Supera SMX10-1, SMX20-1, SMX20-2, SMX30-1 Instruction Manual

SMX10-1, SMX20-1, SMX20-2, SMX30-1

MIXERS

INSTRUCTION MANUAL

This manual contains important information regarding your Supera® unit. Please read this manual thoroughly prior to equipment set-up, operation and mainte­nance. Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty.

DESCRIPTION

This is a type of changing speed gear mixer, with its planetary stirring design. It has
a compact structure, is highly efficient and power saving, and is easy to operate. It
will be provided to you as an ideal assistant for bread and cake making.

TECHNICAL PARAMETERS

MAIN EXTERNAL PARTS MIXER

1. Gear change hand lever

2. Stirring shaft

3. Mixer

4. Stainless barrel

5. Power switch

6. Bent lever

7. Safety guard (may choose the fitting)

8. Support

MANUAL

INSTRUCTION

©SUPERA

V.1.0 | October 2014

INSTA

LLATION

Ensure the location of the Planetary Mixer is capable of supporting it

s weight.

WARNING: The Planetary Mixer is very heavy, care must be taken when moving it.

ASSEMBLY

WARNING: The bowl must be attached and raised into position

prior to st

the Planetary Mixer.
We accept no responsibility for any injury caused by

incorrect assembly of this appliance.

Note: Ensure the feet are level to reduce vibration during operation.

Remove the appliance from all packaging.

Fitting/Removing the Bowl

Turn Off the appliance.

1.
Open the safety guard by turning it to the

2.
left (SMX10-1, SMX20-1, & SMX20-2) or
lifting
Lower the bowl with the bowl handle.

3.
Release the locking catches either side of

4.

it above the mixer (SMX30-1).

the
bowl.
Lift the bowl. The bowl is held in place by two

5.
pins securing the handles to the cradle and a
hole at the back of the appliance which houses
the lug on the bowl lip.

Reverse the procedure to fit the bowl.

6.

arting

MANUAL

INSTRUCTION

Note: Ensure the handle is fully pushed back
and the bowl is completely raised or the
mixer will not work.

Note: Regularly grease the bowl lift mechanism to ensure

Changing the Mixer Attachment

Turn Off the appliance.

1.
en the safety guard by turning it to the left (SMX10-1, SMX20-1, & SMX20-2) or lifting it

Op

2.

above the mixer (SMX30-1).
Lower the bowl with the bowl handle.

3.

Push the mixer attachment up and to the left to release it.

4.

Insert the desired attachment. Push

5.

Raise th

6.

©SUPERA

e bowl.

smooth operation.

up and to the right to lock it into place.

V.1.0 | October 2014

OPERATION INSTRUCTION

Standard power supply v/ HzAc. Plug in the unit into the proper outlet.

1.

Set your unit to desired speed.

2.

Install desired attachment. (Beater, Dough Hook, or Wire Whip)

3.

Place bowl in proper place and check to make sure it is secure.

4.

Raise the hand lever so that it in the highest position.

5.

Once the hand lever is raised, close the Safety Guard completely. If Safety Guard

6.
is not closed the mixer will not function.

To turn the unit on, press the GREEN power button.

7.
To turn the unit off, press the RED power button.

8.

To change the desired speed, press the RED power button to turn the unit
off. Move the hand lever into the lowest position. Select new desired speed.
Raise hand lever back into highest position. Press GREEN power button to
turn the unit back on.

ACCESSORIES AND FUNCTIONS

We recommend t

Whisk: Light mixes, whipped cream, mayonnaise, egg whites,

1.

he following uses for each attachment:

pancakes and souffles. Recommended Speed: 1, 2, 3, Fast

Beater: Firm mixes, light pastry, cake/biscuit mix, icings, fillings, and

2.
mashed vegetables. Recommended Speed: 1, 2, Medium

3. Spiral Dough Hook: Heavy mixes, dough, pie pastry, etc.
Recommended Speed: 1, Slow

NOTES

The power socket must be connected to a ground wire to guarantee optimal

1.

operation. There is a strong risk of malfunction or shock if the mixer is not
grounded. The ground wire can never be connected to a gas pipe, water pipe,
lightning rod, or telephone line. After installation, have an electrician check for
electric leakage. If the power line is ever damaged, please consult a
professional electrician.

