Sunbeam 1632 User Manual

Model Modèle Modelo Model

1632

Series

Printed in China / Imprimé en Chine Impreso en China / Impresso na China P.N. 113995

Instruction Manual

WALL MOUNT 1200-1500 WATT HAIR DRYER

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE

Manuel d’Emploi

SÉCHOIR À CHEVEUX 1200-1500 WATTS À MONTAGE MURAL

LIRE TOUTES LES INSTRUCTIONS AVANT D'UTILISER

Manual de Instrucciones

SECADOR DE CABELLO DE 1200-1500 WATTS MONTAGE EN LA PARED

LEA TODAS LAS INSTRUCCIONES ANTES DE USAR ESTE APARATO

Manual de Instruções

SECADOR DE CABELO DE 1200-1500 WATTS FIXAÇÃO À PAREDE

LEIA TODAS ASINSTRUÇÕES ANTES DE USAR ESTE APARELHO

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:

READ AND SAVE ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER DANGER – As with most electrical appliances, electrical parts are electrically live even

when the switch is off. To reduce the risk of death by electric shock:

1. Do not install or store appliance where it can fall or be pulled into a tub or sink.

2. Always unplug this appliance from the electrical outlet immediately after using and

before cleaning.

3. Do not use while bathing.

4. Do not place in or drop into water or other liquid.

5. If hand unit falls into water, turn unit off immediately. Do not reach into water. WARNING – To reduce risk of burns, electrocution, fire or injury to persons:

1. Close supervision is necessary when this appliance is used by, on, or near invalids or

disabled persons. This appliance should not be used by or on children.

2. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Sunbeam.

3. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged or dropped into water.

4. Keep the cord away from heated surfaces.

5. Never block the air openings of the appliance or place it on a soft surface, such as a

bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, etc.

6. Never use while sleeping.

7. Never drop or insert any object into any opening.

8. Do not use outdoors, or operate where aerosol (spray) products are being used, or

where oxygen is being administered.

9. Periodically inspect wall unit for secure mounting.

10. Do not direct hot air toward eyes or other heat-sensitive areas.

11. The unit and attachments may be hot during use. Allow to cool before handling. To

avoid burn hazard, do not let bare skin touch heated surfaces.

12. Do not place appliance on any surface while it is operating.

13. While using the appliance , keep your hair away from the air inlets.

14. Do not wrap cord around dryer. Continuous stress on the cord can damage cord

insulation and result in a shock, fire, or burn hazard.

15. Do not operate this appliance with a voltage converter.

OPERATE ON 110V 50-60Hz ONLY

Any service other than specifically mentioned should be performed only by an authorized service facility. Please see warranty ser vice information.

FOR PRODUCTS PURCHASED IN THE U.S. AND CANADA ONLY: To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider

than the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT ATTEMPT TO DEFEAT THIS SAFETY FEATURE.

CAUTION – Never allow the power supply cord to be pulled, twisted, or severely bent. Never wrap the cord tightly around the dryer. Damage will occur at the high flex point of entry into the dryer, causing it to r upture, arc, and short. Inspect the cord frequently for damage. Stop use immediately if damage is visible or unit stops or operates intermittently.

SAVE THESE INSTRUCTIONS

MOUNTING INSTRUCTIONS For use on sheetrock or wood walls only. The Sunbeam®Wall Mount hair dryer is designed for installation on

sheetrock or wood walls only.To mount onto wall, be sure there are no hidden electrical circuits or pipes in the mounting location.

FEATURES OF YOUR HAIR DRYER

1632-040 shown here*

Magnetic Hand

Locking System

Wall Mount Cradle

Hair Dryer

FOLLOW THESE INSTRUCTIONS

1. Remove wall bracket from the unit.

2. Use the bracket or

locking plate (optional) as template to mark

BRACKET

position of holes for drilling close to electrical outlet,away

Anchor Bushing

from tub or sink.

Screw

MOUNTING INSTRUCTIONS

1632-040 shown here

WALL MOUNT

UNIT (Base)

3. Drill three 3/16 inch

holes.

4. Insert the three anchor

bushings by tapping lightly with a hammer until the shoulder of the bushing rests

Plug

against the wall.

