www.sunbeam.com.au1300 881 861 Units 5 & 6, 13 Lord Street, Botany NSW 2019 Australia
New Zealand
www.sunbeam.co.nz 0800 786 232 Level 6, Building 5, Central Park, 660-670 Great South Road, Greenlane, Auckland New Zealand
Contents
Sunbeam’s Safety Precautions
Sunbeam’s Safety Precautions 1
Get To Know Your Air Purifier 2
Control Panel & Features 3
Product Specifications 4
Getting Started 4
Operating Instructions 4
Care And Maintenance 4
How To Replace The Hepa Filter 5
Troubleshooting 5
When using electrical appliances, basic safety
precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons.
These precautions include:
• Read all instructions before using the appliance.
• To avoid fire or shock hazard, plug the appliance
directly into appropriate electrical outlet.
• If the filter is covered by a bag when shipped,
remove plastic bag before use and keep away
from children.
• Keep the cord out of heavy traffic areas. To avoid
fire hazard, never put the cord under rugs, near
heat registers, radiators, stoves, or heaters.
• To protect against electrical hazards, do not
immerse the appliance or use near water or other
liquids.
• This appliance is not intended for use by children
or by persons with reduced physical, sensory,
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of
the appliance by a person responsible for their
safety. Close supervision is necessary when any
appliance is used near children. Children should
be supervised to ensure that they do not play with
the appliance. Keep the appliance and its cord
out of reach of children.
• Always turn the appliance off before unplugging
it.
• Always unplug the air purifier before moving or
cleaning the unit, opening the filter chamber
cover, changing the filters and whenever the unit
is not in use. To disconnect the unit, be sure to
pull the plug and not the cord.
• Never drop or insert any objects into the openings
If you have any concerns regarding the performance and use of your appliance,
please visit the Sunbeam website or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
of the unit.
• Do not operate any appliance with a damaged
cord or plug. If the motor fan fails to operate or
the unit has been dropped or damaged in any
manner, return appliance to manufacturer for
examination and/or repair.
• Use appliance only for intended household use
as described in this manual. Any other use not
recommended by the manufacturer may cause
fire, electric shock, or injury to persons.
• Do not use outdoors.
• Never place on a soft surface such as a bed or
sofa as this could cause the unit to tip over and
block the air inlet or outlet grilles.
• Keep unit away from heated surfaces and open
flames.
• Do not place anything on top of unit.
• Never use detergents, gasoline, glass cleaner,
furniture polish, paint thinner or other household
solvents to clean any part of the appliance.
• This appliance should only be used in a room
with temperatures between 10° C and 40° C.
• WARNING: To reduce the risk of fire or electric
shock, do not use this appliance with any solidstate speed control device.
• CAUTION: To prevent risk of electric shock,
remove cord plug from outlet before opening
appliance. To prevent risk of fire, inspect and
clean equipment regularly as noted in this
manual.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
1
Get To Know Your Air Purifier
1
2
Control Panel & Features
3
4
5
6
BOTTOM VIEW
1. Top Air Vent
2. Control Panel
3.
Nightlight
4. 360
Air Intake
5. True HEPA Filter Chamber Cover
6. Chamber Cover OPEN/CLOSE Button
On/Off Button
A dual function button, turns unit on or off
and selects Fan Speed Settings.
IIIIII
Fan speed settings
• For optimum air filtration, it is
recommended to operate the air purifier
continuously on speed II (Medium). Its
durable motor has been designed to give
many years of use.
• For quieter operation (such as in a
bedroom), select speed I (Low).
• When high levels of air pollution are
present, select speed III (High) to quickly
circulate and filter the air in the room.
Timer
For your convenience, you can set the air
filtration time for 2, 4, or 8 hours. Once it
reaches set time, the unit will automatically
turn off. If you want to cancel the set time,
simply press this button to cycle through
until the light goes off.
Nightlight
The (
feature is activated.
Filter Replacement Indicator
The (
replace the filter.
