COMPACT
POST HOLE DIGGER
MODEL NO. S24045000
OWNER’S MANUAL
ASSEMBLY & OPERATING INSTRUCTIONS
WARNING: All operators must read this manual before operating this post hole digger. Follow the safety instructions in the manual and in decals attached to the product. Failure to do so could result in serious injury or death.
PD36-718-0612
Rev. 2
Table of Contents |
|
|
Page(s) |
Important Safety Information ................................................................................................. |
1-4 |
Intended Use .............................................................................................................. |
1 |
Personal Protective Equipment .................................................................................. |
1 |
Safety Decals ............................................................................................................. |
1-3 |
General Safety and Preparation .................................................................................. |
3 |
Operating Safety ......................................................................................................... |
3-4 |
Repair and Maintenance Safety ................................................................................. |
4 |
Assembly Instructions ............................................................................................................ |
5 |
Operating Instructions ............................................................................................................. |
6 |
General Maintenance ............................................................................................................. |
6 |
Parts List ................................................................................................................................. |
7 |
Parts Breakdown Illustration ................................................................................................... |
8 |
Cutting Edges and Point Parts List ......................................................................................... |
9 |
Notes ...................................................................................................................................... |
10 |
Specifications ......................................................................................................................... |
11 |
Ordering Information .............................................................................................................. |
11 |
WARNING: Read and thoroughly understand all instructions and safety information before assembling or operating this post hole digger Failure to do so may cause serious injury or death. Do not allow anyone to operate this post hole digger who has not read this manual. As with all power equipment a post hole digger can be dangerous if assembled or used improperly. Do not operate this post hole digger if you have doubts or questions concerning safe operation. Call our customer service department at 1-800-525-8322 to address these concerns.
Si no entiende ingles, se prefiere que busque alguien que interprete las instrucciones para usted.
INTENDED USE
This product is designed to dig holes in the soil when attached to the 3-point linkage system and power-take-off of a tractor. It is not intended for any other use. Using the product for anything other than digging holes could result in serious injury or death.
PERSONAL PROTECTIVE EQUIPMENT
ALWAYS use appropriate personal protective equipment such as protective eyewear and safety shoes when operating this post hole digger.
NEVER wear loose clothing or jewelry that could become entangled in the auger or driveline.
SAFETY DECALS
ALWAYS replace missing or defaced decals. Reorder from SpeeCo, Inc., 15000 W. 44th Ave., Golden, CO 80403 or call 1-800-525-8322.
PART NUMBER: DL5202010
LOCATION: TOP OF BOOM ON GEAR BOX END
Page 1
PART NUMBER: S52020200
LOCATION: UPPER RIGHT SIDE OF BOOM
PART NUMBER: S52020300
LOCATION: UPPER LEFT SIDE OF BOOM AND PTO DRIVE SHAFT SHIELD
PART NUMBER: S52020400
LOCATION: BOTH SIDES OF GEAR BOX SHIELD
PART NUMBER: S51019200 LOCATION: PTO DRIVE SHAFT SHIELD
PART NUMBER: S52056400 LOCATION: TOP OF BOOM, TRACTOR END
PART NUMBER: S52066500
LOCATION: TOP OF BOOM, TRACTOR END
Page 2
PART NUMBER: S52020500
LOCATION: TOP END OF AUGER TUBE
NOTE: IF THE OUTPUT SHAFT GUARD MENTIONED IN THE ABOVE DECAL IS MISSING ,YOU MAY ORDER A REPLACEMENT BY CALLING US AT 1-800-525-8322.
GENERAL SAFETY AND PREPARATION
ALWAYS make sure that anyone else who operates this post hole digger has read and understood the contents of the owner’s manual and all safety decals on the product.
ALWAYS be certain that all members of the work party are familiar with the operation of the digger and the hazards associated with it.
ALWAYS check with authorities for underground utilities before digging a hole. Serious injury or death could result from contact with gas or electric lines.
ALWAYS check the tractor owner’s manual for instructions on operation, attachment of 3-point equipment and safety.
ALWAYS make sure that all safety shields are in place and tightened down. Do not operate this post hole digger if any shields are missing. Contact SpeeCo, Inc. at 1-800-525-8322 for replacement part(s).
ALWAYS make sure that the auger point and cutting edges are intact and in good working order before using this digger.
OPERATING SAFETY
ALWAYS operate this post hole digger from the tractor seat. Only one person should operate the digger.
NEVER attach the post hole digger with the tractor engine running.
NEVER operate the post hole digger with anyone near or in contact with any part of the implement, PTO driveline or auger.
Serious injury or death could result from entanglement with moving parts.
Page 3
Loading...