Bluetooth Headset
Instruction Manual
MODEL#: CETW-510
®
Read Me
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9) Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10) Only use attachments/accessories specified by the manufacturer.
11) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
12) Unplug this apparatus during lightning storms or when unused for long periods of time.
13) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
FCC NOTICE TO USERS:
FCC ID: 2AMSOCETW5A1
Caution: Changes or modifications not expressly approved by the Party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection Against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications, however there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for Help.
The device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
and any use of such marks by Summit Electronics LLC is under license. Other trademarks and
trade names are those of their respective owners.
2
INTRODUCTION
Thank you for purchasing the CETW-510! This
instruction manual is intended to help you better
understand and use your Bluetooth
Terms covered in this manual will become more
familiar to you as you use your device.
®
PRODUCT REVIEW
3
speaker.
OPERATION
Connecting Your Bluetooth Enabled Device
• To connect one earbud to your device:
o Press and hold the Multifunction Button. Release the
button and red and blue lights will begin alternately
flashing.
o Unlock your phone and make sure Bluetooth is turned
on.
o Choose the earbuds from the list of nearby Bluetooth
devices.
o After the connection is successful, you can listen to
music or make a phone call.
• To connect both earbuds to your device:
o Press and hold the Multifunction Button on both earbuds.
Then, double click both buttons to enter the Bluetooth
pairing state. The red and blue light will begin flashing.
When the connection is successful, the blue light will
slowly blink.
• Calls are only supported when you are using both earbuds.
However, shutdown, play, and pause functionality can be
made when either or both earbuds are connected.
Using Bluetooth for Calls
• Calls are only supported when you are using both earbuds.
However, s
hutdown, play, and pause functionality can be
made when either or both earbuds are connected.
4
• To answer an incoming call using your earbuds, briefly press
the Multifunction Button.
• To reject or hang up a call, quickly tap the Multifunction
Button twice.
• To redial the last number that called you, tap the
Multifunction Button twice while in standby mode.
• When the earbuds are turned on and connected to a
Bluetooth enabled device, you can stream media to your
earbuds.
• To play/pause music, briefly click the Multi
once.
Using Bluetooth for Music
function Button
• When you’re done using the earbuds, press and hold the
Multifunction Button to turn them off.
• When your earbuds are low on power, you will hear a low
power prompt. To charge them, put them in the charging
case and make sure the case is turned on. When the True
Wireless Earbuds are fully charged, the red light on the
Wireless Power Indicator will turn blue.
Power Off
Charging
5
Choosing A Language
Wireless Version
V4.2
Frequency Response
20-20000Hz
Working Range
10M
Battery Capacity
Internal rechargeable lithium-ion
Standby Time
About 100hrs if one earbud is in
use/ 60hrs if both are in use
Continuous Working Time
Using one earbud: 5-6hrs
Using both earbuds: 4-5hrs
• When both earbuds are in pairing mode, press and hold the
Multifunction Buttons. Follow the instructional prompts to
choose between English or Chinese.
SPECIFICATIONS
battery (Earbud 45mAh /Case
300mAh)
WARNING
Do not place metal between your earbuds & the charging
element in the Charging Case, including but not limited to:
phone cases, metal brackets for magnetic mounts, magnets,
phone grip rings, keys/ key rings, coins & paper clips
6
.
SUMMIT ELECTRONICS LLC ONE YEAR LIMITED WARRANTY
SUMMIT ELECTRONICS LLC LIMITED WARRANTY (“Warranty”) ― For Product
Categories Listed in Chart Below (as applicable, “Product”) Before returning
your Product for service under this Warranty, please (i) read the instruction
manual carefully. If you are still having trouble with your Product, please contact
Technical Support at support@summitcegroup.com
Warning: Some Products may contain components that are small enough to be
swallowed. Please keep out of reach of children.
Subject to the terms and conditions herein, SUMMIT ELECTRONICS LLC
(hereinafter called “
of the Product (“Customer”) that for the applicable Warranty Period listed below,
the Product will be free from defects in material or workmanship under normal,
non-commercial use (“Defects”). Warranty Period encompasses, as listed
below, separate “Coverage Periods” for Parts and Labor, each Coverage Period
for one year, to begin from the original date of Customer purchase. If Customer
Product (or, as applicable, any component thereof) or (ii) replace the Product
(or, as applicable, any component thereof) with a new or refurbished Product
(or, as applicable, any component thereof), in either case free of charge to
Customer for Parts and/or Labor (as
Period only, and excluding applicable shipping charges (noted below), for which
the Customer is responsible. The foregoing states the Customer’s exclusive
remedy and SUMMIT ELECTRONICS LLC’s sole liability for breach of the limited
warranty contained herein.
