Stack-On FS User Manual [en, es, fr]

NOTE: You can store your Key #, Serial # and Combination on Stack-On’s SECURE web site – www.stack-on.com under Service. Storing your Key # or Combination will provide instant access to this important information should you ever lose your keys or your combination. Only you will have access to this information.

Installation Instructions

WARNING

Tip Over Hazard

A child or adult can tip the safe and be killed or seriously injured.

Failure to secure the safe as shown in these instructions can result in death or serious injury to children and adults.

Children should not play with or around the safe at any time.

Record the serial number from the tag on the back of the safe or from the tag on the front bottom corner of the safe.

Keep keys and combination in a secure place away from children. Do not store trouble key or this document in the safe.

Do not move this safe using its handle. The handle should only be used for opening and closing the door of the safe.

Removing the back panel on the door will void the fire rating.

Serial # / No de série / # de Serie:

IMPORTANT

Hardware supplied for mounting the safe to the floor: (2) Lag screws, (2) washers and (2) plastic anchors

Tools required: 17mm socket wrench, drill, 7/16” drill bit, 3/8” drill bit, Phillips screwdriver.

Combination # / Combinaison / # Combinación:

HANDLE ASSEMBLY (Select Models only)

Screw the 3 handle spokes into the hub and hand tighten. These spokes are located in the front foam packaging.

NOTE: Do not use this handle to move the safe.

SELECTING A LOCATION

Your safe should be installed in an isolated, dry and secure area.

For extra humidity control we recommend the

SAFE TOP

VIEW

use of a desiccant. Do not drill holes in the safe for electrical dehumidifying devices. This will void the fire rating.

For greater security the safe should be located in a corner and fastened to the floor. (Figure 1)

The safe should be flat against the wall and floor.

Remove the baseboard if necessary. (Figure 2)

SECURING THE SAFE

If you are going to secure your safe to the floor it will first be necessary to drill pilot holes through the fire insulation in the floor of the safe. First place the safe in the desired location. Lift the bottom carpeting up to find the two hole locations marked on the floor insulation. Drill holes through the insulation using the same diameter drill as the diameter of the mounting hardware you are using. IMPORTANT: The fasteners you use must completely fill the hole you drilled into the insulation. (Figure 3) You must use the fasteners after you drill the holes. Failure to do so will void the fire rating.

Use these holes to fasten the safe to the floor. Drill the appropriate diameter and depth of pilot holes into the floor depending on the type of hardware being used and the type of floor surface. (Figure 2)

Secure the safe with the fasteners and replace the carpeting.

MODELS WITH OPTIONAL SHELVING

The shelving can be installed by locating the shelf clips to the desired locations and setting the shelf in place. (Figure 4)

Do not store electronic media, computer disks, audio-visual media or photographic negatives in this safe. This material will not survive the rated internal temperature of the safe. This material may be damaged or destroyed.

FS&E-E

40249-1206

ELECTRONIC LOCK

You must first install the battery which is located in the front protective styrofoam (See BATTERY INSTALLATION below)

To open an electronic lock the first time, press the following numbers/symbols on the electronic keypad in this order: 1, 5, 9, #. (These numbers are preset. You should change the entry code as soon as possible after opening the safe to insure proper security). After you have entered the factory code, you will need to turn the handle clockwise to open the door. You will have 5 seconds to turn the handle before the locking mechanism is reactivated.

ENTERING YOUR SECURITY CODE

To enter your own security code you will need to follow the steps listed below:

1. After opening the electronic safe (with the preset factory code of 1, 5, 9, #) locate the small red red button on the inside of the door near the hinge.

2. Press the red button and then release it, you will hear a beep. The yellow light on the faceplate will be activated and will stay on for a period of time that should allow you to enter your code. You can only enter your code while the yellow light is on.

