Sunbeam 2576 User Manual

Page 1
r
a”
MODEL 2576
OWNER’S
MANUAL
CAUTION:
READ AND
INSTRUCTIONS.
HEPA 2500
AIR CLEANER
OPERATING INSTRUCTIONS
Any questions or comments?
Call I-800-526-2832
Mon.-Fri. 8 a.m.
- 4
p.m. Central Time
Page 2
Your Sunbeam 2500 Air Cleaner has been designed to let you enjoy a refreshing experience in clean air living.
Airborne particles are removed from air passing through the unit.
NOTE: This owner’s manual should be read tho-
roughly before your air cleaner is operated. Keep your owner’s manual for future refer­ence.
HOW THE SUNBEAM HEPA 2500 AIR CLEANER WORKS
1. PRE-FILTER \
2. CARTRIDGE AIR FILTER (HEPA FILTER)
3. CHARCOAL AFTER-FILTER
I
The air around you is filled with thousands of particles of air pollution. Some of the pollutants (dust, smoke and lint) are visible to the naked eye, but most of the pollutants (pollen and bacteria, to name a few) are microscopic in size.
Your true HEPA Filter is enclosed with a sealing label
placed over the top of the collector assembly. This label provides a complete sealing of the HEPA Filter ensuring a 99.97% efficiency at removing common indoor air particles. Do not remove this label unless
replacing the HEPA or Charcoal Filter.
As polluted air is drawn into your console air cleaner
1),
(Figure
an Aluminum Pre-Filter strains out the
larger particles of pollution. The air then passes
through the cartridge air filter (HEPA Filter) where
microscopic particles are collected.
The now cleaned air then passes through a filter of activated carbon. Activated carbon acts like a sponge to help remove odors. (Figure 2) Having been cleaned
three ways, the air returns to the room through the
bottom front grill. (Figure 1)
Figure 2
UNIT LOCATION
Select the location for your air cleaner with an electri­cal outlet nearby. An example of locating your air cleaner is shown in Figure 3.
NOTE: DO NOT USE AN EXTENSION CORD TO
SUPPLY POWER TO YOUR AIR CLEANER.
Your console air cleaner can be placed almost any-
,
where as long as the air can freely circulate into the top front grill and out of the bottom front grill. (Figure 1)
POLLUTED
AIR IN
CLEAN AIR OUT
Figure
Figure 3
1
1
Page 3
OPERATION
MAINTENANCE
Plug the cord into any standard household electrical
outlet. (See data label for electrical specifications and
power consumption. This data label can be seen when
the cabinet top is removed.)
Turn the unit on by sliding the ON/OFF switch to the desired speed: “DAILY USE, MEDIUM or HIGH”. (Fig­ure 4) The air cleaner should be set on HIGH for 1 minute before switching to desired speed to initially start-up the unit. Your air cleaner is designed for con­tinuous operation
-- peak efficiency is obtained when the air cleaner remains on constantly. For best results, select “DAILY USE” setting.
An operating light is located on the top right front grill and indicates that the unit is operating. (Figure 5)
CARE OF CABINET
You should treat the cabinet of your air cleaner as you would any other piece of fine furniture. A soft, damp cloth will keep it clean and attractive for many years. The front grill can be cleaned using a vacuum cleaner with a brush attachment.
TO
REMOVE HEPA FILTER ASSEMBLY
Turn off the air cleaner and unplug it from the electri­cal power source.
Remove the cabinet top by lifting up and remove the Sealing Label (enables 99.97% efficiency) from the top of the HEPA Filter Assembly.
Label.
Lift out the collector assembly using the flip-up
handle. (Figure 6) The HEPA Filter Assembly includes:
Aluminum Pre-Filter, HEPA Filter and Charcoal After-Filter.
The front filter (Aluminum) is the Pre-Filter. The HEPA Filter is the middle (large) filter, and the Charcoal After­Filter is in the back of the HEPA Filter Assembly. (Fig­ure 7)
Do not discard Sealing
Figure 4
Figure
5
OPERATING LIGHT
CHARCOAL AFTER-FILTER
HEPA FILTER
ALUMINUM PRE-FILTER
Figure 6
HEPA
, FILTER
ASSEMBLY
Figure 7
Page 4
TO CLEAN PRE-FILTER
TO REPLACE HEPA FILTER ASSEMBLY
Slide out Pre-Filter located in front of the Filter Assem­bly. Rinse thoroughly with clean warm water. Set aside to dry.
