Sunrise Medical IC-6418 User Manual

Guardian®Tilt Automatic Overbed Table

User Instructions

Model IC-6418

POSSIBLE DAMAGE OR INJURY. Be alert of hi/lo adjustment of overbed table
when raising bed.

ASSEMBLY INSTRUCTIONS (FIGURE 1)

1. Using the hex bolts and washers, attach the base to the post. Tighten the bolts
securely.

2. Insert the tilt control bar into the post by loosening post screw. Tighten post
screw, once tilt control bar has been inserted into post.

3. Attach the outer tube to the top board using the screws.

4. Slide the outer tube onto the tilt control bar. If it is too tight, release the
rotating knob on the tilt control bar.

5. Tighten the rotating knob to set the top board.

6. Insert the casters into the base until they lock into place.

Tilt Control Bar

Rotating Knob

Post Screw

Hex Bolts

Casters

Outer Tube

Screws

Washers

Base

Top Board

Figure 1

©2002 Sunrise Medical 7.02

IM-429008 Rev. A

OPERATING INSTRUCTIONS (FIGURE 2)

1. Remove fix screw located on the table post to release the inner tube and outer
tube of the post.

CAUTION– Stabilize the top board as you remove the fix screw so that top board will

not bounce back too quickly.

2. To raise the top board, place your hand underneath the top board and move it
upward to the desired height. Remove pressure to set height.

3. To lower the top board, lift the adjustable plate and push top board downward
to the desired height. To set the height, release the adjustable plate.

4. To rotate the top board, twist the knob of the tilt control bar to loosen. Rotate
the top to the desired position. Tighten the knob to set the position.

Manufactured for:

Sunrise Medical, Inc.

7477 East Dry Creek Parkway
Longmont, Colorado 80503

www.sunrisemedical.com
Phone: [phone]
Toll Free Phone: [phone]
In Canada: [phone]

Printed in Taiwan

Adjustable Plate

Table Post

Rotating Knob

Figure 2