All trademarks are the property of their legal holders.
NOTICE OF RESPONSIBILITY RESTRICTION
Despite the exerted eԚorts to make this Manual more exact, some discrepancies may occur. The
information in this Manual is given on «as is» terms. The author and the publisher do not bear any
liability to a person or an organization for loss or damage which has arisen from the information
contained in this Manual.
CONTENTS
RUS ...................................................................................................
Ϝ Unpack the device carefully. Make sure there are no accessories left in the box. Check up the
device for damage; if
carried out the delivery; if the product functions incorrectly, address the dealer at once.
Ϝ Check up the package contents and availability of the warranty card. Make sure the warranty
card has a shop stamp, a legible signature or the seller’s stamp and purchase date, and the goods
number corresponds to that in the warranty card.
Ϝ Do not switch on the speaker system immediately after you bring it into a room from environment
with negative temperature! After unpacking, the speaker system should be kept in conditions of
room temperature for at least 4 hours.
Ϝ Before installing and using the speaker system, read this Manual carefully and keep it for future
reference.
the product was damaged during transportation, address the ԛrm which
Technical support is on www.sven.Н
15
ENG
2.1 Multimedia Speaker System
2. PACKAGE CONTENTS
• Subwoofer – 1 pc
• Satellites – 2 pcs
• Signal cable 2RCA to mini-jack Ø 3.5 mm – 1 pc
• Operation manual – 1 pc
• Warranty card – 1 pc
3. SAFETY PRECAUTIONS
Caution! High voltage inside! To avoid the risk of electric
shock do not open or touch elements inside.
• To avoid electric shock, do not open the MSS and do not perform repairs by yourself. Service and
repairs should be performed only by qualiԛed specialists in an authorized service center. The list of
authorized service centers is available on www.sven.Н
• Do not allow the circuit of wires (including the grounded ones) between the speakers, on the
power ampliԛer or the ground, for it causes damage to the power ampliԛer output stage.
• Do not touch the MSS power cord plug pins for 2 seconds after unplugging it from the mains.
• Disconnect the MSS from the mains system during a fuse replacement. Use fuses of the same
type and rated value. Do not use hand-made fuses.
• Do not put foreign objects inside the holes of the MSS.
• Protect the MSS from high humidity, water and dust.
• Protect the MSS from heating: do not place it closer than 1 m from a heat source. Do not expose
it to direct sunlight.
• Do not place any open Ԝame sources on or close to MSS.
• Do not place the MSS in poorly ventilated areas. Leave an air gap of 10 cm or more. When
operating the MSS, do not put any devices on it, do not cover it with cloth or other objects preventing it from cooling.
• Do not use any chemical agents for cleaning. Clean it with dry soft cloth only.
4. TECHNICAL DESCRIPTION
MMS-1000 Multimedia Speaker System 2.1 (MSS) is designed to play music and sound games,
movies etc. MSS has built-in power ampliԛer, acoustic cables built into satellites and signal cable
due to which it can be connected to virtually any audio source (CD/DVD-player, TV, PC, etc.)
without using additional power ampliԛer.
Special features
• Speaker system is compatible with PCs, DVD/Media-players, mobile devices and other sound sources
• Control knobs on the subwoofer side panel
• Master volume control
• Separate subwoofer volume control and treble control
• Magnetic shielding
• MDF subwoofer cabinet
16
ENG
Operation Manual
Subwoofer side panel
a POWER: power switch
b BASS: subwoofer volume control
knob
c TREBLE: treble level control knob
d VOLUME: master volume control
knob
e Phase inverter
Subwoofer rear panel
f INPUT: audio source inputs
g OUTPUT: speaker outputs
h Power cord
5. PREPARATION AND OPERATION
Speaker placement
• Place speakers symmetrically to the
listener at the distance no less than
one meter. Subwoofer emits nondirectional sound, therefore it can
be located in any place of the room,
where it will sound to the best
advantage.
• Place MSS far away from monitors and TV sets, as insigniԛcant
image distortion in these supersensitive devices is possible.
f
MS-1000
a
VOLUME
TREBLE
BASS
bcd
Fig. 1. Subwoofer side panel
INPUT
R
L
e
g
OUTPUT
R
L
Fig. 2. Subwoofer rear panel
h
17
ENG
2.1 Multimedia Speaker System
MSS ǥonnecting and control
MS-1000 Multimedia Speaker System can be connected to virtually any audio source: DVD/CD, PC
sound card, etc. (see Fig. 3 below).
