does not accept responsibility for any
damage or injury caused by improper or incorrect use, or
for repairs carried out by unauthorised personnel.
• In case of technical problems, switch off the product and
do not attempt to repair it yourself. Return the appliance to
an authorised service facility for examination, adjustment
or repair. Always insist on the use of original spare parts.
Failure to comply with the above mentions precautions
and instructions, could affect the safe operation of this
product.
• Your appliance must never be switched on through an
external timer or any kind of separate remote control
system
• This appliance is intended to be used in household and
similar applications such as: staff kitchen areas, in shops,
offices and other working environments; farm houses;
by clients in hotels, motels and other residential type
environments; bed and breakfast type environments.
• Keep loose clothing and hair away from the fan
4
SFA12610_IM.indd 4 10/11/2017 11:47
PARTS & ASSEMBLY
1. Front Grille
2. Fan Blade
3. Fan Blade Screw
4. Rear Guard Screw
5. Rear Grille
6. Motor Shaft
7. Oscillation Knob
8. Speed Control
9. Motor Unit
10. Connector Screw and Nut
11. Inner Pole
12. Height adjust knob
13. Outer Pole
14. Base
15. Heavy Weight
16. Fastener
17. Locking Screw
Fan Grille Assembly
1. Fasten the rear grille onto
2. Install the Blade onto the
3. Centre the front grille by
4. Secure the front and rear
the motor with four screws.
Motor Shaft by tightening
the blade screw.
aligning the logo on the grille
Hub so it is horizontal and
parallel to the floor.
grilles completely together
by snapping grille clips into
place. Lastly, tighten the grill
e locking screw at the bottom
of the Rear Grille.
Base Assembly
1. Unscrew the Fasten Ring and Base Locking Nut from the Stand Assembly.
2. Insert the Stand Assembly through the hole in the centre of the Base and twist into
position.
3. Turn the Stand Base upside down with the Stand Assembly facing the floor and place
the Base Weight (15) to the bottom of the Base. Tighten the Base Weight to the Stand
Base by the fastener and locking screw.
4. Finally, connect the assembled fan head and stand with the connector screw and nuts,
ensure it’s strong enough and all fastenings are sufficiently tight.
5
SFA12610_IM.indd 5 10/11/2017 11:47
HOW TO USE
• Turn the speed control to selected speeds: 0 (off) and 1 (slow), 2 (medium), 3 (fast)
• Set the tilt angle by adjusting the fan head accordingly.
• You can tighten/loosen the screw on the neck of the fan to lock the tilt
angle
• Never touch the blades with hands or any object. Keep long hair away
from the fan blades
• There is an oscillation control on top of the fan motor. Press down to
make the fan sweep left and right. Lift up to stop the oscillation motion.
• Adjust the height. Take the weight of the fan head assembly, loosen
the Height Adjust Knob, set the desired height, then tighten the Height
Adjust Knob again.
CLEANING & MAINTENANCE
Your fan requires little maintenance and contains no user serviceable parts.
Do not attempt to dismantle the unit yourself. The fan is permanently lubricated and will not require additional lubrication.
Cleaning:
• Always unplug the fan from the mains outlet before cleaning.
• The fan can be cleaned with a soft dry cloth. Deposits of dust can be removed by using a vacuum cleaner, ensuring that the air vents and grilles
remain free from dust to prevent overheating.
• Important: Do not allow water to run into the interior of the fan, as this
can cause an electric shock.
• Do not use abrasive cleaners or chemical agents to clean the product.
• When not in use, store the fan in it’s retail box.
TECHNICAL DATA
Description: RETRO 16” (40cm) STAND FAN
Model: SFA12610 (all colours)
Input Voltage: 230V 50Hz 50 Watts
6
SFA12610_IM.indd 6 10/11/2017 11:47
WARRANTY
This product is guaranteed for 2 years from the date of original purchase. If any defect arises due to faulty
materials of workmanship the faulty products must be returned to the place of purchase. Refunds or
replacement is at the discretion of the store.
The following conditions apply:
• The product must be returned to the retailer with proof of purchase.
• The product must be installed and used in accordance with the instructions contained in this
instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• Swan Products Ltd has limited liability for incidental or consequential loss or damage.
• This guarantee is valid in the UK and Eire Only.
BS PLUG
The wires in the mains lead are coloured in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour markings
identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or
coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red. The wire which is coloured GREEN/YELLOW must be connected to the
terminal which is marked with the letter E or (earth symbol) and is coloured GREEN or GREEN/YELLOW.
WARNING: THIS APPLIANCE MUST BE EARTHED
DISPOSAL OF UNIT
Appliances bearing the symbol shown here may not be disposed of in domestic rubbish. You
are required to dispose of old electrical and electronic appliances like this separately.
Please visit www.recycle-more.co.uk or www.recyclenow.co.uk for access to information
about the recycling of electrical items. Please visit www.weeeireland.ie for access to information
August 2006, states that all electrical items must be recycled, rather than taken to landfill. Please arrange
to take this appliance to your local Civic Amenity site for recycling, once it has reached the end of its life.
SFA12610_IM.indd 7 10/11/2017 11:47
about the recycling of electrical items purchased in Ireland. The WEEE directive, introduced in
7
www.swan-brand.co.uk
Copyright © Swan Products Ltd.
PO Box 3117, Stoke-on-Trent ST4 9GD
Est.1931
We love
what we do
s
2 year
GUARANTEE
we’re proud
of o ur qua lity
Scan this QR code
to hear about
our story
Find us on Facebook
*
* on selected products
SFA12610_IM.indd 8 10/11/2017 11:47
Loading...