Sta-Rite TMR-LX Installation Manual

SYSTEM START-UP

INSTALLATION

INSTRUCTIONS

Apply power to the system.
At the LX-30 Power Center, check that the POWER Status Light has turned on.

If the status light is not on, check the 3 amp circuit breaker which is located above
the faceplate. Tripped circuit breaker is indicated by a white tab. Push to reset.

Turn the FILTER PUMP Service Switch "ON" and "OFF to verify that pump is
operating.
Return FILTER PUMP Service Switch to "TIMER" position, and activate filter
7ump using the FILTER TIMER Dial.

t

the system incorporates a pool cleaner pump, activate pump using the

CLEANER TIMER Dial.
At the Remote Control, turn SPA Switch to "SPA position.

Check that Valve Actuators have rotated to correct positions. If either valve is

180" out of phase, flip toggle switch on rear of Valve Actuator from

"ON2" position.
Turn HEAT Switch to "SPA position, and check that heater has been activated.

AUXl and AUX2 Switches "ON", and verify that auxiliary equipment has

Turn
been activated.

The system is now ready to be operated as desired.

"ON1" to

CP30 POOL-SPA SWITCHING SYSTEM

IMPORTANT SAFETY INSTRUCTIONS

All wiring must be performed by a qualified electrician.

Basic safety precautions and local codes should

always be followed when installing and using this

electrical equipment.

a

Cornpool,

599

Fairchild

Mountain

California

Inc.

Drive

View

94043

800-458-2201

http

://www.c0mpo01.com

PAC FA6 Company

READ AND FOLLOW ALL INSTRUCTIONS.

WARNING

permit children to use this product unless they are

:

To reduce the risk of injury, do not

closely supervised at all times.

SAVE THESE INSTRUCTIONS.