5. Position wall bracket

and tighten the two bottom screws first, then tighten the top screw.(Anchor

LOCKING PLATE

(Optional)

bushings and screws are provided for you).

6. Match the slots on the back of the mounting base with the hooks

on the bracket.

7. Press base onto the hooks and slide down to insure secure

mounting.(If using locking plate , remove small screw from center of magnet and replace with longer screw included).

8. Plug the unit into the nearby electrical outlet (110 volt,50 – 60

cycle AC only).

DANGER – To reduce risk of electrocution,do not install where unit can fall into tub or sink.

Off Switch

Off Button

On Button

Hi,Low

Control Switch

ALCI

Night Light

Test and

Reset Buttons

3- Ft. Power Cord

Expandable

Power Cord

*1632-020 is without the night light

OPERATING INSTRUCTIONS This dryer is equipped with an appliance leakage circuit interrupter

(ALCI) for your safety.This device is designed to make the appliance inoperable under some abnormal conditions (such as accidental immersion in water).

After the appliance is plugged in,you must check your protective device as follows:

1. Press the “Reset” button on the ALCI device.

2. Press the “Test” button.The “Reset” button will pop out.This verifies that the protective device is working properly.

3. Press the “Reset” button once more to reactivate the safety device and use your appliance.

REPEAT THE ABOVE PROCEDURE BEFORE EACH USE TO CONFIRM THAT THE PROTECTIVE DEVICE IS OPERATING.

If your protective device does not operate as described above,please contact your nearest authorized Sunbeam distributor.

Removable Lint Screen

TO USE

1. Remove hair dryer from cradle.

2. To start the dr yer,press the ON button on the wall mount unit.

3. Slide the control switch to:LOW position for styling hair, HIGH position for fastest drying.

4. Stop the dryer by pushing the OFF button or by replacing the unit to the mounting base, which will automatically engage the OFF switch.

For your protection,this unit contains a thermostat that prevents the dryer from overheating.Should the air intake and/or air outlet become blocked or obstructed,the hair dryer will automatically shut off.If this occurs, slide the switch to OFF,unplug and allow dryer to cool.If dr yer continues to turn off automatically,discontinue use and contact your nearest authorized Sunbeam distributor.

CAUTION – Use your Sunbeam hair dryer with care. Directing a high volume of heat continuously to one area can overheat hair and scalp. When using a “High” heat setting, hold the blower opening a few inches away from the hair, drying one section at a time .Work layers of hair in quick strokes.Keep the dryer in motion until drying and styling are complete.

LOWER WATTAGE CONSUMPTION

For lower wattage consumption, there is an optional 1200/1500 switch found behind the lint screen.(Patent Pending)

Removable Lint Screen

1. Remove lint screen.

2. Locate wattage switch and move to the desired wattage.

3. Replace lint screen.

1200/1500

Wattage Switch

CARING FOR YOUR HAIR DRYER

STORAGE

1. Always store dryer inside the base.

2. Do not mount or store dryer in an area with excessive heat or moisture.

3. Do not wrap cord around dryer.Allow to hang loosely from dryer.

4. Do not hang dryer by cord or use cord as a handle.

5. Store in a cool,dr y place and out of reach of children.

6. Store where dryer will not be accidentally damaged from bumping or falling.Do not put anything on top of dr yer.

MAINTENANCE, CARE & CLEANING

1. Always unplug dryer from outlet before cleaning.

2. Clean dryer by wiping with a soft, lightly moistened cloth.

3. NEVER IMMERSE HAIR DRYER IN WATER.

4. The motor never needs oil or grease.

5. Check the removable lint screen.It is important that you clean the removable lint screen when hair, lint or dust begin to build up on it. To remove the screen,rotate counter-clockwise and loosen.To clean,brush the outside of the screen with a toothbrush to loosen lint,etc .Then turn the screen over and rinse under a running faucet. Towel dry the screen thoroughly. If inside of screen is dirty, brush gently with a toothbrush to clean. To replace screen, line up pegs on inside of the screen with slots on side of unit and rotate clockwise to lock in place.

