IMPORTANT: HUBODOMETER®MUST BE ACCURATELY CENTERED ON WHEEL.
Installation Instructions
®
for STEMCO Hubodometer
-
Rear Wheel Truck or Bus Mount
Part Numbers 610-0011 and 610-0025
1. Drill two 3/16" holes on each end of mounting strap (#1) at marks corresponding to bolt circle diameter
of rear wheel axle (#2).
2. Open single hole in support angles (#3) if necessary to fit axle studs or bolts.
3. Cut and trim strap 3/8" beyond rivet holes on both ends.
4. Assemble angles (#3) to mounting strap (#1) as per drawing, using 4 rivets (#4) supplied. Trim angles to conform
to contour of axle if necessary.
5 IMPORTANT: Place washer (#7) on Hubodometer
6. Mount Hubodometer
used to hold Hubodometer
15 ft/lbs torque.
7. Mount strap assembly to axle.
8. To clean Hubodometer
®
(#6) on strap using 1/2" locknut (#5) supplied. It is recommended that a strap wrench be
®
while tightening. Do not clamp Hubodometer®flange in a vise. Do not exceed
®
face, use a damp cloth to prevent scrathes. Do not use solvents, paints or thinners.
®
stud.
ISO 9001:2000 & ISO/TS 16949
STEMCO-USA • P.O. Box 1989 • Longview, TX 75606-1989
(903) 758-9981 • 1-800-527-8492 • FAX: 1-800-874-4297 • www.stemco.com
STEMCO-CANADA • 5900 Ambler Drive, Units 4 & 5 • Mississauga, ON L4W 2N3
(905) 206-9922 • 877-232-9111 • FAX: 877-244-4555
STEMCO and Hubodometer are registered trademarks of STEMCO LP ©2005 STEMCO LP.
Printed in the USA
(Hudson 10-491) 09-611-0036
Rev. 07-05
Loading...