Sub Zero 7003464, 7003463, 7023376 Installation
Extended Handles
(7003462, 7003463, 7003464, 7003465)
7004569 / Rev A / January, 2008
Page 1 of 2
CONTAINS:
QTY
DESCRIPTION
1 / 2 Door Handle Assembly
(in 7003462, 7003463, 7003464 / 7003465)
1 Drawer Handle Assembly
(in 7003463, 7003464)
1 Instruction Sheet (in All)
DOOR
SCREW COVER
HANDLE
DOOR HANDLE PROCEDURE:
1. Remove the Screw Cover from the Handle
At the top of the door, insert a flat blade screwdriver into channel of the screw cover and push the
cover away form the handle so that it disengages
from the handle (See Figure 1).
2. Remove the Existing Handle from the Door
With a T-20, 6-lobe Torx type bit, extract the handle mounting screws and pull the handle from the
door (See Figure 2).
3. Install the Extended Handle on the Door
Place the extended handle against the side of the
door, then use a T-20, 6-lobe Torx type bit to insert
the handle mounting screws and secure the handle to the door (See Figure 3).
4. Reinstall the Screw Cover
Line up the the screw cover with the handle and
push it toward the handle so that it engages the
handle clips, working it into position from bottom to
top, or top to bottom (See Figure 4).
Figure 1. Screw Cover Removal
HANDLE
Figure 2. Handle Removal
DOOR
SCREW COVER
EXTENDED
HANDLE
Figure 4. Screw Cover Installation
EXTENDED
HANDLE
Figure 3. Handle Installation
Extended Handles
(7003462, 7003463, 7003464, 7003465)
7004569 / Rev A / January, 2008
Page 2 of 2
SCREW COVER
HANDLE
DRAWER HANDLE PROCEDURE:
1. Remove the Screw Cover from the Handle
At the back right-hand side of the drawer handle,
insert a flat blade screwdriver into the notch in the
screw cover and pry the cover away form the handle, disengaging it from the handle (See Figure 5).
2. Remove the Existing Handle from the Drawer
With a T-20, 6-lobe Torx type bit, extract the handle mounting screws and pull the handle from the
drawer (See Figure 6).
3. Install the Extended Handle on the Drawer
Place the extended handle against the top of the
drawer, then use a T-20, 6-lobe Torx type bit to
insert the handle mounting screws and secure the
handle to the drawer (See Figure 7).
4. Reinstall the Screw Cover
Line up the the screw cover with the handle and
push it toward the handle so that it engages the
handle clips, working it into position from left to
right, or right to left (See Figure 8).
Figure 5. Screw Cover Removal
DRAWER
HANDLE
Figure 6. Handle Removal
SCREW COVER
EXTENDED
HANDLE
Figure 8. Screw Cover Installation
DRAWER
EXTENDED HANDLE
Figure 7. Handle Installation
Loading...