With the door open and the yellow light on, enter your own personal security code, which can be 3 - 8 digits long, and confirm your new code by pressing the " " symbol on the electronic touch pad. Before you close the door, try the new security code to make sure the lock releases the handle so you can turn it and retract the live action bolts. DO NOT SHUT THE DOOR UNTIL YOU HAVE

CONFIRMED THAT YOUR NEW SECURITY CODE HAS BEEN ENTERED CORRECTLY.

If the code fails, go through steps 1 and 2 again. If the code works successfully record your combination number on the front of this form or somewhere in your records, then you should lock the safe.

When you open the safe in the future enter the security code you have set followed by the " If the incorrect security code is entered 3 times you will have an automatic lockout for 20 seconds before you can try your code

again.

If the incorrect security code is entered 3 additional times there will be a 5-minute lockout before the code can be tried again.

TURNING THE KEYPAD SOUND OFF/ON

You can turn off the "Beep" sound of the keypad by entering the code 633. To turn the "Beep" sound on, enter the code 66.

BATTERY INSTALLATION

NOTE: When changing the battery, always hold the battery connecting cap while disconnecting or attaching the battery. Do not pull on the wires. Doing this could cause the power supply to become disconnected from the lock.

This safe uses one 9V alkaline battery. Under normal use, batteries will last about 1 year. When the battery is low and you press a button on the keypad, a red light will come on warning you that the battery is low.

To test the batteries, enter your security code. If the batteries are low the red light will come on momentarily. To replace the battery, remove the cover by pressing the tab and turning the cover as shown in the illustration. Replace the old

battery and screw the cover back in place.

# " symbol.

TROUBLE KEY

A "Trouble Key" has been provided in case you have forgotten or lost your security code. To open the safe using the trouble key follow the steps below:

1. Remove the cover by pressing the tab and turning the cover as shown in the illustration. The lock can hang by the connecting cable while unlocking the safe.

2. Insert the key in the key hole and turn clockwise 1/4 turn (until stopped) in order to unlock the safe. Rotate the handle and open the door.

3. Keep the door open until you have entered a new security code. Before entering your new code, remove the key and screw the cover back in place.

4. Enter your new security code following the instructions at the top of the page.

TAB

INSTALLATION OF SCOPE STAND-OFF

NOTE: The scope stand-off will function properly for many combinations of guns with scopes.

Screw the scope stand-off into the pilot hole of the barrel rest.

IMPORTANT

Keep keys and combination number in a secure place, away from children. Keep this record of your serial number and combination in a secure place separate from your safe. To order a replacement key set, follow the instructions on the attached form.

STACK-ON PRODUCTS CO., P.O. BOX 489, WAUCONDA, IL 60084

40249-1206

Key Request

“This is not a Registration Form”

Verification of ownership is required in order to receive replacement key for your security product.

In order to receive a replacement key to your security product:

1. Complete the following form and send to Stack-On Products.

2. Send a copy of your valid driver’s license along with the form.

3. Send a copy of the receipt showing the original purchase.

4. Security product owner must sign form.

5. Owner’s signature must be notarized.

6. Send $10.00 for replacement key. Personal Check, MasterCard, or Visa accepted.

7. Send completed information to:

Stack-On Products Company 1360 N. Old Rand Road

Serial Number______________________ Key Number (if applicable) _______

Unit Dimensions________________________________________

Unit Description___________________________________________________________

P.O. box 489 Wauconda, IL 60084

Owner’s Name ____________________________________ Date Purchased___/___/____

Owner’s Address ___________________________ Unit or Apt Number _________________

City ___________________________ State _______________ Zip Code________________

Telephone Number: (____)___________________ Fax Number: (____)___________________

Owner’s Email Address: ________________________________________________________

Owner’s Signature __________________________ Notary Signature________________

Notary Commission Expires: _____/_____/_____ Notary Stamp

SERVICE REQUESTED

Key Replacement: Yes No $10.00 charge for this service

Credit Card Information (Please circle one) MasterCard Visa

Expiration Date: ___/___/___ Card Number:______________________________________

Credit Card Identification Number (Located on back of card, last 3 digits on signature strip)_________ 9/07

