Tagelus® Sand Filter
with ClearPro Technology™
By Pentair Pool Products
®
Now with new, exclusive, patented technology
that dramatically improves water clarity
Traditional sand filters can only remove particles in the 50–100 micron range,
but Tagelus® sand filter with ClearPro Technology™ removes particles up to five
times smaller…well below what your eye can detect. And that’s the difference
between a clean pool and one that truly sparkles with clarity.
The secret is a proprietary component inside the filter—an exclusive porous
tube water must pass through before re-entering your pool. It creates a final
barrier to the small par ticles sand cannot stop, including the finest dust particles,
algae, and pollens. The result is a level of water clarity never before possible. In
fact, Tagelus with ClearPro Technology achieves the same water clarity as
legendary diatomaceous earth (D.E.) filters.
At the same time, Tagelus remains the blissfully simple filter that requires less
maintenance than either cartridge or D.E. f ilters. Just an occasional backwashing
with the turn of a valve is all it takes to keep Tagelus delivering the clearest water
year after year.
Traditional Sand Filter Tagelus with ClearPro Technology
Illustrating the Difference
The graphics above illustrate, in a technically accurate way, the
difference when ClearPro Technology is at work—far superior
water clarity. The difference is particularly dramatic at night
when pool lights can highlight particles in the water—not so
when ClearPro Technology is on the job.
Tagelus® Sand Filter
with ClearPro Technology
™
Six-position Hi-Flow
easy control of all filter functions:
l
Filter
l
Backwash
l
Rinse
Exceptionally strong one-piece fiberglass
reinforced tank with UV-resistant surface
finish for years of service
Model Filter Vertical* Filter Required Flow Rate GPM Turnover Capacity (Gallons)
Number Area Sq. Ft. Clearance Diameter Sand
TA 60D CP 3.1 57" 24.5" 325 60 28,000 36,000 43,200
Maximum water clarity with
™
valve provides
l
Waste
l
Closed
l
Recirculate
†
(lbs.) Res.** 8hrs. 10hrs. 12hrs.
†
* Required clearance to remove the valve.
Use standard #20 silica sand.
** Maximum flow rate.
Maximum operating pressure is 50 psi.
minimal attention
Tagelus® filters have been installed in hundreds of thousands of pools
for two primary reasons. First is their consistency of performance over
time. Second, because they go about their work without making work
for you. With ClearPro Technology™, performance is dramatically
enhanced, but these same valued vir tues remain intact.
l
Tagelus filters provide years of service with only periodic
backwashing to remove trapped debris from the sand.
l
Easy does it. The six-position Hi-Flow™ valve has a manual air relief
valve and a sight glass to make inspection, routine maintenance and
operation fast, easy and always safe. Pressure gauge also included.
l
A special “diffuser” creates a uniform sand bed that consistently
traps more dirt without impeding the water ow or letting it race
through too fast—the result is more effective filtration and longer
times between backwashing.
l
Combination sand and water drain speeds servicing and winterizing.
l
All internal parts are threaded for fast and easy service.
l
One-year limited warranty. See warranty for details.
Available from:
www.pentairpool.com
Phone: 800-831-7133 Fax: 800-284-4151
pumps / filters / heaters / heat pumps / automation / lighting / cleaners / sanitizers / maintenance products
2/08 Part # P1-018
©2008 Pentair Water Pool and Spa, Inc. All rights reserved.