Sub-Zero 9011615, 9011700 Installation Guide

CONTENTS

2 Panel, drawer

2 Trim, cabinet side

1 Assembly, lock

1 Shim, plastic 3/32"

1 Shim, plastic 1/4"

1 Bracket, center

1 Pocket, lock

2 Washer

2 Nut

16 Screw, #8 x 32 x ½"

ID-24RO Stainless Steel Panel Installation

subzero.com 800.222.7820

Install the remaining cabinet side trim using the existing

6

screws, then loosely secure to the center bracket stud
with a washer and a nut.

ID-24RO STAINLESS STEEL PANEL INSTALLATION

For panels without a lock, proceed to step 14.

1

Remove both drawers.

2

Remove the existing side mounting brackets.

3

Install one of the new cabinet side trims using the

4

existing screws. The mounting stud on the side trim
should align with the bottom of the center mullion.

Place the center bracket onto the mounting stud, then

5

loosely secure with a washer and a nut.

Install the upper drawer.

7

Place the 3/32 plastic shim above the center bracket

8

and below the upper drawer.

Move the center bracket up or down to achieve proper

9

spacing, then tighten both nuts to secure each side of
the bracket.

Discard the shim.

10

Install the bottom drawer.

11

9012313 REV-A 12/2016

Page 1 of 2

*9012313$REVA*

ID-24RO Stainless Steel Panel Installation

subzero.com 800.222.7820

Remove the paper backing from the lock pocket, align

12

it with the square holes and the slot in the lower panel,
then press to secure.

Install the lock assembly on the upper panel, then use

13

the key to verify the cam rotates downward.

Pull both drawers out slightly, then place the 1/4" shim

17

between the upper and lower drawer panels.

To make panels adjustments, refer to the Integrated

18

Refrigeration Installation Instructions.

Verify the operation of the lock, then discard the shim.

19

Align the trim with the bracket on the side of the drawer

20

and snap into position.

Partially insert a screw in the center hole on each side

14

of the top set of holes for each panel.

Open the drawers and use the positioning screws to

15

support and align the panels with the mounting
brackets on each side of the drawer.

Install and secure the remaining screws through the

16

brackets and into the panels.

Page 2 of 2