Self-Cleaning Commercial Gas Water Heater - SBD Models
Sandblaster® is the original money-saving self-cleaning water heater. It provides outstanding performance and
installation flexibility for new construction and replacement applications. The Sandblaster SBD series offers
installer-friendly features, including compact low-profile design, multiple options for water connections and
low installation clearances.
Self-Cleaning Hydro Cannon™
• Significantly reduces sediment buildup inside the tank
• Maintains rated thermal efficiency, reduces water heating costs
• Maximizes tank life
Automatic Flue Damper (120 - 390 Models)
• Automatic motorized flue damper helps minimize standby heat loss
• Low-profile draft diverter helps for installation in tight spaces
• SBD85 500 Model features induced draft design and no damper
Three Water Connection Options
• Hot and cold water connections can be made through front, top or rear
of unit
• Hydro Cannon™ operates when cold water is connected through front
Low Lead Content
Hydro Cannon
Intermittent Electronic Ignition
• Eliminates standing pilot, saves energy
• Includes power ON/OFF switch
• Provides flame failure response in less than one second
Glasslined Tank with Multiple Anode Rods
• Provides outstanding protection against corrosion
CSA Certified and ASME Rated T&P Relief Valve, Factory-Installed
Maximum Hydrostatic Working Pressure 160 psi
80% Thermal Efficiency
Meets the Thermal Efficiency and Standby Loss Requirements
of the U.S. Department of Energy and Current
Edition of ASHRAE/IESNA 90.1
• Design-certified by Underwriters Laboratories (UL), according to
™
ANSIZ21.10.3-CSA 4.3 standards governing storage-type water heaters
• Design-certified by Underwriters Laboratories Sanitation to NSF Standard 5
for 180°F (62°C) water
• Optional ASME tank construction available
Three-Year Limited Tank Warranty
• For complete warranty information, consult written warranty shipped with
water heater or contact State Water Heaters
For more information on Sandblaster® contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800-365-0024 Toll-free USA
www.statewaterheaters.com
SCGSS01006 Revised July 2012
COMMERCIAL
®
SANDBLASTER
Self-Cleaning Commercial Gas Water Heater - SBD Models
Other Sandblaster® Features
Fully Automatic Control System
• Manual-reset gas shut-off device prevents excessive water temperature
• Adjustable thermostat with 120º - 180º range
• Gas pressure regulator and pilot filter
Handhole Cleanout
• Allows easy access to tank interior for cleaning
Plug Kits
• Pipe nipples and caps included to plug unused water connections
Sandblaster® Options
Manifold Kits for Multiple Heater Installations
2-unit kit, Part Number 9003426205
3-unit kit, Part Number 9003427205
4-unit kit, Part Number 9003428205
Optional Leg Kit to Meet NSF Standard 5
For all SBD models, Part Number 9003425205
Side Wall Power Venting Kits
For SBD71 120NE through SBD100 199NES, Part Number 9006015005
For SBD100 250NE through SBD100 390NE, Part Number 9006016005
For installation of approved power venter to operate in conjunction with water heater thermostat
Field wiring should conform to latest version of the National Electric Code ANSI/NFPA No. 70
For more information, consult manual shipped with water heater or contact the State Water Heaters
Technical Support Center at 1-800-365-0024
WATER CONNECTIONS IN INCHES
TOP INLET AND OUTLET
FRONT INLET AND OUTLET1-1/2" on all models except 2” on SBD100 199NES,
SBD100 250, SBD100 275 and SBD 100 390
BACK INLET AND OUTLET
1-1/2" on all models except SBD65 251 and
snoitcennoc pot htiw deppiuqe ton ,503 56DBS
1-1/2" on all models except 2" on SBD100 199NE,
SBD100 250, SBD100 275 AND SBD100 390
(Natural or Propane) gas water heater(s) shall be State Sandblaster® model # _____________ or equal, with a storage capacity of __________
gallons, an input rating of ___________________ BTUs per hour, a recovery rating of _________ GPH at 100ºF rise and a maximum hydrostatic
working pressure of 160 psi. Water heater(s) shall be protected against overheating caused by the buildup of scale, film and other sediment
by a self-cleaning device, positioned inside the tank so that it directs the flow of inlet water to keep precipitated solids in suspension so
that they are removed from the water heater on that or successive draws. Glasslined water heater(s) shall also be protected against
electrolytic corrosion by multiple factory-installed anode rods. In addition, water heater(s) shall: 1) Be equipped with an integrated control
system consisting of a 180ºF adjustable thermostat with upper and lower sensing bulbs. 2) Be equipped with intermittent electronic
ignition, a manual reset gas shutoff device, a gas pressure regulator, factory-installed CSA Certified and ASME Rated T&P Relief valve and
2-3/4" x 3-3/4" tank inspection port. 3) Be design-certified by Underwriters Laboratories under Volume III tests for commercial water
heaters for delivery of 180º water. 4) Be design-certified by UL (Underwriters Laboratories) to current edition of ANSI Z21.10.3 - CSA 4.3
standards governing storage-type water heaters. 5) Meet the thermal efficiency and standby loss requirements of the U.S. Department of
Energy and Current Edition of ASHRAE/IESNA 90.1. 6) Have a 3-year limited warranty as outlined by manufacturer.
For complete information on limited warranties, consult written warranty,
or contact the State Customer Care Center, 1-800-365-0024.
State Industries, Inc. reserves the right to make product changes or improvements without prior notice
.
For more information on Sandblaster® contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800-365-0024 Toll-free USA
www.statewaterheaters.com
SCGSS01006 Revised July 2012
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.