Sub Zero 7003409, 7003408 Installation

Metal Side Panel (with Optional Base Cover)

7015550 / Rev A / February, 2010

Page 1 of 3

CONTAINS: QTY DESCRIPTION

1 Panel Assembly, Side
2 Bracket, Side Panel (rear)

Figure 1. Reposition Lower Front Bracket (Over / Under Models Only)

IMPORTANT NOTE: When a side panel
is to be mounted on the hinge side of an
over / under model, it will be necessary to
reposition the lower front bracket down to
the bottom mounting position in order to
avoid interference between the lower
bracket and the lower hinge plate.
(See Figure 1)

QTY DESCRIPTION

6 Screw, #10X3/4 Drill PH Hex Wash
1 Cover, Base
1 Instruction Sheet

REPOSITION
LOWER FRONT
BRACKET TO
BOTTOM
POSITION

LOWER
HINGE PLATE,
OVER / UNDER
MODELS ONLY

Metal Side Panel (with Optional Base Cover)

7015550 / Rev A / February, 2010

Page 2 of 3

NOTE: Side panels and base cover must be installed before the unit is placed in its final position.

ATTACH REAR SIDE PANEL BRACKETS TO BACK OF UNIT:

1. Align mounting holes of brackets with pre-punched locator holes along back side edge of unit, making sure
bracket hooks are facing up and outward.

2. insert the #10X3/4 Drill PH Hex Washer Screws through the bracket mounting holes (two each bracket), then
use a power driver with a Phillips or 5/16” Hex bit to drive the screws into the pre-punched locator holes.

NOTE: It is not necessary to drill holes into the back of the unit in order to mount the brackets. It should be
possible to push the screw tips through the unit shell while spinning the screws clockwise with a power driv­er. If a drill bit is used, be sure it is a 1/8” (3 mm) drill bit, but do NOT penetrate deeper than 3/4” (19 mm).

3. Attach optional base cover to side of unit base at this time. it has a magnetic back and can be adjusted after
the unit is installed.

Figure 2. Attach Rear Side Panel Brackets

SIDE PANEL
BRACKET
(REAR)

BASE COVER
(OPTIONAL)