Summit SP6DS2D7MEDDT, SP6DS2D7MEDDTADA, SP6DSSTB7MEDDT, SP6DSSTB7MEDDTADA User Manual

SAFETY DATA SHEET

Propylene Glycol

1.1 Product identifier
Product Name: Propylene Glycol

Product Codes(s):
Synonyms:
REACH Registration Number:

1.2 Relevant identified uses of the substance or mixture and uses advised against
General Use:
Uses advised against:

1.3 Details of the supplier and of the safety data sheet
Manufacturer/Distributor

Allan Chemical Corporation

Allan Chemical Corporation
235 Margaret King Avenue

235 Margaret King Avenue
Ringwood, NJ 07456 USA

Ringwood, NJ 07456 USA
[phone]

1.4 Emergency telephone number

Chem Tel Contract # MIS0000288
[phone]
[phone]

Propylene Glycol

1,2-Dihydroxypropane; Methylene glycol; Monopropylene glycol; 1,2-Propylene glycol; 1,2-Propanediol; 2-Hydroxypropanol.

Material for use in industrial and commercial formulation applications

SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION

No data available

None known

SECTION 2 - HAZARDS IDENTIFICATION

2.1 Classification of substance or mixture

Product definition:

Classification (Regulation (EC) No 1272/2008)

None allocated

2.2 Label Elements

Labeling (Regulation (EC) No 1272/2008)

Hazard Symbol(s):

Signal Word:

Hazard Statement(s):

Substance

None allocated
None allocated

None allocated

SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS

3.1 Substances

% by Weight

>99

There are no additional ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified
as hazardous to the health or the environment and hence require reporting in this section.

3.2 Mixtures
Chemical characterization (preparation)

Not applicable

Ingredient

Propylene Glycol

CAS Number

57-55-6

EC Number

200-338-0

Index Number

------------

EC Classification

------------

SECTION 4 - FIRST AID MEASURES

4.1 Description of first aid measures

Inhalation:

difficult or irregular, administer oxygen; if respiratory arrest occurs, start artificial respiration by trained personnel. Loosen tight fitting clothing
such as a collar, tie, belt or waistband. If symptoms persist, seek medical attention.

Eyes: Immediately flush eyes with large amounts of water for 15 minutes, occasionally lifting the upper and lower lids. Remove contact lenses,

if present and easy to do, after the first 2 minutes and continue rinsing. If irritation persists seek medical attention, preferably from an
ophthalmologist.

Skin:

contaminated clothing and shoes thoroughly before reuse. If irritation occurs or persists, seek medical attention.

Ingestion:

do so by medical personnel. Never give anything by mouth to an unconscious person. If victim feels unwell, obtain medical attention.

4.2 Most important symptoms and effects, both acute and delayed
Potential health symptoms and effects
Eyes:
Skin:

If product mist or vapor causes respiratory irritation or distress, move the exposed person to fresh air immediately. If breathing is

Flush skin with large amounts of water while removing contaminated clothing and continue rinsing for at least 15 minutes. Wash

Rinse mouth thoroughly with water if the victim is conscious. Remove dentures, if present. Do not induce vomiting unless directed to

May cause mild, transient eye irritation. Mist may cause eye irritation.

Not expected to cause skin irritation.

Propylene Glycol

ALLAN CHEMICAL CORPORATION

Page 1 of 6

Inhalation:
Ingestion:
Chronic:

4.3 Indication of any immediate medical attention and special treatment needed
Advice to Doctor and Hospital Personnel:

Not expected to cause irritation of the respiratory tract.
Very low toxicity if swallowed. May cause digestive upset when ingested in large quantities with nausea, vomiting and diarrhea.

None known

Treat symptomatically and supportively.

SECTION 5 - FIRE FIGHTING MEASURES

5.1 Extinguishable media
Suitable methods of extinction:
Unsuitable methods of extinction:

5.2 Special hazards arising from the substance or mixture

Closed containers may explode due to the buildup of pressure when exposed to extreme heat. During emergency conditions overexposure to
decomposition products may cause a health hazard. Symptoms may not be immediately apparent. Obtain medical attention.