REPLACEMENT OF HEPA FILTER
After about 12 months of collecting dirt, dust, pollen and other pollutants, the HEPA Filter of your unit will
The
HEPA
need to be replaced.
cleaned.
replacement filters if not available from your retailer. Remove the Pre-Filter and Charcoal After-Filter from
the HEPA Filter Assembly and place aside. The HEPA
Filter can now be discarded. Using the directions on
top of the new HEPA Filter, replace the aluminum
Pre-Filter in slots provided in front of the HEPA Filter and replace the Charcoal After-Filter in the slots pro­vided in the back.
Use the enclosed reorder form to order
Filter cannot be
REPLACEMENT OF CHARCOAL FILTER
ACTIVATED CHARCOAL FILTER HELPS REMOVE
HOUSEHOLD ODORS.
NOTE: Use directions on the top of the
Assembly for proper placement of the filters
into the assembly and for replacing the as­sembly into the unit.
Using the handle, slide the HEPA Filter Assembly back into the cabinet. Aluminum Pre-Filter will face the front
grill. Replace the Sealing Label provided with the new
HEPA Filter over the opening containing the HEPA Filter Assembly.
HEPA
Filter
TO REPLACE CABINET TOP
Replace the cabinet top by positioning over the unit and placing on cabinet. (Figure 8) Be sure that the plas­tic ball and socket are engaged.
Plug the cord into the electrical power source and select desired speed.
PLASTIC BALL
8
SOCKET
To remove the Charcoal Filter, remove the Sealing
Label from top of Filter Assembly and place aside so it can be reused. Remove the Charcoal Filter from the Filter Assembly. should be replaced every 3-6 months under average conditions. These filters are available in your retail store or use the enclosed order form.
After replacing the Charcoal Filter, return the Filter Assembly back into the cabinet. Reseal the top of the
Filter Assembly with the Sealing Label removed pre­viously.
Do not wash the Charcoal Filter. It
Figure 8
Page 5
TROUBLESHOOTING CHECKLIST
Many times questions that appear to be major can be solved quite easily. The chart below lists potential questions/ problems and how to correct them. Remember, check the simple things first.
CONDITION WHAT TO CHECK
Unit fails to turn on.
Unit does not remove pollutants/ Reduced air flow
Unit still does not
operate properly.
1. Power Cord
2. Electrical Outlet
3. ON/OFF Switch
4. Cabinet Top is properly intalled
5. Collector assembly is pro­perly installed.
HEPA
Filter
Re-check the above points.
WHAT TO DO
1. Plug in power cord.
2. Check for power to the electrical outlet. Plug a table lamp into the electrical outlet to ensure power availability.
3. Set ON/OFF Switch to desired speed.
4. Refer to section on previous page,
“To Replace Cabinet Top.”
5. Use directions on the top side of the assembly. Aluminum Pre-Filter will face the front grill.
1. As the HEPA Filter collects, a higher speed may be necessary to maintain the original cleaning level of the air cleaner.
2. The HEPA Filter needs to be replaced. (Will
need to be replaced every 12 months or sooner depending on the environment the air cleaner is operated in.)
Return unit to Appliance Service Station, Hattiesburg, MS, for service. See Warranty Information on back cover for address.
NOTE:
Blowing smoke directly into the front grill is not a good test for unit performance.
4
Page 6
CABINET TOP
CHARCOAL REPLACEMENT FILTER
2
0
ALUMINUM PRE-FILTER
PARTS LIST
Key
Number Number
1
2 3 4
To order Replacement Parts, write to Appliance Service Center, 117 Central Industrial Row, Purvis, MS 39475.
Part
344953-001
123324-003
6576
6575
Description
Cabinet Top Aluminum Pre-Filter
HEPA Filter
Charcoal Replacement
Filter
Page 7
31
Notes/Notas
Page 8
e
MODEL 2576
OWNER’S
HEPA
2500
AIR CLEANER
LIMITED ONE YEAR WARRANTY STATEMENT
MANUAL
This product is warranted for one year from the date of purchase
against electrical and mechanical defects in material and workman­ship. If the unit fails to operate during this period, return it, prepaid, to Appliance Service Station, 117 Central Industrial Row, Purvis, Mississ­ippi,39475, for repair or replacement without charge at the manu­facturer’s option. This warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
Warrantor: Sunbeam-Oster Household Products
Made in America
@Sunbeam,
@Sunbeam-Oster
Household Products, Distributed by Sunbeam-Oster Household Products, Schaumburg IL
Committed To Our Environment . . . Printed on Recycled Paper ,‘*,
60173
Part No. 61803 (144965001)
Printed in USA
.v
Loading...