component thereof) that has been subject to or Defects resulting from: (a) any
neglect or misuse
of operating instructions for the Product, any other Customer-induced damage,
or the alteration or removal
or repair to Product (or, as applicable, any component thereof) by any party
other than
ELECTRONICS LLC
thereof) due to power surges, incorrect electrical voltage,
device, or malfunction of any device used with the Product (or, as applicable,
any component thereof); (d) cosmetic damage to the Product (or, as
any component thereof) caused by normal wear and tear; (e) shipping damage
that occurs while the Product is in transit; (f) damage caused by heat sources,
SUMMIT ELECTRONICS LLC”) warrants to the original purchaser
SUMMIT ELECTRONICS LLC
by a Customer, an accident, improper application, violation
SUMMIT ELECTRONICS LLC or a party authorized in writing by SUMMIT
; (c) any damage to Product (or, as applicable, any component
misconnection to any
applicable,
7
sunlight, electromagnetic conditions, or other climatic conditions; or (g) any acts
of God. Product is sold to Customer for personal, non-commercial use only.
Product is
not warranted for Customer’s commercial or rental use.
In addition, Product is not warranted against failure, and should not be used by
Customer for any application
Product will be breached or otherwise compromised, or (ii) the data stored on
Product is relied upon for medical or
SUMMIT ELECTRONICS LLC disclaims any Warranty for any of the foregoing uses
fullest extent permitted by law. Customer assumes any and all risks
to the
associated with such uses of Product, and agrees to indemnify SUMMIT ELECTRO-
NICS LLC
for any damages claimed against SUMMIT ELECTRONICS LLC for such uses.
EXCEPT FOR EXPRESS
MAXIMUM EXTENT PERMITTED BY LAW, THE PRODUCTS ARE PROVIDED
“AS IS”, AND
INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTY (I) OF
MERCHANTABILITY, (II) OF FITNESS FOR A PARTICULAR PURPOSE,
OR (III) OF NON-INFRINGEMENT OF THIRD PARTY RIGHTS. TO THE
MAXIMUM EXTENT PERMITTED BY
SUMMIT ELECTRONICS LLC BE LIABLE TO CUSTOMER OR ANY THIRD
WILL
PARTY FOR ANY INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL,
EXEMPLARY OR PUNITIVE DAMAGES, INCLUDING, WITHOUT LIMITATION,
ANY LOST PROFITS OR REVENUES, LOSS OR INACCURACY OF ANY
DATA OR COST OF SUBSTITUTE GOODS, REGARDLESS OF THE THEORY
OF LIABILITY (INCLUDING NEGLIGENCE) AND EVEN IF
LLC
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES,
SUMMIT ELECTRONICS LLC’S AGGREGATE LIABILITY TO CUSTOMER FOR
ACTUAL DIRECT DAMAGES FOR ANY CAUSE WHATSOEVER SHALL
BE LIMITED TO THE CUMU
CUSTOMER FOR THE PRODUCT CAUSING THE DAMAGES, IF ANY. This
rights that vary from jurisdiction to jurisdiction. To obtain Warranty service,
Customer must email
a Product return. Customer must include with Product return the following items
(failure to enclose any of these items may result in a delay in the processing
of your Warranty claim): (i) a dated sales receipt that indicates the place of
purchase,
model number of Product, and amount paid; (ii) a detailed description
of Customer’s problem with Product; (iii) Customer’s full name, phone number,
and return
address, and; (iv) a money order made out to SUMMIT ELECTRONICS LLC
Electronics Corporation to cover return shipping charges to US destinations
only, for the applicable dollar
SUMMIT ELECTRONICS LLC will not make return shipments to a P.O. Box. For
shipping to international addresses, actual freight will
Return your Product freight-prepaid in its original packaging, or packaging
where (i) there is a risk that any data stored on
lifesaving applications.
WARRANTIES STATED ABOVE AND TO THE
SUMMIT ELECTRONICS LLC DISCLAIMS ALL OTHER WARRANTIES,
APPLICABLE LAW, IN NO EVENT
SUMMIT ELECTRONICS
LATIVE PRODUCT FEES PAID BY THAT
SUMMIT ELECTRONICS LLC Technical Support prior to making
amount shown for the Product in the table above.
be charged to Customer.
8
processing of your claim (6 to 8 weeks from November to February).
PRODUCT CATEGORY
Adapters, Converters, Chargers, Headphones,
Microphones, Cellular Accessories
Alarm Clocks, Portable CD Players, Radios, Corded
Telephones, MP3 Players, Digital Photo Frames
(screen size less than 5”)
Portable Stereo Systems, Speaker Systems,
Cordless Telephones, Home DVD Players
Home Theater DVD Systems, Portable DVD
Players, Portable Media Players, Digital Photo
Frames (screen sizes 5” to 11”)
You must email
return. Please ask if you are unsure of which category your product falls under
*US destinations only.
SUMMIT ELECTRONICS LLC Technical Support prior to making a
Contact Us at
support@summitcegroup.com
For Return Information
SHIPPING*
(USD)
$7.99
$7.99
$14.99
$21.99
9
Loading...