Explosion hazards:

5.3 Advice for firefighters

Full protective equipment including self-contained breathing apparatus should be used. Water may be used to cool closed containers to prevent
pressure buildup and possible autoignition or explosion when exposed to extreme heat. Burning liquids may be moved by flushing with water to
protect personnel and minimize property damage. If possible, water contaminated by this material should be contained from being discharged to
any waterway, sewer or drain to prevent environmental contamination.

Not considered to be explosion hazard.

Water fog, water spray, carbon dioxide, dry chemical and alcohol-resistant foam.

Water jets or direct water streams may spread fire.

SECTION 6 - ACCIDENTAL RELEASE MEASURES

6.1 Personal precautions, protective equipment and emergency procedures

Wear all appropriate protective equipment designated in Section 8. Remove all sources of ignition. Ventilate the area.

6.2 Environmental precautions

Avoid dispersal of spilled material or runoff and prevent contact with soil and entry into drains, sewers or waterways.

6.3 Methods and materials for containment and cleaning up

Cover drains and contain spill. Cover with a large quantity of inert absorbent. Do not use combustible material such as saw dust. Shovel or
sweep up product and place into an approved container for proper disposal. Observe possible material restrictions (Sections 7.2 and 10.5).
Dispose of waste via a licensed waste disposal contractor.

6.4 Reference to other sections

See Section 13 for additional waste treatment information.

SECTION 7 - HANDLING AND STORAGE

7.1 Precautions for safe handling

Wear all appropriate personal protective equipment specified in Section 8. Do not get in eyes or on skin or clothing. If normal use of material
presents a respiratory hazard, use only adequate ventilation or wear an appropriate respirator. Wash contaminated clothing and shoes before
reuse.

Advice on protection against fire and explosion

Material does not present a fire or explosion hazard.

7.2 Conditions for safe storage, including any incompatibilities

Store in a dry, cool and well-ventilated area, away from incompatible materials (see Section 10.5), food and drink. Store away from direct sunlight
or ultraviolet light. Transfer only to approved containers having correct labeling. Keep container tightly closed to prevent moisture absorption.
Protect containers against physical damage. Containers that have been opened must be carefully resealed and kept upright to prevent leakage.
Containers may be hazardous when empty as they contain product residues. Use appropriate containment to avoid environmental contamination.
Ventilate closed areas. Do not take internally. Keep out of reach of children.

7.3 Specific end uses

Apart from the uses mentioned in Section 1.2, no other specific uses are stipulated.

SECTION 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION

8.1 Control parameters

CAS Number

57-55-6

8.2 Exposure controls
Engineering Measures:

equipment. Use adequate ventilation. Local exhaust is preferable. Refer to Section 7.1 for additional data.

Individual protection measures:

selected specifically for the workplace, depending on concentrations and quantities of hazardous substances handled. The chemical resistance
of the protective equipment should be enquired at the representative supplier.

Hygiene measures:

clothing. Preventive skin protection is recommended. Wash hands thoroughly after use, before eating, drinking or using the lavatory.

Eye/face protection:

ANSI Z87.4 or Standard EN 166.

Ingredient

Propylene Glycol

Technical measures and appropriate working operations should be given priority over the use of personal protective

Wear protective clothing to prevent repeated or prolonged contact with product. Protective clothing needs to be

Facilities storing or using this material should be equipped with an eyewash station and safety shower. Change contaminated

Wear protective goggles or safety glasses with non-perforated side shields and a face shield. Refer to 29 CFR 1910.133,

10 mg/m3 TWA (aerosol only);

50 ppm; 155 mg/m3 TWA (aerosol & vapor)

OSHA PEL

ACGIH TLV

------------

NIOSH

------------

Propylene Glycol

ALLAN CHEMICAL CORPORATION

Page 2 of 6