Supersonic sc-504 Instruction Manual

INSTRUCTION MANUAL

PORTABLE CD/MP3/USB PLAYER WITH

STEREO RADIO

MANUAL DE INSTRUCCIONES

REPRODUCTOR DE CD PORTÁTIL CON

RADIO

SC-504

IMPORTANT: Please read before using and retain for future reference.

FAVOR DE LEER EL MANUAL COMPLETAMENTE ANTES DE OPERAR ESTE

PRODUCTO. CONSERVAR EL MANUAL PARA FUTURAS REFERENCIAS.

1

ENGLSIH

IMPORTANT NOTES

INTRODUCTION

 Thank you for buying this product.

 Please read through these operating instructions, so you will know how to operate your

equipment properly. After you finished reading the instructions manual, put it in a safe place

for future reference.

CAUTION

Use of controls or adjustment or performance of procedures other than those specified herein
may result in hazardous radiation exposure.

DANGER

This Compact disc player is classified as a Class 1
LASER PRODUCT.

THE CLASS 1 LASER PRODUCT label is located on the
rear exterior.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications.

 Avoid installing the unit in locations described below:

1. Places exposed to direct sunlight or close to heat radiating appliances such as electric

heaters, or other equipments that radiate too much heat.

2. Places subjected to constant vibration.

3. Unventilated or dusty places.

4. Humid or moist places.

 Operate buttons and switches as instructed in the manual.

 Before turning on the power for the first time, make sure that the power cord is properly

installed and the voltage switch is correctly set.

 Store your CD or other devices in a cool area to avoid damage from heat.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR

BACK). DO NOT OPEN THE UNIT ANY SERVICING PLEASE REFER TO

QUALIFIED SERVICE PERSONNEL.

WARNING:

- Remove batteries if exhausted or if they will not be used for a long period.

- The incorrect use of batteries can cause electrolyte leakage and will corrode the

compartment or cause the batteries to burst. Therefore:

- Do not mix battery types, e.g. alkaline with zinc carbonate.

- When inserting new batteries, replace all batteries at the same time.

2

LOCATION OF CONTROLS

3

NAMES OF CONTROLS

1. HANDLE

2. FUNCTION SWITCH

3. AUX JACK

4. VOLUME KNOB

5. X-BASS BUTTON

6. CD COMPARTMENT

7. BAND SELECTOR

8. DIAL SCALE

9. TUNING KNOB

10. CD DOOR OPEN/CLOSE

11. POWER INDICATOR

12. FM STEREO INDICATOR

13. CD SKIP/SEARCH BACKWARD BUTTON

14. CD STOP BUTTON

15. SPEAKERS

16. LCD DISPLAY

17. CD SKIP/SEARCH FORWARD
BUTTON

18. CD PLAY/PAUSE/USB BUTTON

19. FOLD-/-10 BUTTON

20. CD PROG./P-MODE BUTTON

21. FOLD+/+10 BUTTON

22. USB PORT

23. FM TELESCOPIC ANTENNA

24. BATTERY DOOR

25. AC SOCKET

26. AC VOLTAGE SELECTOR

(OPTIONAL)

POWER SOURCE

This unit is designed to be operated on AC/DC.

AC OPERATION

Plug the smaller end of AC power cord into AC jack on unit and the other bigger end into AC
wall outlet. The batteries will be automatically disconnected. For dual voltage version, make
sure that the AC voltage selector (located on the bottom of the unit) is switched to your local
voltage.(optional)

DC OPERATION

Open the BATTERY COMPARTMENT DOOR. Install 6 pcs UM-1/D size batteries (not included)
into compartment. Please follow correct polarities as indicated.

CAUTION

Remove batteries if they are flat or not being used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.

BASIC FUNCTION

SWITCHING ON THE UNIT

Set the FUNCTION switch to AUX/USB/CD/MP3 or RADIO.

TO ADJUST VOLUME

Rotate the VOLUME CONTROL back and forth to increase and decrease volume.

BASS BOOST SYSTEM

The BASS BOOST BUTTON controls the bass of the unit. Bass sound is the lower frequency
ranges of sound. The knob can be pushed to OFF or ON position, When the BASS BOOST is
on, the unit boosts (increases) the sound output of the bass frequencies.

4

USING THE RADIO

TUNING IN RADIO STATIONS

1. Move the FUNCTION switch to RADIO position, the POWER indicator will illuminate.

2. Slide the BAND switch to select the desired wave band: AM/FM ST.

3. Tune to required station by rotating the TUNING KNOB.

4. Rotate the VOLUME CONTROL to comfortable volume level.

5. Extend the TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting.
Gently rock the unit back and forth to get the best reception when you are listening to AM
program, or place the unit in an open place.
Note: The FM STEREO indicator will be on if you are receiving FM stereo program.

6. Turn off the radio by switching the FUNCTION switch to "OFF" position

USING THE CD/MP3
Discs for Playback

This system can playback all digital audio CD, MP3 finalized digital audio CD-Recordable
(CD-R) discs, finalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital
audio CD/CD-R/CD-RW discs.

LOADING A DISC

1. Set the FUNCTION switch to AUX/USB/CD/MP3 position.

2. Open the CD door.

3. Place an audio CD into the tray with the label side facing up.

4. Close the CD door.
The total number of tracks will appear on the display after several seconds.

5. To remove the CD, press to open CD compartment lid, grasp the CD by its edges, and
carefully take it out.

Note:

 To ensure good system performance; wait until the disc tray completely reads the disc

before proceeding.

 If no disc is loaded into the compartment, or the disc is placed upside down, the display will

show N0D.

PLAYING A DISC

1. Press the PLAY/PAUSE/USB button to start playback.
The playback starts from track 1, the “ ” indicator is shown on the display.
To interrupt playback, press the PLAY/PAUSE/USB button. The “ ” indicator will flash on
the display. To resume playback, press the PLAY/PAUSE/USB button again.

2. To stop playback, press the STOP button, the total number of tracks appears

on the display.

SELECTING A DESIRED TRACK/PASSAGE
To select a desired track

 Press the CD SKIP/SEARCH FORWARD/BACKWARD button repeatedly in stop mode or

during play until the desired track appears on the display.

 Press the PLAY/PAUSE/USB button to start play.

To search for a particular passage during playback
(track scanning at high speed)

Press and hold the CD SKIP/SEARCH FORWARD/BACKWARD button to scan the current
playing track at high speed until desired point passage, and then release the button.
Playback will start again from this point.