NIGHT LIGHT FEATURE

(1632-040 model only) To change bulbs, follow instructions below.

1. To remove lens: Insert tool (screw driver, knife point, etc.) in crevice.

2. Replace bulb and lamp holder as an assembly by pulling straight out.Each bulb can be replaced separately.

(Close-up)

ONE-YEAR LIMITED HOSPITALITY WARRANTY Sunbeam Products,Inc. or if in Canada, Sunbeam Corporation (Canada) Limited

(Collectively “Sunbeam”) warrants that for a period of one year from the date of purchase,this product will be free from defects in material and workmanship.Sunbeam, at its option,will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available,replacement may be made with a similar product of equal or greater value.

This is your exclusive warranty.This warranty is valid for the original purchaser from the date of initial purchase and is not transferable.Sunbeam dealers, service centers,or stores selling Sunbeam products do not have the right to alter, modify or any way change the terms and conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the following:negligent use or misuse of the product, use on improper voltage or current,use contrary to the operating instructions, disassembly,repair or alteration by anyone other than Sunbeam or an authorized service center. Further,the warranty does not cover Acts of God,such as fire, flood, hurricanes and tornadoes.

Sunbeam shall not be liable for any incidental or consequential damages caused by the breach of any express or implied warranty.Except to the extent prohibited by applicable law,any implied warranty of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. Sunbeam disclaims all other warranties,conditions or representations express, implied,statutor y or otherwise . Some states, provinces or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts,so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state or province to province.

This warranty is only applicable to products purchased by members of the hospitality industry and not to consumer sales.

How to Obtain Warranty Service

Contact your Sunbeam authorized dealer.

www.sunbeamhospitality.com

MESURES DE SÉCURITÉ

IMPORTANTES

Lors de l’utilisation d’appareils électriques, surtout à proximité d’enfants, des mesures de sécurité de base doivent toujours être suivies, incluant celles qui suivent:

LISEZ TOUTES LES INSTRUCTIONS AVANT L’UTILISATIONGARDEZ L’APPAREIL LOIN DE L’EAU

DANGER – Comme avec la plupart des appareils électriques, les pièces électriques sont

sous tension même lorsque l’interrupteur est dans la position d’arrêt. Pour réduire le danger de choc électrique:

1. Ne mettez pas ou ne rangez pas l’appareil dans un endroit d’ou il peut tomber ou etrê tiré dans une baignoire ou en évier.

2. Toujours retirer cet appareil de la prise de courant après usage et avant nettoyage.

3. Ne l’utilisez pas en prenant un bain.

4. Ne le palcez pas ou ne l’échappez pas dans l’eau ou autre liquide.

5. Si l’appareil por tatif tombe dans l’eau, le mettre immédiatement en position arrêt. Ne pas

le toucher dans l’eau.

ADVERTISSEMENT – Pour réduire le risque de brûlures, électrocution, incendie ou blessures personnelles:

1. Une sur veillance attentive est nécessaire lorsque cet appareil est utilisé par, sur ou proche de personnes invalides ou malades. Cet appareil ne doit pas être utilisé par ou sure des enfants.

2. Utilisez-le tel que décrit dans ce livret d’instruciones . N’utilisez pas d’accessoires non recommandés par Sunbeam.

3. N’utilisez pas cet appareil si le cordon ou la fiche est endommagé ou s’il ne fonctionne pas proprement, s’il a été échappé ou endommagé d’une façon quelconque ou échappé dans l’eau.

4. Gardez le cordon loin des surfaces chaudes.

5. Ne bloquez jamais les admissions d’air de cet appareil et ne le placez pas sur une

surface molle, telle qu’un lit ou un sofa, où les admissions d’air peuvent être bloquées. Gardez les admissions d’air exemptes de charpie, cheveux, etc.

6. Ne l’utilisez jamais lorsque vous vous endormez.

7. N’échappez jamais ou n’insérez jamais d’objet dans les ouver tures.

8. Ne l’utilisez pas à l’extérieur ni dans un endroit ou des produits en aérosol sont utilisés

où dans un endroit où de l’oxygène est administré.

9. Inspecter périodequement l’unité murale pour garantir la sécurité du montage.

+ 11 hidden pages