Superior ETK42-P, ETK36-P, ETK42-B, ETK36-B User Manual
WOOD BURNING APPLIANCE
KITS AND ACCESSORIES
INSTALLATION INSTRUCTIONS FOR EDGE TRIM KITS
FOR USE WITH SUPERIOR'S WOOD BURNING APPLIANCES
SHIPPING AND PACKING LIST
Edge Trim Kit must include:
1 - RH Side Trim
1 - LH Side Trim
1 - Top Frame Trim
1 - Lower Mounting Frame Trim*
2 - Upper Mounting Frame Trim*
*Note: Upper and lower mounting frame trim included with
Models 42 only.
The Edge Trim Kits covered in this document are:
Catalog # Model #
91L57 ETK36-B
91L58 ETK36-P
91L61 ETK42-B
91L62 ETK42-P
750,058M
11/2000
Step 5. 42 Models only. Install the lower mounting frame trim.
Align the two holes of the trim to the two holes of the fireplace.
Step 6. 42 Models only. Align the two end holes of the second
upper mounting frame with the holes on the lower fireplace frame
and secure with two screws.
Step 7. Adjust all trim pieces and ensure that all screws have been
tightened. Reinstall louvers.
Step 8. Remove protective covering from trim pieces and wipe with a
damp cloth.
Step 9. Reinstall louvers.
EDGE TRIM KITS
FIREPLACE EDGE TRIM KIT INSTALLATION INSTRUCTIONS
Step 1. Remove fireplace grille assemblies by lifting up and out of holes
on frame. Then pull from bottom out towards you. (
Note: Lift grille near outer support rods to fully clear holes.
Step 2. There is a right hand and a left hand trim. Install side trims
carefully. Place trim on side frame and press firmly to fit around
frame (
Figure 1
).
Step 3. Install the top frame trim with two screws as shown in
Figure 2
.
Note: The ends should overlap the side trim pieces a little.
Step 4. 42 Models only. Install one of the two upper mounting
frame trim pieces by aligning the three holes of the trim to the three
holes of the fireplace. Fasten with three screws.
Figures 1 and 2
).
Figure 1
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 2
Top Trim
Step 3
Step 2
Screws
Side Trim
Step 3
Step 4
Step 5
Figure 3
Side Trim
Step 2
Press The Sides
To Tighten If The
Fit Is Loose
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
FireCraft Technologies reserves the right to make changes at any time, without notice,
in design, materials, specifications, prices and also to discontinue colors, styles and
products. Consult your local distributor for fireplace code information.
Printed in U.S.A. © 2000 by FCT
P/N 750,058M REV. B 11/2000
4325 Artesia Avenue • Fullerton, CA 92833-2522
714-521-7302
Loading...