Stanton M-201 Owners manual

PROFESSIONAL DJ MIXER

IMPORTANT SAFETY INSTRUCTIONS

1. Read these Instructions

2. Keep these Instructions

3. Heed all Warnings

4. Follow all Instructions

5. Do not use this apparatus near water

6. Clean only with dry cloth

7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators,
hear registers, stoves, or other apparatus (including
amplifiers) that produce heat.

9

. Do not defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has
two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.

11. Only use attachments/accessories specified by the
manufacturer.

12.
Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination to
avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when

unused for long periods of time.

14. Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug
is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally,
or has been dropped.

15. This appliance shall not be exposed to dripping or
splashing water and that no object filled with liquids such
as vases shall be placed on apparatus.

FEATURES

 3-band EQ w/ input GAIN control per channel.
 Power on/off muting.
 Long-lasting crossfader.

MIXER CONTENTS

4

2

6

13

3

1

5

11

10

9

12

7 8

1. Input fader - Controls individual source levels (channels) in the mix.

2. Input toggle switch - Selects which source will be active based on what you have connected to the
rear panel input section (phono/line).

3. Channel EQ - Adjusts the high, mid and low frequency levels of the input channels for good sound.

4. Channel Gain – Adjusts the pre-fader volume for cleaner sound.

5. Replaceable Crossfader - Achieves clean segues between the two input channels. "Hard left"
selects Channel 1. "Hard right" selects Channel 2. With the crossfader centered, both channels are
live. Use the crossfader for fast and seamless segues (fades) from one channel to the other.

Note: The crossfader is user replaceable in case of failure. Simply unscrew the two large screws
which hold it in place, lift it out and disconnect its cable. Re-attach the new crossfader and screw
the mounting plate back onto the unit - you’re back in business!

6. Mic Input Gain – Adjusts microphone input level.

7. Mic Input – Insert your Microphone with ¼” plug here.

8. Headphone Input – Insert in the ¼” plug for your headphones here.

9. Channel Cue / Cue Pan - Used to preview channel audio to your headphones. Listen here before
bringing up channel faders or moving the crossfader.

10. Headphone Level – Adjusts cue volume.

11. Master Level - Controls the overall output level.

12. Level Indicators – The dual LEDs indicators are used to indicate the master output level of channels
Right and Left.

13. Mic EQ – The mic channel include a two-band EQ with a range of +10dB to –10dB.