Summit Electronics CHBT60789 User Manual
CHBT-706
User Manual
Bluetooth headphone
Manual De Usuario
Manuel de l'utilisateur
Please read carefully before use.
Por favor, lea cuidadosamente antes de su uso.
Se il vous plaît lire attentivement avant utilisation.
Read Me
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9) Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10) Only use attachments/accessories specified by the manufacturer.
11) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
12) Unplug this apparatus during lightning storms or when unused for long periods of time.
13) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
FCC NOTICE TO USERS:
FCC ID: 2AMSOCHBT60789
Caution: Changes or modifications not expressly approved by the Party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection Against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications, however there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for Help.
The device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Summit CE Group is under license. Other trademarks and
trade names are those of their respective owners.
Léeme
Instrucciones de seguridad importantes
1) Lee estas instrucciones.
2) Guarde estas instrucciones.
3) Presta atención a todas las advertencias.
4) Sigue todas las instrucciones.
5) No use este aparato cerca del agua.
6) Limpie solo con un paño seco.
7) No bloquee ninguna abertura de ventilación. Instalar de acuerdo con las especificaciones
del fabricanteinstrucciones.
8) No instale cerca de fuentes de calor como radiadores, registros de calor, estufas u otros
aparatos (incluyendo amplificadores) que producen calor.
9) Proteja el cable de alimentación de ser pisado o pellizcado, especialmente en los enchufes,
receptáculos de conveniencia, y el punto donde salen del aparato.
10) Utilice únicamente accesorios / accesorios especificados por el fabricante.
11) Use solo con el carro, soporte, trípode, soporte o mesa especificados por el fabricante,
o vendido con el aparato. Cuando se usa un carro, tenga cuidado al mover el carro /
combinación de aparatos para evitar lesiones por vuelco.
12) Desenchufe este aparato durante tormentas eléctricas o cuando no se use durante largos
períodos de tiempo.
13) Remita todos los servicios a personal de servicio calificado. Se requiere servicio cuando
el aparato ha sido dañado de alguna manera, como el cable de alimentación o el enchufe
está dañado, se ha derramado líquido u objetos han caído en el aparato, el aparato ha sido
expuesto a la lluvia o a la humedad, no funciona normalmente o se ha caído.
FCC AVISO PARA LOS USUARIOS:
FCC ID: 2AMSOCHBT60789
Precaución: Cambios o modificaciones no aprobados expresamente por la Parte responsable
de el cumplimiento podría anular la autoridad del usuario para operar el equipo.
Nota: Este equipo ha sido probado y se encontró que cumple con los límites para una Clase
B dispositivo digital, de conformidad con la parte 15 de las Reglas de la FCC. Estos límites
están diseñados para proporcionar protección razonable contra interferencia perjudicial en
una instalación residencial. Esta el equipo genera, usa y puede irradiar energía de
radiofrecuencia y, si no está instalado y usado de acuerdo con las instrucciones, puede
causar interferencia dañina a la radio comunicaciones, sin embargo no hay garantía de que
la interferencia no ocurra en un instalación particular. Si este equipo causa interferencia
dañina a la radio o recepción de televisión, que puede determinarse apagando y encendiendo
el equipo, se recomienda al usuario que intente corregir la interferencia por uno o más de los
siguientes medidas:
- Reorientar o reubicar la antena receptora.
- Aumente la separación entre el equipo y el receptor.
- Conecte el equipo a una toma de corriente en un circuito diferente al que el receptor
está conectado.
- Consulte al distribuidor o a un técnico experimentado en radio / TV para obtener ayuda.
El dispositivo cumple con la parte 15 de las Reglas de la FCC. La operación está sujeta a lo
siguiente dos condiciones: (1) este dispositivo no puede causar interferencia dañina, y (2) este
dispositivo debe aceptar cualquier interferencia recibida, incluidas las interferencias que
puedan causar un funcionamiento no deseado.
La palabra y los logotipos de Bluetooth® son marcas registradas propiedad de Bluetooth SIG,
Inc. y cualquier uso de tales marcas por parte de Summit CE Group se realiza bajo licencia.
Otras marcas comerciales y los nombres comerciales son los de sus respectivos dueños.
Read Me
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9) Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10) Only use attachments/accessories specified by the manufacturer.
11) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
12) Unplug this apparatus during lightning storms or when unused for long periods of time.
13) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
FCC NOTICE TO USERS:
FCC ID: 2AMSOCHBT60789
Caution: Changes or modifications not expressly approved by the Party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection Against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications, however there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for Help.
The device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Summit CE Group is under license. Other trademarks and
trade names are those of their respective owners.
US
INTRODUCTION
Thank you for purchasing the CHBT-706! Please read this manual
fully before using this device. The terms used within will become more
familiar as you use your headphones.
CHARGING
Charge your headphones fully before your rst use. To charge, insert the
microUSB cable into the charging port, and connect to a power source.
When it is charging, the indicator light will glow red. After it has nished
charging, the indicator light will go off. Charging time takes up to 2
hours.
When the headset is running out of battery, the blue indicator light will
appear and an alarm sound will be heard. Please charge the battery
immediately. If the headphones are used after this warning, they will
automatically turn o after 5 to 10 minutes.
BLUETOOTH
To connect the headphones to your audio device, first turn the
headphones on by pressing the Power Button. The headphones will
make a noise when they are turned on, and a blue indicator light will
flash when they enter Bluetooth® Mode. If you are not in Bluetooth®
Mode, press and hold the Mode (M) Button until the lights ash blue.
Open the Bluetooth® function on your audio device, and connect to
“CHBT-706.” If asked to enter a passcode, enter in "0000" or "1234."
When the headphones have connected successfully, they will make a
conrmation sound.
®
CONTROLS
TO: DO THIS:
Power On/O Press the Power Button.
Answer or End a Call Press the Call Button.
Decline an Incoming Call
Play or Pause a Song or Video Press the 4/; Button once.
Go to the Previous Track Press the 9 Button once.
Go to the Next Track Press the : Button once.
Increase Volume Press and hold the : Button.
Decrease Volume Press and hold the 9 Button.
Change Mode Press the M Button once.
Hold the Call Button for 3 seconds,
then release the button.
2
Loading...