Sub Zero 7004855 Installation
7004855
Partial Framed Panel Kit
7012891 / Rev A / February, 2009
Page 1 of 1
Panels may have sharp edges which could inflict
serious personal injury. Use care when handling.
CONT
AINS:
QTY
DESCRIPTION
1 Refrigerator Partial Panel
1 Framed Transition Trim
7 Screws, #10-12 x 1/2 Truss HD
1 Instructions
PROCEDURE:
1. Remove glasswell grille, dispenser control panel
and the dispenser bezel from door (See Figure
3).
2. Remove screw cover by inserting a flat blade
screwdriver into channel of screw cover and push
cover towards the back, disengaging it from hanÂdle / handle-side trim (See Figure 1).
3. With a T-20, 6-lobe Torx type bit, extract handle /
handle-side trim mounting screws and pull trim
from the door (See Figure 2).
4. Install decorative refrigerator door panel onto door
(See Figure 3).
5. Remove blue laser film from transition trim, then
attach transition trim to door using the #10-12 x
1/2 truss head screws included in this package.
6. Remove white laser film from partial panel, then
install partial panel with enclosed chipboard
behind the partial panel.
7. Reinstall door handle / handle-side trim and
screw cover.
8. Reinstall bezel, dispenser control panel and
glasswell grille.
Decorative
Ref. Door
Panel
Handle-Side Trim
Grille
Control Panel
Bezel
Transition Trim
Screws (5)
Partial
Panel
Screw Cover
Figure 1. Screw Cover Removal
NOTE: With stainless steel panels, the white protecÂtive tape must be removed from front of panel before
installing.
SCREW COVER
HANDLE SIDE-TRIM
DOOR
HANDLE SIDE-TRIM
Figure 2. Handle / Handle-Side Trim Removal
Figure 3. Overall View of Accessory Kit
Loading...