Supera SMX30-1 Operators Manual
SMX10-1, SMX20-1, SMX20-2, SMX30-1
MIXERS
INSTRUCTION MANUAL
This manual contains important information regarding your Supera® unit. Please read this manual thoroughly prior to equipment set-up, operation and maintenance. Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty.
DESCRIPTION
This is a type of changing speed gear mixer, with its planetary stirring design. It has
a compact structure, is highly efficient and power saving, and is easy to operate. It
will be provided to you as an ideal assistant for bread and cake making.
TECHNICAL PARAMETERS
MAIN EXTERNAL PARTS MIXER
1. Gear change hand lever
2. Stirring shaft
3. Mixer
4. Stainless barrel
5. Power switch
6. Bent lever
7. Safety guard (may choose the fitting)
8. Support
MANUAL
INSTRUCTION
©SUPERA
V.1.0 | October 2014
INSTA
LLATION
Ensure the location of the Planetary Mixer is capable of supporting it
s weight.
WARNING: The Planetary Mixer is very heavy, care must be taken when moving it.
ASSEMBLY
WARNING: The bowl must be attached and raised into position
prior to st
the Planetary Mixer.
We accept no responsibility for any injury caused by
incorrect assembly of this appliance.
Note: Ensure the feet are level to reduce vibration during operation.
Remove the appliance from all packaging.
Fitting/Removing the Bowl
Turn Off the appliance.
1.
Open the safety guard by turning it to the
2.
left (SMX10-1, SMX20-1, & SMX20-2) or
lifting
Lower the bowl with the bowl handle.
3.
Release the locking catches either side of
4.
it above the mixer (SMX30-1).
the
bowl.
Lift the bowl. The bowl is held in place by two
5.
pins securing the handles to the cradle and a
hole at the back of the appliance which houses
the lug on the bowl lip.
Reverse the procedure to fit the bowl.
6.
arting
MANUAL
INSTRUCTION
Note: Ensure the handle is fully pushed back
and the bowl is completely raised or the
mixer will not work.
Note: Regularly grease the bowl lift mechanism to ensure
Changing the Mixer Attachment
Turn Off the appliance.
1.
en the safety guard by turning it to the left (SMX10-1, SMX20-1, & SMX20-2) or lifting it
Op
2.
above the mixer (SMX30-1).
Lower the bowl with the bowl handle.
3.
Push the mixer attachment up and to the left to release it.
4.
Insert the desired attachment. Push
5.
6.
©SUPERA
Raise th
e bowl.
smooth operation.
up and to the right to lock it into place.
V.1.0 | October 2014
OPERATION INSTRUCTION
*CAUTION: The unit will not run if the safety guard is not closed completely!
1. Plug the unit into the proper outlet ensuring it has the correct voltage and amps.
2. Set your unit to desired speed.
3. Install desired attachment. (Beater, Dough Hook, or Wire Whip)
4. Install bowl and check to make sure it is secure and in the proper position.
5. Raise the hand lever so that it in the highest position.
6. Once the hand lever is raised, close the Safety Guard completely. If the Safety
Guard is not closed the mixer will not function.
7. Make sure the safety guard lock is on before turning on the unit
8. To turn the unit on, press the GREEN power button.
9. To turn the unit off, press the RED power button.
To change the desired speed, press the RED power button to turn the unit
off. Move the hand lever into the lowest position. Select new desired speed.
Raise hand lever back into highest position. Press GREEN power button to
turn the unit back on.
ACCESSORIES AND FUNCTIONS
We recommend the following uses
Whisk: Light mixes, whipped cream, mayonnaise, egg whites,
1.
pancakes and souffles.
Beater: Firm mixes, light pastry, cake/biscuit mix, icings, fillings, and
2.
mashed vegetables. Recommended Speed: 1, 2, Medium
3. Spiral Dough Hook: Heavy mixes, dough, pie pastry, etc.
Recommended Speed: 1, Slow
NOTES
The power socket must be connected to a ground wire to guarantee optimal
1.
operation. There is a strong risk of malfunction or shock if the mixer is not
grounded. The ground wire can never be connected to a gas pipe, water pipe,
lightning rod, or telephone line.
electric leakage. If the power line is ever damaged, please consult a
professional electrician.
