Stabila REC User guide

Receiver REC

GB

Operating instructions

7

GB

We thank you for selecting our product. The STABILA REC receiver you have just
purchased is a high-quality, easy to operate portable receiver suitable for displaying
height reference data from rotation laser units. We wish you much enjoyment of your
purchase.

Main components

Mit dem Receiver REC können Laserstrahlen von Rotationslasern empfangen werden,
auch wenn sie für das menschliche Auge nicht mehr sichtbar sind.
We have endeavoured to explain the unit's handling and functioning in as clear and
comprehensible manner as possible. If, however, you still have any unanswered
questions, we should be pleased to provide advice over the telephone at any time on
the following telephone number: 0049 / 63 46 / 3 09-470

Operating instructions

1.

ON/OFF & volume selector switch: after switching on, press­ing the button again selects the relevant volume level.
Holding the button depressed (for 2 seconds) switches the
unit off.

3

4

5

7

8

2

1

6

9

2. Beeper output:
beams the acoustic signal relative to the laser plane.

3. Laser receiver glass: protects the photocells, which lie
behind it and receive the laser beam.

4. LCD display window: visually displays the position relative
to the laser plane. Also shows the battery status and
whether the unit is switched on.

5. Clamp guide channel: for sliding in the retention clamp.

6.Fixing point: fastens the clamp in place after it has been
moved into its final (retention) position.

7. Marking groove: for marking reference heights - the upper
edge of the receiver is 2.5cm higher than the centre position
("Height OK").

8. Serial number label

9. Battery compartment door: for 2 AA (LR6) batteries. When

inserting the batteries, please ensure that the polarity is
correct, as shown on the drawing in the label inside.
Pressing the cover into the seal ensures dust and water­tightness. Use a coin on the clip to open the door.

The ID label is inside.