SUPERSONIC IQ 9000BT User Manual
COMPLIANCE WITH FCC
REGULATIONS
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1)this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment, In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits,Human proximity to the antenna shall not
be less than 20cm (8 inches) during normal operation.
PRECAUTIONS BEFORE USE
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS
VOLTAGE AND UNTIL ALL OTHER CONNECTIONS HAVE BEEN MADE.
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF
SEVERAL INCHES AROUND THE UNIT FOR VENTILATION.
IMPORTANT NOTES
Stop operation immediately if any liquid or solid object should fall into the
cabinet
If the unit is not to be used for a long period of time, make sure that all
power sources are disconnected from the unit. And unplug the AC-DC
adaptor from the wall outlet. Make it a practice to remove the AC-DC
adaptor by grasping the plug and not by pulling the cord.
Places exposed to direct sunlight or close to heat radiating appliances such
as electric heaters.
Places subject to constant vibration.
Dusty, humid or moist places.
Unplug the unit from the electrical power outlet immediately in case of malfunction.
WARNING: TO AVOID THE DANGER OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. NEVER OPEN THE CABINET, AS
DANGEROUS HIGH VOLTAGES ARE CONTAINED INSIDE. ONLY A QUALIFIED
SERVICE TECHNICIAN SHOULD ATTEMPT TO OPEN THE CABINET.
CAUTION:
This equipment generates, uses and can radiate radio frequency energy, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communication. However, this is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures;
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Loading...