Stanley SIMPLE START BBC2CS Instruction Manual
1
SIMPLE START™
VEHICLE-TO-VEHICLE BATTERY BOOSTER
INSTRuCTION MANuAL
SIMPLE START™ AuMENTAdOR dE PRESIóN dE
BATERíA VEHíCuLO-A-VEHíCuLO
MANuAL dE INSTRuCCIóN
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.
CONSERVE ESTE MANUAL PARA FUTURAS CONSULTAS.
© 2011 Baccus Global LLC
Boca Raton, FL 33432
Customer Service: (877) 571-2391
BBC2CS
English page 3
Español página 9
16
BBC2CS_ManualENSP_080111.indd 16-1 8/1/2011 5:03:39 PM
GENERAL SAFETY WARNINGS AND INSTRUCTIONS
READ ALL INSTRUCTIONS
WARNING: Read all instructions before operating battery booster. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury.
SAFETY GUIDELINES / DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous situation which, if not
avoided, may result in property damage.
RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety precautions should always
be followed to reduce the risk of personal injury. Improper operation, maintenance or modification of
tools or equipment could result in serious injury and property damage. There are certain applications for
which tools and equipment are designed. Manufacturer strongly recommends that this product NOT be
modified and/or used for any application other than for which it was designed. Read and understand all
warnings and operating instructions before using any tool or equipment.
IMPORTANT SAFETY INSTRUCTIONS
• Avoid dangerous environments: don’t use appliances in damp or wet locations. Don’t use
appliances in the rain.
• Keep children away. All visitors should be kept at a distance from work area.
• Store idle appliances indoors. When not in use, appliances should be stored indoors in dry, and
high or locked-up place – out of reach of children.
• Don’t force appliance. It will do the job better and with less likelihood of a risk of injury at the rate
for which it was designed.
• Use right appliance. Do not use the appliance for any job except that for which it is intended.
• Don’t abuse cord. Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord
from heat, oil, and sharp edges.
• Disconnect appliances. Disconnect the appliance from the power supply when not in use.
• Use of accessories and attachments. The use of any accessory or attachment not recommended
for use with this appliance could be hazardous.
2
3
FEATURES
CARACTERÍSTICAS
FEATURES
1. Red Plug (connects to vehicle to be charged)
2 Power LED Indicator
3. Storage Cylinder
4. Charging LED Indicator
5. Black Plug (connects to host vehicle)
CARACTERÍSTICAS
1. Enchufe rojo (conecta con el vehículo que se
cargará)
2 Indicador de la energía LED
3. Cilindro del almacenaje
4. Indicador de carga verde del LED
5. Enchufe negro (conecta con el vehículo del
anfitrión)
5
1
2
4
3
BBC2CS_ManualENSP_080111.indd 2-3 8/1/2011 5:03:40 PM
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Follow these instructions
and those published by the manufacturer of any engine you intend to use with this battery charger.
Review cautionary markings on the battery charger and engine.
INTRODUCTION
Thank you for choosing the Simple Start™ Vehicle-To-Vehicle Battery Booster. This car to car
booster is an innovative product that replaces the use of inconvenient booster cables to jump-start a
car. All you need to do is to insert the Simple Start's black plug into the working car's 12 volt accessory
outlet and the red plug into the 12 volt accessory outlet of the car that needs to be boosted.
OPERATING INSTRUCTIONS
1. Insert the Black 12 Volt DC Accessory Plug into the 12 volt DC accessory outlet of the working car.
Rotate the plug slightly to make sure there is good contact. The power LED indicator will light
green.
Notes:
– Some vehicles require that the ignition key be turned to the Accessory position to activate the
12 volt DC Accessory Outlet.
– If the Power LED Indicator does not light, the Black 12 Volt DC Accessory Plug is not connected
properly to the working car's 12 Volt DC Accessory Outlet. Rotate the plug again to assure
good contact.
– If the Power LED Indicator lights solid red, the battery of the working car is in a fault
condition, such as low battery voltage, high battery voltage or overheated.
2. Insert the Red 12 Volt DC Accessory Plug into the 12 volt DC accessory outlet of the car to be
boosted.
Note: Turn OFF vehicle ignition and all accessories (radio, A/C, lights, connected cell phone
chargers, etc.); place vehicle in “park;” and set the emergency brake.
3. Rotate the plug slightly to make sure there is good contact. The Power LED Indicator will light
green and the Charging LED Indicator will flash red, indicating the charging process has begun.
Notes:
– Some vehicles require that the ignition key has to be on the Accessory position to activate the
DC Accessory Outlet.
– If the Charging LED Indicator does not light, the Red 12 Volt DC Accessory Plug is not
connected properly to the 12 Volt DC Accessory Outlet of the car to be boosted. Rotate the
plug again to assure good contact.
– If the Charging LED Indicator lights solid red, the battery of the car to be boosted is in a fault
condition.
5
Note:
Refer to the accessory section of this manual for further details.
• Stay alert. Watch what you are doing. Use common sense. Do not operate unit when you are tired.
• Check damaged parts. Before further use of the unit, a part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. A part that
is damaged should be properly repaired or replaced by manufacturer unless otherwise indicated
elsewhere in this instruction manual.
• Do not operate near flammable liquids or in gaseous or explosive atmospheres.
WARNING: BURST HAZARD: Do not use the unit for charging dry-cell batteries that are commonly
used with home appliances. These batteries may burst and cause injury to persons and damage
property. Use the unit for charging/boosting a LEAD-ACID battery only. It is not intended to supply
power to a low-voltage electrical system other than in a starter-motor application.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
• Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been
dropped, or otherwise damaged in any way. Do not disassemble the unit; take it to a qualified service
technician when service or repair is required.
• Never submerge this unit in water; do not expose it to rain, snow or use when wet.
• Make sure cord is located so that it will not be stepped on, tripped over or otherwise subjected to
damage or stress.
• Do not leave the unit unattended while attempting to boost a vehicle.
• This unit is not for use by children and should only be operated by adults.
• Pull the plug rather than the cord when disconnecting the unit.
• Never attempt to boost or charge a frozen battery.
• Vehicles that have on-board computerized systems may be damaged if vehicle battery is boosted.
Before boosting, read the vehicle’s owner’s manual to confirm that external-starting assistance is
suitable.
• Do not use any accessory that is not recommended or provided by the manufacturer.
• This system is designed to be used only on vehicles with a 12 volt DC battery system. Do
not connect to a 6 volt or 24 volt battery system.
• Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after
the recommended number of attempts, discontinue boosting procedures and contact a qualified
technician to investigate why the engine did not start.
WARNING: Do not use this jump-starter on a watercraft. It is not qualified for marine applications.
WARNING: NEVER connect this product to a positive grounded vehicle.
WARNING: To reduce the risk of fire, make sure that the 12 volt outlet is free of debris
and the adaptor plug fits tightly in the outlet.
• Read And Understand This Instruction Manual Before Using This Unit.
4
BBC2CS_ManualENSP_080111.indd 4-5 8/1/2011 5:03:40 PM
Loading...