Sunbeam WW4300 User Manual
Please read these instructions carefully
and retain for future reference.
Wok
5.0 Litre Non-Stick Wok
Instruction/Recipe Booklet
WW4300
Sunbeam’s Safety Precautions 1
Features of your Wok 2
Using your Wok 6
Cooking Techniques 7
Care and Cleaning of your Wok 9
Recipes
Entrees & Appetisers 10
Main Meals 11
Stir Fries 13
Side Dishes 16
Desserts 17
Contents
1
Sunbeam are very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• Close supervision is necessary when your
appliance is being used near children or
infirm persons.
• Never leave an appliance unattended while
in use.
• Young children should be supervised to ensure
that they do not play with the appliance.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• For safety reasons and to avoid maintenance
by unskilled persons, some appliances are
‘sealed’ using tamperproof screws. Such
appliances should always be returned to the
nearest Sunbeam Appointed Service Centre
for adjustment or repair if required.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
dropped or damaged in any manner. If damage
is suspected, return the appliance to the
nearest Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM WOK.
• Use well away from walls and curtains.
• Avoid using on metal surfaces e.g. sink,
hotplate.
• Do not touch cooking vessel whilst hot, use
cool touch handles.
• If using a plastic spatula do not leave in
cooking vessel when hot.
• Do not immerse removable probe in water.
Glass lid with adjustable steam vent
Allows you to view your food while
cooking, and controls moisture levels.
DuPont ® Teflon Platinum with
ScratchGuard™ Non-stick Coating
Safe to use with metal utensils.
Up to 10 times more scratchresistant than other non-stick
coatings. See page 4.
2000 watt ‘butterfly-shaped’ element
The element is butterfly-shaped and
is embedded into the heavy duty
base for better heat distribution and
faster heating.
Detachable Base
Allows for easy cleaning.
Simply un-twist and pull.
Non-slip rubber feet
Provides extra stability and prevents
slipping.
Steaming Rack
2
Features of your Wok
3
Cool Touch Handles
Makes handling your wok safe when cooking.
Dishwasher safe parts
The wok vessel, base and glass lid are
dishwasher safe.
Heavy Duty Die-Cast Cooking Vessel
Trigger-release Heat Control Probe
with 10 heat settings
The removable probe is thermostatically
controlled to provide accurate cooking
temperatures. The trigger-release makes the
probe easy to remove.
DuPont Teflon® - Platinum with ScratchGuard™
Non-Stick Coating
Your Sunbeam wok features DuPont’s
toughest non-stick coating produced to date Platinum with ScratchGuard.
DuPont is the world leader in non-stick
coatings with the introduction of Teflon
dating back to 1938. Today more than 2
billion households have Teflon non-stick
coated cookware.
Teflon Platinum is a premium 3 layer nonstick coating. It features special scratch
resistant minerals causing metal utensils to
slide over these particles without damaging
the Teflon matrix.
This preserves the release properties of the
non-stick coating during the life of the wok.
The end result is a non-stick coating that can
be treated like ordinary cookware, enabling
the use of metal utensils such as spatulas
and spoons, but not sharp utensils.
So tough is the new
Teflon Platinum
coating that it is up to
10 times more scratch
resistant than other
non-stick coatings*.
The image show here
is an example of the
performance of Teflon
Platinum against an
'other' non-stick
coating. Each surface
has undergone 5
cycles of the DuPont
In-House Abuse Test.
The Teflon Platinum only has some surface
scuffing, whereas the 'other' non-stick
coating has deteriorate badly.
* The images shown here and performance
claims are based upon the DuPont InHouse Cooking Abuse Test used to evaluate
scratch resistance and release properties of
non-stick coatings.
4
Features of your Wok
Platinum with ScratchGuard – 3 layer scratch
resistant coating
Results from DuPont’s ‘In-house Cooking
Abuse Test’
SUNBEAM OTHER BRANDS
Superior
nonstick top surface
Reinforced intermediate coat
Primer + scratch
resistant minerals
Wok base
5
2000 Watt ‘Butterfly-Shaped’ Element
Your Sunbeam Wok features a special 2000
Watt 'butterfly-shaped' element. This element
shape and design provides more effective
heat distribution at the base of the wok when
compared to normal ‘round-shaped’elements.
The element is also embedded into the heavy
duty base for faster heating of your work.
Trigger-Release Control Probe with 10 heat
settings
The Heat Control Probe is thermostatically
controlled with 10 settings to deliver perfect
cooking control.
The indicator light switches 'on' when it is
heating. When the wok has reached the
desired temperature the indicator light
switches 'off'. The indicator light will then
cycle 'on' and 'off' as the thermostat
maintains the set temperature.
The Heat Control Probe is ergonomically
designed with a handy Trigger-Release.
Simply hold the probe and squeeze the
trigger with your thumb to remove it.
Detachable Cook & Clean Base
Your Sunbeam Wok features a quick
detachable 'Cook & Clean' base. This enables
the base to be removed from the wok cooking
vessel making easier cleaning.
Simply turn the wok upside down and untwist the plastic knob anti-clockwise as
shown in the illustration below.
Features of your Wok continued
Completely cast-in element
Heat control probe with trigger release
Quick-release cook and clean base
6
Before the First Use.
Ensure any stickers are removed from the
product. Wash in warm soapy water, rinse
thoroughly and dry your Wok and lid.
Do not immerse the Heat Control Probe in water
or any other liquid.
Season the cooking surface by applying a
thin coat of cooking oil and wiping over with
paper towelling. Re-seasoning is
recommended every few months.
1.Insert the Heat Control Probe into the
socket of the Wok.
2.Plug the cord into a 230-240V power
outlet and turn the power on.
3.Set the Heat Control Probe dial to the
desired temperature setting, or the
recommended temperature setting for your
required recipe.
Allow 5 minutes for your wok to reach the
temperature setting you have selected. The
Wok is now ready to use.
Note: The thermostat light on the Heat
Control Probe indicates the temperature at
which the dial is set.
This light will remain on until the set
temperature has been reached and then will
cycle on and off throughout cooking. This will
ensure that the Wok maintains the correct
temperature.
Using your Wok
Loading...