2. Don’t put your hand into the stirring barrel during operation. Power supply
should be disconnected before the mixer is going to be installed.
3. Don’t operate the mixer beyond the time limit. Doing so will reduce the life
of the
4. The mixer should be mounted on a stable and clean place. Keep it away from
overheated or over-wet places and away from equipment which has strong
electromagnet
unit.
ic pull or can produce a strong electromagnetic pull.
Recommended Speed: 1, 2, 3, Fast
for each attachment:
After installation, have an electrician check for
MANUAL
INSTRUCTION
©SUPERA
V.1.0 | October 2014
5. Keep the machine clean constantly. Disconnect power supply before
maintenance. Clean it with a piece of soft and damp cloth. Don’t clean it with
liquid or spraying detergent.
Overload Switch
The Overload sw
ack of the machine b
b
entry. If the appliance becomes too
itch is situated at the
de the cable
esi
Overload
switch
hot the Overload switch will stop the
machine automatically. If this
happens:
Turn Off the mixer.
1.
ce the load in the mixing bowl.
Redu
2.
Push the Overload switch back in to reset
3.
Allow the appliance to cool for 20 minutes.
4.
Note: In the
ut in to prevent the appliance from restarting
c
event of a power cut the Overload switch will
it.
automatically when power is restored.
Note: Always disconnect the Planetary Mixer from the mains
powers supply when not
in use.
MAINTENANCE
•
Always turn off the
se warm soapy wa
• U
mixer and disconnect from the power supply before cleaning.
ter to clean the bowl
and mixing
attachments. Do not use abrasive
cleaning chemicals as these can leave behind harmful residues.
• Clean the exterior of the appliance with a damp cloth.
• Dry all parts thoroughly after cleaning.
• Do not us
• Clean t
e jet/pressure washers to clean the appliance.
he appliance regularly.
MANUAL
INSTRUCTION
The transmission gear box is greased in a factory, for best practice we recommend
checking the grease every 6 months. To add or refill grease, open the top cover,
then fill grease from aperture or replace the grease directly.
©SUPERA
V.1.0 | October 2014
TROUBLESHOOTING
Fault
The appliance is not
orking
w
Bowl will not fit back in to
place
The appliance is
overheating
Probable Cause Action
he unit
T
Plug and lead are damaged
Fuse i
Power supply Check power supply
The overload switch has activated
Safety Guard not closed Close Safety Guard fully
Appliance not in gear Put in gear
Bowl not fully raised
Bowl pins or surrounding area clogged
with mix
The mixing
The appliance has b
long
is not switched on
eased (HLM30)
l
n the plug has blown
bowl is overloaded
een operating for too
Check the unit is plugged in
correctly and switched on
Turn button clockwise to releaseThe Stop button not re
Call agent or qualified
Tec
hnician
Replace the fuse
See overload s
the Operation section of this manual
Ensure the Bowl lever is
back fully
Clean the appliance
Turn off the appliance and empty
some of the contents
Turn off the appliance and allow to
cool down for
witch informati
30 minutes
on in
pushed
MANUAL
INSTRUCTION
The appliance is noisy
The mixing a
fails
to rotate properly
Cannot select gear Gearing cogs misaligned
ttachment
Bowl or mixing attachment not
correctly fitted
rn bearings/damaged gears
Wo
The belt has become loose Call agent or qualified
Remove an
attachment
ll agent or qualified
Ca
Technician
Tech
T
urn Off applia
the whisk attachment slightly. Select
the gear again.
d refit bowl/mixing
nician
nce and manually turn
WARNING!
If the equipment is out of function, please have it serviced by a professional.
©SUPERA
V.1.0 | October 2014
Loading...