)illuminates when the nightlight
) starts blinking when it is time to
32
Product Specifications
How To Replace The Hepa Filter
CADR
Fan Speeds
Smoke: 153 m3/hr
3
Noise Level on High Speed
Power Consumption
Getting Started
1. Gently place the air purifier on its side to
expose the filter chamber cover.
2. Open the cover following the instructions
in How to Replace the HEPA Filter on
page 5. Pull the filter out of the air
purifier and remove the plastic bag.
3. Insert the filter back into the unit and
close the cover.
4. Your unit is equipped with a True HEPA
filter that will last for approximately 12
months.
Operating Instructions
1. Place the unit on a dry, stable and firm
surface. Make sure not to block the top air
vent and air intake grille.
2. Plug unit into appropriate electrical outlet.
3. Select desired fan speed setting: III (Hi), II
(Medium) and I (Low) by pressing the ON/
OFF (
speeds until it reaches desired speed setting.
) button to cycle through the
4. Note: For optimum air filtration, it is
recommended to operate the unit
continuously on speed II (Medium). Its
heavy-duty motor was designed to provide
many years of use.
5. Important: Always turn off and unplug the
unit when not in use.
Care And Maintenance
Before cleaning the air purifier, turn off and
unplug.
Clean the exterior surface with a clean, damp
cloth.
The top air vent can be cleaned of dust with
a small, soft brush.
If you would like to clean the inside of the
filter compartment, ONLY use a dry, soft
cloth to wipe it down.
WARNING: Do not allow moisture to come into
contact with the main housing of the air
purifier.
NEVER use detergents, gasoline, glass
cleaner, furniture polish, paint thinner, or
other household solvents to clean any part of
the appliance.
55dB(A) max
38W
It is recommended to replace the True HEPA filter every 8-12 months.
1. The Filter Replacement Indicator light (
Turn off and unplug air purifier. Replace the HEPA filter with a new one.
2. To replace:
Gently place the
air purier on its
side to expose
the lter
chamber cover.
Push the Button
toward arrow
direction to
unlock and open
the cover.
3. Close and lock the cover. Place the air purifier on a flat surface.
4. Plug the unit into an electrical outlet. Reset the Filter Replacement Indicator by pressing and
holding the On/Off (
a beep and the light goes off.
*Replacement filters (SAPF0900) can be purchased through local service centres.
) and Timer (
) starts blinking when it is time to replace the filter.
Pull the used
HEPA lter
out and insert
a new one.
2H 4H
8
H I II III
) buttons simultaneously for 3 seconds until you hear
2H 4
H
8H I II III
Troubleshooting
ProblemSolution
Why is my unit not working?
Why is there a decrease in air flow?
Why is the unit making a loud noise?
Check if unit is properly plugged in and outlet is
working.
Make sure unit is turned ON.
Make sure the filter is properly installed.
Make sure nothing is blocking air intake grille and
filtered air outlet.
Check condition of the filters and replace if
necessary.
Check filter to remove any plastic wrapping/
packaging.
Make sure the unit is firmly positioned in place.
Open filter chamber cover and verify that any plastic
packaging was removed from the filter.
4
5
Need help with your appliance?
Contact our customer service team or visit our
website for information and tips on getting the
most from your appliance.
Australia | visit www.sunbeam.com.au
phone 1300 881 861
mail Suite 1, Level 1,
13 Lord Street,
Botany NSW 2019
Australia
New Zealand | visit www.sunbeam.co.nz
phone 0800 786 232
mail Level 6, Building 5, Central
Park, 660–670 Great South
Road, Greenlane, Auckland.
Suite 1, Level 1,
13 Lord Street,
Botany NSW 2019
Australia
www.sunbeam.co.nz
0800 786 232
Level 6, Building 5,
Central Park, 660-670
Great South Road,
Greenlane, Auckland
New Zeland
Newell Australia Pty Ltd | ABN 68 075 071 233
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.