Sunbeam 2600, SR2600 User Manual

Ultura 2600 Platinum

Dry Iron

Instruction Booklet

SR2600

Please read these instructions carefully
and retain for future reference.

Contents

Contents

Sunbeam’s Safety Precautions 1

Features of your Ultura Dry Iron 2

Using your Ultura Dry Iron 3

Care and Cleaning 3

Ironing Guide 4

Important instructions – retain for
future use.

Sunbeam’s Safety Precautions

Sunbeam’s Safety Precautions

SAFETY PRECAUTIONS FOR YOUR IRON.

• Do not leave a hot iron within reach of children.
If they come into contact with a hot iron it
could lead to serious burns.

• Iron only on an ironing board.

• An iron takes approximately 30 minutes to
cool down. Allow the iron to cool completely
before storing.

• Do not wind the cord around the
soleplate while the iron is still hot.

Sunbeam is very safety conscious when designing

and manufacturing consumer products, but it is
essential that the product user also exercise care
when using an electrical appliance. Listed below are
precautions which are essential for the safe use of
an electrical appliance:

• Read carefully and save all the instructions
provided with an appliance.

• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.

• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.

• Do not use your appliance with an extension cord
unless this cord has been checked and tested by
a qualified technician or service person.

• Always use your appliance from a power outlet of
the voltage (A.C. only) marked on the appliance.

• This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.

• Children should be supervised to ensure that they
do not play with the appliance.

• The temperature of accessible surfaces may be
high when the appliance is operating.

• Never leave an appliance unattended while
in use.

• Do not leave the iron unattended while it is
plugged into the power outlet.

• The iron must be used and rested on a stable
surface.

• When placing the iron on its stand, ensure that
the surface on which the stand is placed is
stable.

• The iron is not to be used if it has been
dropped, if there are visible signs of damage or
if it is leaking.

• Do not use an appliance for any purpose other
than its intended use.

• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.

• Do not place on top of any other appliance.

• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch any
hot surface.

• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
damaged in any manner. If damage is suspected,
return the appliance to the nearest Sunbeam
Appointed Service Centre for examination, repair
or adjustment.

• For additional protection, Sunbeam recommend
the use of a residual current device (RCD)
with a tripping current not exceeding 30mA in
the electrical circuit supplying power to your
appliances.

• Do not immerse the appliance in water or any
other liquid unless recommended.

• Appliances are not intended to be operated by
means of an external timer or separate remote
control system.

• This appliance is intended to be used in
household and similar applications such as: staff
kitchen areas in shops, offices and other working
environments; farm houses; by clients in hotels,
motels and other residential type environments;
bed and breakfast type environments.

If you have any concerns regarding the performance and use of your appliance,

please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.

Ensure the above safety precautions are understood.

1

1