CSBT-326 BLUETOOTH SPEAKER
Instruction Manual (Read before proceeding)
Power:
z Works on internal rechargeable Lithium battery. Please charge your speaker fully before first use.
z Connect the speaker’s Micro USB socket with the power source’s USB port through USB cable.
z A red light will indicate the charging situation. When battery is full, the red light will turn off
automatically.
z Disconnect the USB cable when it is fully charged.
Playing Music Via Bluetooth
z Turn on Bluetooth speaker by sliding power switch on the back side to “ON” position.
z The blue indicator light will flash quickly . This indicates that speaker entering Bluetooth Pairing mode.
z Turn on the Bluetooth function on your device, search the speaker named “SB-01” and select it, your
device will pair without a password. (If required, enter the password “0000” to finalize the paring).The
Blue light will begin to flash slowly after pair is complete.
z Start playing music on your device. Keep your device within 33feet (10 meters) of your speaker.
z Turn off the unit when not in used.
Light Operation
z Turn on the LED light on the bottom by pushing the switch “Off l Light” to “Light” position.
z Colorful light will either work independently or dance with the rhythm of music.
z Turn off the colorful light by pushing the switch to “Off” position
Caution:
z This is not a toy. Please keep away from small children.
z Please keep away from water / heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not over-charge the battery.
z Battery pack shall not be exposed to excessive heat such as sunshine, fire or the like
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Loading...