Spear & Jackson XSZ41D Instruction manual

IN THE BOX

QUICK START

GUIDE

41cm 125cm3 self propelled

Petrol
Lawnmower

XSZ41D

1 2 3

1. Main mower deck (with upper handle attached)

2. Lower handle with rope guide

3. Grass collection bag 1pc

4. Handle fixing bolts 4pcs

5. Quick clamp 2pcs

6. Cable clip 1pc

7. Spanner 1pc

8. Plug wrench 1pc

4

6

7 8

5

Important - Please read these instructions
fully before starting assembly

These instructions contain important information that will help
you get the best from your mower, ensuring it is assembled correctly
and safely. If you need help or have damaged or missing parts,
call the Customer Helpline on 0345 605 2067

AFTER SALES SUPPORT

0345 605 2067

1

2

ASSEMBLE

OPERATE

Unpack the lawn mower ensuring all parts are present

1

2

Align the lower handle with
the holes in the deck. Fix the
lower handle using the 4
handle fixing bolts onto
the deck firmly with supplied
wrench. Make sure that
the rope guide is in the
when you stand behind the mower.

Fix the upper and lower
handle with supplied quick
clamps, ensuring cables are
not twisted. Use the cable
clip to secure the cables to
the handle.

right

3

,

4

PREPARE

Attach the grass bag to
the frame by fixing all plastic
hooks.

Lift the flap and
hook the grass bag
over the plastic
hooks on the rear
of the mower.

Do not start the engine before putting 500ml of SAE 30 oil into the engine.
Failure to do so will result in irreparable damage to the engine and
invalidate your warranty.

Fill the petrol tank with 0.8l of normal 95 Octane petrol (standard unleaded) using a funnel and
measuring jug.

9

Engine stop

10

Engine start

When starting a cold
engine, press down the
primer fully 3~5 times.
When starting a warm
engine, the primer
does not need to be
used.

Hold the stop/start bar
firmly to the handle to
keep the engine running.

11

12

PRIMER BULB

3~5 TIMES

To stop the mower release the stop/start bar.

IMPORTANT INFORMATION!

STOP/START-LEVER
CLOSED

To start the engine slowly
pull the start cord out
until resistance is felt
(approx 10-15cm) then
start the engine with a
sharp vigorous pull.

Pull up the propulsion lever
to engage the self propelled
function.

PULL STARTING

-KNOB

PROPULSION-LEVER
CLOSED

5

7

Adjust the cutting
height via the lever
located at the rear
right wheel.

Fill the petrol tank with 0.8l
of normal 95 Octane petrol
(standard unleaded) using
a funnel and measuring jug.

6

Add Full

8

The engine does not
come with oil. Add

0.5 litres SAE 30 oil.

CHECK THE OIL LEVEL
BEFORE EVERY USE.

Slowly pull out starter
rope & hook it through
the eye of rope guide.
You should ALWAYS
start your mower
from this position.

In cold weather it may be necessary to repeat the cold engine starting
process.

Never allow the starter cord to snap back.

Check the oil level before every use.

SAE30 oil (or equivalent eg 5W 30, often termed as 4 Stroke lawn mower oil).

Always use high quality detergent oil classified

If you have any difficulties please contact the

helpline on 0345 605 2067

Always read the instruction manual thoroughly before starting the lawnmower.