Please read these instructions carefully
and retain for future reference.
Visio Stainless
1.7 litre cordless kettle in
brushed stainless steel
Instruction Booklet
KE7600B
Contents
Important instructions – retain for
future use.
Sunbeam’s Safety Precautions 1
Features of your
Visio Stainless 2
Using your Visio Stainless
4
Sunbeam’s 3-Way Safety System
5
Care and Cleaning
6
1
Sunbeam are very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• Close supervision is necessary when your
appliance is being used near children or
infirm persons.
• Never leave an appliance unattended while
in use.
• Young children should be supervised to ensure
that they do not play with the appliance.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• For safety reasons and to avoid maintenance
by unskilled persons, some appliances are
‘sealed’ using tamperproof screws. Such
appliances should always be returned to the
nearest Sunbeam Appointed Service Centre
for adjustment or repair if required.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
dropped or damaged in any manner. If damage
is suspected, return the appliance to the
nearest Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line
Ensure the above safety precautions are understood.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM KETTLE.
• Boiling water will scald. Do not leave a
boiling or hot kettle near or where children
may touch it.
• Boiling water may be ejected, if overfilled.
• Do not leave the power cord near the edge
of a bench top where children may touch
or pull it.
• Do not move kettle while switched on.
• Always turn the power off and unplug the
cord while the kettle is NOT in use.
• Do not operate the kettle without water.
• Your Visio Stainless kettle must only be used
with the power base supplied.
• Always operate the kettle on a flat,
level surface.
2
Features of your Visio Stainless
Removable mesh filter
Eliminates scale deposits resulting in cleaner
water and is removable for easy cleaning.
2400 watt concealed element
The fast boil 2400 watt element is concealed
in the base of the kettle for longer element
life. The smooth stainless floor reduces scale
build up and allows for easy cleaning.
360 degree cordless power base
Designed to allow you to place the kettle on
the base in any direction. Convenient for both
left and right handed users.
Hinged lid with safety lock
Hinged locking lid opens at the push of a
button for one-handed use and for safety,
locks shut to reduce the chance of accidental
scolding.
Soft grip handle
Contoured design for easy handling and
pouring.
Easy read water gauge
Indicates the volume of water in the kettle
up to 1.7 litres.
Neon ON/OFF switch with auto cut-out
Lights up to indicate that the kettle is on and
heating. Switches the kettle off automatically
after boiling.
Cord storage facility
Excess cord can be wound around the cord
storage facility underneath the power base.
3
3-Way Safety System
1 – Automatically switches the kettle off after boiling.
2 – Cuts out for boil-dry production.
3 – Shuts down in case of overheating.
4
Before using your kettle.
It is recommended that you clean your kettle
before use by filling the kettle with water,
up to the maximum level indicator, boil and
discard.
Using your kettle.
1. To fill the kettle, remove it from the power
base and lift the lid, by pressing the button
on the handle. Alternatively, the kettle may
be filled through the pouring spout.
2. Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks. Too little
water will result in the kettle switching off
before the water has boiled.
NOTE: Do not fill the kettle over the
maximum level, as water may spill out of
the spout when boiling.
3. Push the lid closed firmly until it locks into
position.
4. Place the kettle on the power base and
connect the plug into a 230/240 Volt
AC power outlet. Turn the power ON.
5. Press the ON/OFF button downwards at the
base of the handgrip. The power indicator
light will illuminate to indicate the kettle
is heating. The kettle will switch off
automatically once the water has boiled.
NOTE: Ensure that the ON/OFF switch is
clear of obstructions and the lid is firmly
closed. The kettle will not turn off if the
ON/OFF switch is constrained or if the lid
is left open. Do not remove the kettle from
the power base while in use.
6. Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will
scald.
7. The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, boil-dry protection
will automatically switch it off. If this
occurs, allow the kettle to cool before
filling with cold water and re-boiling.
Cord Storage Facility.
Excess cord can be stored by winding the
cord around the storage facility underneath
the power base.
Using your Visio Stainless
360° power base
5
Safety is a major consideration in the
design of a Sunbeam kettle. This is why we
have developed our 3-Way Safety System,
which ensures that your kettle will:
1. Automatically switch off after boiling.
For convenience, safety and energy
efficiency, your Sunbeam kettle will
automatically switch off after boiling.
2. Cut-out for boil-dry protection.
If the kettle is operated without water, it
will automatically cut-out, preventing any
damage to the element.
If this occurs, allow the kettle to cool
before filling with cold water and
re-boiling.
3. Shut-down in case of overheating.
In the event of overheating, the kettle will
automatically shut down to prevent further
damage. Should this occur, take your kettle
to a Sunbeam Service Centre or Appointed
Service Agent.
Sunbeam’s 3-Way
Safety System
6
Always disconnect the kettle from the
power outlet before cleaning.
Never immerse the kettle switch area, cord
or power base in water, or allow moisture to
come into contact with these parts.
Removal of mineral deposits.
Mineral deposits in tap water may cause
the interior of the water gauge to discolour.
To remove this build-up, use Sunbeam
Liquid Descaler, a simple to use, non-toxic
cleaner available from Sunbeam Appointed
Service Agents.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2. Empty the solution from the kettle. Any
stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill
the kettle with clean water, bring to boil
and then discard the water. Repeat and the
kettle will then be ready to use.
The outside of the kettle can be wiped over
with a damp cloth.
CAUTION: Do not use chemicals, steelwool,
or abrasive cleaners to clean the outside of
the kettle.
To clean the mesh filter.
Press the button on the handle to open the
hinged lid. Grasp the top of the mesh filter
and pull upwards to remove. Wash in warm
soapy water and dry thoroughly before
replacing in the kettle.
Cleaning the concealed heating element
This kettle features a non-corrosive
stainless steel heating element. Over
time, scale may build up on the
concealed element inside the kettle,
causing discolouration that may have the
appearance of rust. Be assured this is
not rust. If this occurs clean with a green
Scotchbrite
®
scourer or similar and a
suitable abrasive cleaning cream. Rinse
and clean thoroughly with tap water before
using your kettle again.
Care and Cleaning
‘Sunbeam’ & ‘Visio Stainless’ are registered trademarks of
Sunbeam Corporation.
Made in China. Due to minor changes in design or
otherwise, the product may differ from the one shown
in this leaflet. Backed by Sunbeam’s 12 Month
Replacement Guarantee and National Service Network.
© Copyright.
SUNBEAM CORPORATION LIMITED 2006.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
Sunbeam Corporation is a division of GUD Holdings Ltd.
For more information or advice on this or any other
Sunbeam appliance, visit www.sunbeam.com.au or
contact the Sunbeam Consumer Service Line.
Australia 1800 025 059
New Zealand 0800 786 232.
04/0
6
is a registered Trademark of Sunbeam
Corporation Limited. ACN 000 006 771.
© Sunbeam Corporation Limited 2006.
Consumer Hotline
Australia
1800 025 059
New Zealand
0800 786 232
www.sunbeam.com.au
Loading...