ON-THE-GO FRESH
Portable Air Purifier
User Guide
SAP0800WH, SAP0800BK, SAPF0800
Contents
Sunbeam’s Safety Precautions
Sunbeam’s Safety Precautions 1
What’s included in your box 2
Control Panel & Features 3
Features of your Air Purier 4
Getting Started 4
Operating Instructions 5
Care and maintenance 5
Replacing lter 6
Troubleshooting 7
Warranty Information 8
Important Instructions - retain for future use
When using electrical appliances, basic safety
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons. These precautions include:
• Read all instructions before using the
appliance.
• Read the maintenance instructions before
opening the appliance.
• To avoid fire or shock hazard, plug the
appliance directly into appropriate electrical
outlet.
• If the filter is covered by a bag when shipped,
remove plastic bag before use and keep away
from children.
• Keep the cord out of heavy traffic areas. To
avoid fire hazard, never put the cord under
rugs, near heat registers, radiators, stoves, or
heaters.
• To protect against electrical hazards, do not
immerse the appliance or use near water or
other liquids.
• This appliance is not intended for use by
children or by persons with reduced physical,
sensory, or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Close supervision
is necessary when any appliance is used
near children. Children should be supervised
to ensure that they do not play with the
appliance. Keep the appliance and its cord out
of reach of children.
• Always turn the appliance off before
unplugging it.
• Always unplug the air purifier before moving
or cleaning the unit, opening the filter
chamber cover, changing the filters and
whenever the unit is not in use. To disconnect
the unit, be sure to pull the plug and not the
cord.
• Never drop or insert any objects into the
openings of the unit.
• Do not operate any appliance with a damaged
cord or plug. If the air purifier fails to operate
or the unit has been dropped or damaged in
any manner, return appliance to manufacturer
for examination and/or repair. Appliances that
are obviously damaged must not be operated.
• Use appliance only for intended household
use as described in this manual. Any other
use not recommended by the manufacturer
may cause fire, electric shock, or injury to
persons.
• Do not use outdoors.
• Never place on a soft surface such as a bed
or sofa as this could cause the unit to tip over
and block the air inlet or outlet grills.
• Keep unit away from heated surfaces and
open flames.
• Do not place anything on top of unit.
• Prior to cleaning or other maintenance, the
appliance must be disconnected from the
supply mains.
• Never use detergents, gasoline, glass cleaner,
furniture polish, paint thinner or other
household solvents to clean any part of the
appliance.
• This appliance should only be used in a room
with temperatures between 10° C and 40° C.
• WARNING: To reduce the risk of fire or
electric shock, do not use this appliance with
any solid-state speed control device.
• Do not place the appliance on a walkway
or where someone may trip over it.
Misplacement of the appliance may cause a
trip and fall.
• CAUTION: To prevent risk of electric shock,
remove cord plug from outlet before opening
appliance. To prevent risk of fire, inspect and
clean equipment regularly as noted in this
manual.
• This appliance contains a UV-C emitter.
• Unintended use of the appliance or damage
to the housing may result in the escape of
dangerous UV-C radiation.
• UV-C radiation may, even in little doses,
cause harm to the eyes and skin. Do not
operate the UV-C emitter outside the
appliance.
• WARNING: The filter cover is provided to
prevent exposure to excessive ultraviolet light.
Do not defeat its purpose. Do not attempt to
service without turning unit off.
• CAUTION: This equipment should be
inspected frequently and collected dirt
removed from it regularly to prevent excessive
accumulation.
If you have any concerns regarding the performance and use of your appliance,
please visit the Sunbeam website or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
1
What’s included in your box Control panel and features
1 Sunbeam On-The-Go Fresh Portable Air Purier
1 USB Charging Cable
1 Sunbeam True HEPA Filter pre installed
On/Off button
Press and hold the On/off button for 1
second to turn the unit on, press and hold
On/off button for 1 second to turn the unit
off.
Fan speed settings
Adjusts the speed between I (Low),
II (High), Auto.
UV Light
Turn the UV light on and off
depending on your preference.
AIR QUALITY INDICATOR & FILTER
REPLACEMENT INDICATOR
The light illuminates in red and starts
ashing when it’s time to replace your lter.
2
3
Features of your air purifier Operating instructions
A battery operated fan with integral
batteries or a separate/detachable battery
pack shall be recharged only with the
specified charger for the battery. A charger
that may be suitable for one type of battery
may create a risk of fire when used with
another battery.
Use battery operated fan only with
specifically designated battery pack. Use of
any other batteries may create a risk of fire.
When battery pack is not in use, keep it
away from other metal objects such as
paper clips, coins, keys, nails, screws, or
other small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause sparks, burns, or a fire.
Risk of fire - Use battery operated fan
only with installed battery. Battery is not
removable or replaceable. Do not attempt
to access.
Getting started
1. Locate the lter door on the top of the
unit. Remove cover by using rib and lift
off.
2. Remove the plastic bag from the lter
and re-insert the lter. Make sure the
ribbon tab is exposed and the lter is
pushed completely to ensure the unit
operates properly.
PRODUCT DISPOSAL
This product contains an integral
lithium battery which is not removable
or replaceable. Do not incinerate this
product, even if it is severely damaged.
The batteries can explode in a fire. Do not
dispose of product in normal household
waste. We encourage you to help protect
our environment and recycle this product
through a local electronics recycling
program. Please observe local regulations
for proper disposal.
3. Realign the cover and gently press it
back into the unit.
4. Your unit is equipped with one True
HEPA lter that last 6 months.
1. Place the unit on a dry, stable and rm
surface. Make sure not to block the
back air vent and air intake grille.
2. Press and hold the On/off button for 1
second to turn unit on, Press and hold
the On/off button again to turn unit off.