2RCA to 2RCA
signal cable
DVD
DŽDž
CD
DŽlayer
or
2RCA to mini-jack
signal cable
INPUT
L
OUTPUT
L
R
R
Power cord
Fig. 3. džonnection diagram
Note! Before connecting, make sure that the device is unplugged.
• Connect acoustic cables built into speakers into OUTPUT g of subwoofer rear panel (Fig. 2): left
speaker to white color output L, right speaker to red color output R.
• Insert RCA-jack of signal cable (included) into subwoofer INPUT f and opposite mini-jack of
signal cable connect into LINE OUT port of PC sound card or OUTPUT of ǀDŽ3/CD-player (see Fig. 3).
To connect MSS to DVD-player or TV use stereo signal cables 2RCA to 2RCA (not included).
• Insert plug of power cord h on the rear panel of subwoofer into the socket (see Fig. 2).
• Adjust master volume level to its minimum by turning VOLUME control knob d counterclockwise
until it stops.
• Shift POWER switch a (see Fig. 1).
• Switch on the audio source and adjust master volume level by turning VOLUME control knob d
on the side panel of subwoofer. While turning the knob clockwise, volume level increases, but while
turning it counterclockwise, it reduces.
18
ENG
Operation Manual
• Adjust subwoofer volume level and tremble control by turning BASS b and TREBLE c control
knobs accordingly. While turning the knob clockwise, volume level increases, but while turning it
counterclockwise, it reduces.
Notes:
• If speaker system has not been used for a long time, please mind to switch off POWER a
on subwoofer rear panel and pull out its plug h from the socket.
• To improve sound quality, use Line-Out output of sound card.
6. TROUBLESHOOTING
Problem
MSS does not
turn on.
No sound.
There is too quiet
sound of speakers.
Distortion of sound.
Sound is produced by
one of the channels
only.
Cause
MSS is not connected to the mains
outlet.
Power switch is oԚ.
Volume level is set at minimum value.
Improperly connected audio source.
Volume level is set at minimum value.
Large amplitude of the input signal.
Improperly connected speakers to
audio source.
MS-1000
Solution
Check the connection.
Turn on the switch.
Adjust volume control knob.
Connect audio sources correctly.
Adjust volume control knob.
Turn down source volume
and MSS volume.
Check the connection of speakers.
If none of the above mentioned solutions solves the problem, please refer to nearest authorized
service center for consultation by a qualiԛed specialist. Never try to repair the device on your own.
19
ENG
2.1 Multimedia Speaker System
7. TECHNICAL SPECIFICATIONS
Parameter, measurement unit
Output power (RMS), W
Frequency range, Hz:
subwoofer
satellites
Speaker diameter, mm:
subwoofer
satellites
Power supply, V/Hz
Dimensions (W × H × D), mm:
subwoofer
one satellite
Weight, kg
Notes:
• Technical speciНcations given in this table are supplemental information and cannot give
occasion to claims.
• Technical speciНcations are subject to change without notice due to improvement of SVEN
production.
Value
60 (30 + 2 × 15)
40 – 200
200 – 20 000
Ø 133
50 × 90 + Ø 20
~220/50
295 × 195 × 265
77 × 280 × 75
6.25
20
ǀǧǟǰǦǜǠǙǘǜǝǡǔdz
ǔǞǧǥǦǜǫǙǥǞǔdz ǥǜǥǦǙǠǔ 2.1
DžǦǔǕǜǟǜǛǔǦǢǤǡǔǣǤdzǚǙǡǜdzDžǦǔǕǜǟǜǛǔǦǢǤǡǔǣǤdzǚǙǡǜdz
2.0 Multimedia Speaker System
2.0 Multimedia Speaker System 2.0 Multimedia Speaker System
Manufacturer: SVEN PTE. LTD, 176 Joo Chiat Road,
д 02-02, Singapore, 427447. Produced under the
control of Oy Sven Scandinavia Ltd. 15, Kotolahdentie,
Kotka, Finland, 48310. Made in China.
® Registered Trademark of Oy SVEN
Scandinavia Ltd. Finland.
MS-1000
MS-1000
MS-1000
SPS-619
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.