Sub Zero 7040426, 7040181 Installation

Humidor Installation

subzero.com 800.222.7820

CONTENTS

1 Rack

1 Humidor

1 Hygrometer

2 Package, 84 percent humidity

12 Package, 72 percent humidity

INSTALLATION

1 Determine the desired location of the humidor and

remove the existing wine rack. To remove, pull out to full
extension, tilt up, then lift up and out.

2 To install the humidor rack, place the back of the rack

into the slides then rotate the front down until it engages
the slides.

Remove wine rack

Install humidor rack

3 Remove humidor from packaging then place it on the

humidor rack between the front and rear retainer wires.

4 Remove hygrometer from box and place inside the

humidor.

5 Remove the two 84% humidity packages from the box

and place inside the retainer. Position the humidor
dividers as needed, then close the lid.

RETAINER

Install humidity packages

6 After 14 days, remove and replace the 84% humidity

packages with two 72% humidity packages. Replace the
72% humidity packages every 2 months to maintain a
consistent humidity level.

7 Models IW-18, IW-24, IW-30 and IW-30R include a

humidity package replacement reminder (not available
on model BW-30). To activate the reminder, press
on the display panel. The reminder will appear after two
months. Select "Snooze" to delay the reminder for two
weeks, if desired.

9003462 REV-B 08/2015

NOTICE: Removing the humidor from the wine unit will
not maintain the appropriate humidity and may cause the
humidor to warp.

page 1 of 1