Subaru H7110FS300 User Manual
INSTALLATION
REMOTE KEYLESS
ENTRY SYSTEM
INSTRUCTIONS
Kit Contents:
1 Keyless Entry Control Module w/Integral Bracket
2 Remote Control Transmitters
1 Installation Manual
FORESTER
P/N: H7110FS300
Tools Required:
#1 Flat-tip Screwdriver
#2 Phillips Head Screwdriver (short)
1
/4” Drive Ratchet
1
4-inch
1
/4” Swivel
10 mm Socket
This device complies with FCC rules part 15. Operation is
subject to the following two conditions: (1) this device may
not cause harmful interference and (2) this device must
accept any interference that may cause undesired operation.
/4” Drive Extension
1
99.11
UT27T-11
Printed in Japan
A. Pre-Installation Notes
1. Vehicle Preparation
a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle during
installation.
b. Note and record station presets on radio for step #2 in section E. Finish the Installation.
c. Disconnect negative battery terminal to prevent accidental shorting of any power circuits.
2. System Preparation
Remove the keyless module and transmitters from the package and inspect for any physical damage.
B. Installation
1. Remove one plastic screw and two metal screws indicated by the arrows in Figure 1. Remove the lower dash
panel by pulling the upper side of the lower dash panel
toward you.
2. Disconnect four harnesses (two white housings, one
brown housing and one black housing) on the lower
dash panel. Then completely remove the lower dash
panel.
NOTE: To detach the black housing, insert a slotted
screwdriver as shown in Figure 2 and lift up
the black housing. The black housing can be
detached easily.
Figure 1
Figure 2
2
Loading...