40249-1206



 



LIMITED LIFETIME GUARANTEE AND LIMITED FIVE YEAR WARRANTY

STACK-ON FIRE RESISTANT SAFE

(

Valid Only for Purchases in North America)

If your Stack-On Fire Resistant Steel Safe suffers damage due to theft or fire at any time while still owned by the original owner, Stack-On will either repair or replace (at Stack-On’s discretion) your safe free of charge. If Stack-On chooses to repair the safe, such repair work may be performed by a local technician approved by Stack-On. Depending on the exten of the damage, Stack-On may require the safe be returned to the factory for repair. If the safe is so returned, Stack-On will pay the freight to the factory as well as the return freight. If the safe is replaced, Stack-On will pay the freight. This guarantee does not cover labor costs for removal or installation of the safe and its contents. Any repair, dismantling, o tampering undertaken without the prior written approval or direction of Stack-On will nullify this guarantee. Personal property in the safe is not covered under this guarantee.

In addition, Stack-On Fire Resistant Steel Safes are warranted to be free from defects in material and workmanship for a period of five (5) years from the date of original purchase by a consumer. This warranty extends to the initial consume only. If you believe there is a defect in material or workmanship in your Stack-On Fire Resistant Steel Safe during the 5 year warranty period, please contact our customer service department at the address and in the manner set forth below. If Stack-On is properly notified during the 5-year warranty period and, after inspection confirms there is a defect, Stack-On will, at its sole option, provide repair parts or exchange the product at no charge, or refund the purchase price of the product.

THIS WARRANTY DOES NOT COVER ANY PRODUCT, OR ANY PART OF ANY PRODUCT, WHICH HAS BEEN SUBJECT TO EXCESSIVE USE, ACCIDENT, NEGLIGENCE, INCORRECT MAINTENANCE, ALTERATION OR REPAIR BY ANYONE OTHE THAN STACK-ON, ABUSE, OR MIS USE.

THIS WARRANTY IS EXCLUSIVE AND EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, W HICH ARE HEREBY DISCLAIMED AND EXCLUDED. STACK-ON SHALL NOT BE SUBJECT TO ANY OTHER OBLIGATIONS OR LIABILITIES. STACK-ON NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT, AN OTHER LIABILITY IN CONNECTION WITH THE SALE OF STACK-ON'S FIRE RESISTANT STEEL SAFES.

STACK-ON WILL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE TO THE INITIAL CONSUMER FOR ANY INCIDENTAL, CONSEQUENTIAL, SPECIAL, EXEMPLARY, OR PUNITIVE DAMAGES ARISING OUT OF THE PURCHASE OR USE OF ANY STACK-ON PRODUCTS, INCLUDING THE FIRE RESISTANT STEEL SAFES. STACK-ON'S LIABILITY FO

NY BREACH OF THIS WARRANTY SHALL BE LIMITED EXCLUSIVELY TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT, AS DESCRIBED ABOVE, OR A REFUND OF THE PURCHASE PRICE OF THE PRODUCT. IN NO EVENT SHALL STACK-ON'S OBLIGATION UNDER THIS WARRANTY EXCEED THE PRICE OF THE PRODUCT.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGH TS W HICH VAR Y FROM STAT E TO STATE.

Please send your claim pursuant to the above guarantee or warranty in writing by regular mail or email to:

Be sure to include:

Your name and address A description of the warranty claim, fire or theft The model number and photographs of the safe The serial number off the front or back of the safe A copy of the report from the fire department, police or insurance company within 30 days of damage (applies to units damaged by theft or fire) Proof of purchase information of the safe

This product is not designed for the storage of computer disks, CDs, DVDs, audio - v isual materials or photographs/negatives.

08/07

Stack-On Products Co. Attn.: Customer Service Department 1360 North Old Rand Road Wauconda, IL 60084 customerservice@stack-on.com

40249-1206

+ 8 hidden pages