3. Select desired fan speed setting
I (Low), II (High), Auto Mode by pressing
the Fan Speed button (
) to cycle
Care and maintenance
• Before cleaning the air purier, turn the
unit off.
• Clean the exterior surface with a clean,
damp cloth.
• The back air vent can be cleaned of
dust with a small, soft brush.
• If you would like to clean the inside of
the lter compartment, ONLY use a dry,
soft cloth to wipe it down.
through the speeds until it reaches
desired speed setting.
4. To turn the UV ON, press the UV button
once until the White LED light next to
the button is illuminated. Press the UV
button again to turn the UV OFF.
WARNING: Do not allow moisture to come
into contact with the main housing of the air
purier.
NEVER use detergents, gasoline, glass
cleaner, furniture polish, paint thinner, or
other household solvents to clean any part
of the appliance.
4
5
Replacing filter
Troubleshooting
It is recommended to replace the True
HEPA filter every 6 months.
1. Remove cover by using rib and lift off.
2. Insert the new True HEPA lter. Make
sure ribbon tab is exposed and the lter
is pushed in completely to ensure the
unit operates properly.
The lter indicator on the control panel will turn on in red and ash when it’s time to replace
your lters. For the best performance, replace the True HEPA Filter every 6 months.
3. Realign the cover and gently press it
back into the unit.
4. Turn the power ON.
5. To reset lter reminder, press and hold
the Fan Speed Button for 3 seconds,
the red ashing indicator will then turn
off.
For troubleshooting and FAQs visit www.sunbeam.com.au.
Problem Solution
Why is my unit not
working?
Why is there a
decrease in air
flow?
Why is the unit
making a loud
noise?
Make sure unit is turned ON.
Make sure filter is properly installed and the filter door is correctly
closed.
Use USB cord to input 5 VDC 1.0A for battery charging.
Make sure nothing is blocking air intake grille and filtered air outlet.
Check condition of the filter and replace if necessary.
Check filter to remove any plastic wrapping/packaging.
Use USB cord to input 5VDC 1.0A for battery charging.
Make sure parts are firmly positioned in place.
Open the filter door and verify that any plastic packaging was
removed from the filter.
Visit www.sunbeam.com.au to see which retailers sell our genuine Sunbeam
SAPF0800 True HEPA lter replacements.
6
7
This product is covered by a 12 month
replacement or repair warranty, which is
in addion to your rights under the
Australian Consumer Law (if your product
was purchased in Australia) or New Zealand
Consumer Guarantees Act (if your product
was purchased in New Zealand).
Should you experience any
difficules with your product
during the warranty period,
please contact our customer
service line for advice on 1300
881 861 in Australia, or 0800
786 232 in New Zealand.
Australia
www.sunbeam.com.au
1300 881 861
New Zealand
www.sunbeam.co.nz
0800 786 232
Upon receipt of your claim, Sunbeam will seek
to resolve your difficules or, if the product is
defecve, advise you on how to obtain a
replacement or refund.
To assist us in managing warranty claims, we
recommend you register your product as soon
as praccable aer purchase, on our
Sunbeam website and uploading a copy of
your original receipt. View the Support
secon of the Sunbeam website.
In order to make a claim under our warranty,
you must have the original proof of purchase
documentaon for the product and present it
when requested (if not already uploaded to
our website).
Should your product develop any defect
within 12 months of purchase because of
faulty materials or workmanship, we will
replace or repair it, at our discreon, free of
charge. A product presented for repair may be
replaced by a refurbished product of the same
type rather than being repaired. Refurbished
parts may be used to repair the product.
Our replacement or repair warranty only
applies where a defect arises as a result of
faulty material or workmanship during the
warranty period. Your warranty does not
cover misuse or negligent handling
(including damage caused by failing to use the
product in accordance with this instrucon
booklet), accidental damage, or normal wear
and tear.
Your warranty does not:
• cover freight or any other costs incurred in
making a claim, consumable items,
accessories that by their nature and limited
lifespan require periodic renewal (such as
filters and seals) or any consequenal loss or
damage; or
• cover damage caused by:
-power surges, power dips, voltage supply
problems, or use of the product on
incorrect voltage;
-servicing or modificaon of the product
other than by Sunbeam or an authorised
service centre;
-use of the product with other
accessories, aachments, product
supplies, parts or devices that do not
conform to Sunbeam specificaons; or
-exposure of the product to abnormally
corrosive condions; or
• extend beyond 3 months if the product is
used in commercial, industrial, educaonal or
rental applicaons.
The benefits given to you by our warranty
are in addion to other rights and remedies
under law in relaon to the product.
In Australia our goods come with guarantees
that cannot be excluded under the
Australian Consumer Law. You are entled
to a replacement or refund for a major
failure and for compensaon for any other
foreseeable loss or damage. You are also
entled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to a
major failure.
Our goods also come with guarantees that
cannot be excluded under the New Zealand
Consumer Guarantees Act.
If your warranty claim is not accepted, we
will inform you and if requested to do so by
you, repair the product provided you pay
the usual charges for such repair. You will
also be responsible for all freight and other
costs.
Should your product require repair or
service aer the warranty period, contact
your nearest service centre. For a complete
list of service centres, visit our website or
call our customer service line for advice on
1300 881 861 in Australia, or 0800 786 232
in New Zealand.
8
Need help with your appliance?
Contact our customer service team or visit our
website for information and tips on getting the
most from your appliance.
Australia | visit www.sunbeam.com.au
phone 1300 881 861
New Zealand | visit www.sunbeam.co.nz
phone 0800 786 232
Newell Australia Pty Ltd. ABN 68 075 071 233
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2022.
SAP0800WH_SAP0800BK_SAPF0800_22EM1 (ANZ)_GCDS-LD NWL0001426231
Loading...