2. Don’t put your hand into the stirring barrel during operation. Power supply
should be disconnected before the mixer is going to be installed.

3. Don’t operate the mixer beyond the time limit. Doing so will reduce the life
of the unit.

4. The mixer should be mounted on a stable and clean place. Keep it away from
overheated or over-wet places and away from equipment which has strong
electromagnetic pull or can produce a strong electromagnetic pull.

MANUAL

INSTRUCTION

©SUPERA

V.1.0 | October 2014

5. Keep the machine clean constantly. Disconnect power supply before
maintenance. Clean it with a piece of soft and damp cloth. Don’t clean it with
liquid or spraying detergent.

Overload Switch
The Overload sw

ack of the machine b

b
entry. If the appliance becomes too

itch is situated at the

eside the cable

Over

switch

load

hot the Overload switch will stop the
machine automatically. If this
happens:

Turn Off the mixer.

1.
uce the load in the mixing bowl.

Red

2.

Push the Overload switch back in to reset

3.

Allow the appliance to cool for 20 minutes.

4.

Note: In

the event of a power cut the Overload switch

it.

cut in to prevent the appliance from restarting
automatically when power is restored.

Note: Always disconnect the Planetary Mixer from the mains
pow

ers supply when not in use.

MAINTENANCE

•

• U

ys turn off the mixer and disconnect from the power supply before cleaning.

Alwa

se warm soapy wa

ter to clean the bowl

and mixing attachments. Do not use abrasive

cleaning chemicals as these can leave behind harmful residues.

• Clean the exterior of the appliance with a damp cloth.

• Dry all parts thoroughly after cleaning.

• Do not u

• Clean

se jet/pressure washers to clean the appliance.

the appliance regularly.

will

MANUAL

INSTRUCTION

The transmission gear box is greased in a factory, for best practice we recommend
checking the grease every 6 months. To add or refill grease, open the top cover,
then fill grease from aperture or replace the grease directly.

©SUPERA

V.1.0 | October 2014

TROUBLESHOOTING

Fault

The appliance is not

orking

w

Bowl will not fit back in to
place

The appliance is
overheating

Probable Cause Action

he unit

T

Plug and lead are damaged

Fuse i

Power supply Check power supply

The overload switch has activated

Safety Guard not closed Close Safety Guard fully

Appliance not in gear Put in gear

Bowl not fully raised

Bowl pins or surrounding area clogged
with mix

The mixing

The appliance has b
long

is not switched on

eased (HLM30)

l

n the plug has blown

bowl is overloaded

een operating for too

Check the unit is plugged in
correctly and switched on

Turn button clockwise to releaseThe Stop button not re

Call agent or qualified
Tec

hnician

Replace the fuse

See overload s
the Operation section of this manual

Ensure the Bowl lever is
back fully

Clean the appliance

Turn off the appliance and empty
some of the contents

Turn off the appliance and allow to
cool down for

witch informati

30 minutes

on in

pushed

MANUAL

INSTRUCTION

The appliance is noisy

The mixing a

fails

to rotate properly

Cannot select gear Gearing cogs misaligned

ttachment

Bowl or mixing attachment not
correctly fitted

rn bearings/damaged gears

Wo

The belt has become loose Call agent or qualified

Remove an
attachment

ll agent or qualified

Ca
Technician

Tech

T

urn Off applia
the whisk attachment slightly. Select
the gear again.

d refit bowl/mixing

nician

nce and manually turn

WARNING!

If the equipment is out of function, please have it serviced by a professional.

©SUPERA

V.1.0 | October 2014