Stanton PRO-30 User Manual

PRO-30

PROFESSIONAL STEREO PREAMP MIXER

OWNER’S MANUAL

PRO-30

© 1999, Stanton Magnetics, LLC

Register this product online

@

www.stantonmagnetics.com

STANTON MAGNETICS, LLC

2821 Evans St. Hollywood, FL 33020 [phone]
Fax: [phone] [e-mail]

@

T RO U B LE S H O O TI N G

Thank you for making Next! your first choice in professional DJ mixers.

This new, innovative family of mixers has been developed with input from the profes­sional DJ community, bringing to the marketplace a previously unavailable, afford­able combination of user-friendly, functional design, rugged construction, and pro­fessional quality features.

Next! and your authorized Next! dealer are dedicated to your complete satisfaction
by offering benchmark service and support throughout the long life of your Next!
product.

Again, we appreciate your patronage, and look forward to many years of making
music together.

PLEASE READ CAREFULLY BEFORE USE OF THIS PRODUCT

FA I LU R E TO FO LLOW T H E I N ST RU C TI O N S P R I N TE D B E LOW M AY VO I D WA R R A N T Y

• Follow all security advice printed on your mixer

• When removing the unit's AC plug from the power source, grasp and pull the
plug, NEVER the cord itself!

• Avoid placing your mixer near heat sources, such as power amplifiers.

• When in use, place your mixer on a stable surface, away from vibration. Always
use care when carrying your mixer. Impact, or heavy vibration may compromise
the unit's mechanical integrity. The manufacturer is not responsible for damage
resulting from an impact, or misuse.

• When in use, place your mixer away from sources of hum or noise, such as
transformers, or electric motors.

• To prevent overheating, always provide your mixer with adequate ventilation
air space.

• Avoid stepping on your mixer's AC cord. Repeated compression of the cord
may lead to electrical shorting.

• To avoid damage due to AC voltage peaks, always disconnect your mixer from
the power source during electrical storms.

Problem

Excessive hum when using
phono source.

Low frequency hum while
operating source unit.

Pro g ram volume can’t be
adjusted with master vo l u m e
c o n t ro l .

No powe r.

The amplifier is turned up,
but there is no signal.

No signal in headphones.

Cause

Poor ground connection.

Loose cartridge/headshell
connection.

Poor AC source ground.
Loose input/output connec­tion. Shorted cable.

Amplifier or outboard gear
connected to the re c o rd out­put.

I m p roperly connected AC cord
or power line source not on

Faulty output connections

Improper level adjustment.

Improper connection.

Improper level or cue mix
settings.

Solution

Properly connect turntable
ground wire to mixer ground
terminal.

Check cartridge connection
to headshell. Check head­shell connection to tonearm.

Properly ground the AC
source. Check all input and
output connections for
s e c u re fit. Isolate and re p l a c e
the damaged cable.

Connect amplifier or outboard
gear to master output.

Properly connect AC cord to
AC power source. Turn powe r
o n .

Properly connect amplifier, or
outboard gear to mixer.

Properly set crossfader,
channel faders, gain con­trols, and input selector tog­gles.

Check headphone connec­tion to mixer. Tighten if nec­essary.

Adjust headphone level and
cue mix to the proper level
and channel settings.

• Your mixer contains no user-serviceable parts. The manufacturer is not
responsible for any damage or personal injury resulting from unauthorized
user-servicing or modifications. In addition, the warranty will be void if any
unauthorized service by the user is detected. Always return you mixer to an
authorized Stanton dealer for servicing.