The description, testing procedures, and specifications contained in this parts / service publication were current at time of writing. This
manual will not be updated. If in doubt about any aspect of maintenance or servicing of the axle please contact the vehicle builder or our
service department directly.
SPICER® products are subject to continuos development and we reserve the right to modify procedures and to make changes in
specifications at any time without prior notice and without incurring in any obligation.
The recommendations of the vehicle manufacturer should be considered as the primary source of service information regarding this
SPICER® product. This manual is intended to be used as a supplement to such information.
Any references to brand names in this publication are made simply as an example of the types of tools and materials recommended for
use and, as such, should not be considered as an endorsement.
This manual is the property of Commercial Vehicle Products – Europe, a division of Dana Holding Corporation, and may not be
copied or disseminated without prior agreement of Commercial Vehicle Products– Europe, a divison of Dana Holding Corporation.
Commercial Vehicle Products – Europe, a division of Dana Holding Corporation, recommends following all manufacturers
recommendations for the proper handling and disposal of lubricants and solvents. For further information please contact the lubricants
and solvents supplier.
EVERY EFFORT HAS BEEN MADE TO ENSURE THE ACCURACY OF THE INFORMATION CONTAINED WITHIN THIS MANUAL.
HOWEVER, COMMERCIAL VEHICLE PRODUCTS – EUROPE, A DIVISION OF DANA HOLDING CORPORATION, MAKES NO
EXPRESSED OR IMPLIED WARRANTY OR REPRESENTATION BASED ON THE ENCLOSED INFORMATION.
Last Modification Date Approved by Date Issue Document Eng. Change
C.Goñi 23-12-08 JP. Navarro 23-12-08 B IPL-0020 NC08720
A. Urio 11-05-09 C. Goñi 11-05-09 C IPL-0020 NC09488
C.Goñi 25-05-09 V. Badiola 25-05-09 D IPL-0020 NC09504
A. Urio 21-07-10 JP. Navarro 21-07-10 E IPL-0020 NC10539
C.Goñi 12-01-11 JP. Navarro 12-01-11 F IPL-0020 NC11406
C.Goñi 23/02/11 JP. Navarro 23/02/11 G IPL-0020 NC11433A
A. Urio 24/03/11 A. Urio 24/03/11 H IPL-0020 NC11455
IPL-0020 Rev. H 2
826240 826241 826341 826242 826342 826243 826343 826284 826244 826245 826345 826246 826346 826247 826347 826248
10.989.444 10.981.342 11.204.899 10.989.448 11.204.884 10.989.450 11.204.892 11.107.438 10.990.638 10.989.442 11.204.896 10.989.449 11.204.883 10.989.454 11.204.885 10.989.455
3.07 4.56 3.07 4.56
Draw. Item Desc ription Qty
-- -- HOUSING 1
-- -- HEAD ASSY 1 831629 831633 831629 831633
1 CARRIER-CAPS ASSY 1
1A BEARING CAP. 1
1B BEARING CAP. 1
1C BOLT 6
1D WEB-BEARING PILOT 1
1E BUSHING, DOWEL 2
1F BOLT 4
2 BEARING CONE 1
3-5 BRG CUP 2
4 BEARING SPACER
6 BEARING CONE 1
7 OIL SEAL 1
8 LOCKNUT 1
Draw. 1
9 BRG, PINION PILOT 1
10 SPIDER 1
11 SIDE PINION 4
12 SIDE GEAR 2
13 GEAR SET 1 R832463B R832451B
13A CROWNWHEEL 1 R832464B R832452B
13B PINION 1 R832465B R832453B
14 DIFF CASE FLANGE 1
15 SCREW 16
16 DIFF CASE PLAIN 1 131479 131479
17 BEARING CONE 2
18 BRG CUP 2
19 IDENTIFICATION TAG 1
20 RIVET, POP 2
Draw. 2
21 COUPLING FLANGE 1
22 MUD SLINGER 1
23 BOLT 10
24 BOLT 4
25 PLUG, MAGNETIC 1
26 PLUG, MAGNETIC 1
27 KIT BREATHER 1
28 AXLE SHAFT 1
29 AXLE SHAFT 1
30 BOLT 20
31 BRAKE KNORR L.H. 1 829785 829785 828130 829785 828130 829785 828130 829785 829785 829785 828130 829785 828130 829785 828130 829785
Draw. 3
32 BRAKE KNORR R.H. 1 829786 829786 828131 829786 828131 829786 828131 829786 829786 829786 828131 829786 828131 829786 828131 829786
33 BOLT 12
34 HUB M/C HUB UNIT 2
35 UNITISED BEARING 2
35A "O" RING 2
36 ROTOR KNORR 2
37 WHEELBOLT 20
38 BOLT ROTOR 20
39 NUT & WASHER KIT 2
39A NUT, HUB 2
39B SPINDLE WASHER 2
40 ABS SENSOR 2
Draw. 4
41 ABS BUSHING 2
42 ABS BRAKET 2
IPL-0020 Rev. H 3