Page 1
OWNER’S MANUAL
AIM Monitor LCR
Home Theater Monitors
Congratulations on your purchase of SpeakerCraft’s AIM Monitor LCR Speaker. The AIM Monitor LCR has
been t imbre matched to SpeakerCraft’s MT and CRS series Speakers, providing an outstanding home
theater experience.
SPEAKER PLACEMENT
The AIM Monitor LCR speaker can be used in any position
of a home theater speaker system. A single AIM Monitor
LCR can be used for the front center channel, or a pair can
be used for front or rear left and right. Because the
Monitor LCR speaker is magnetically shielded, it is perfectly
safe to place it close to the television.
AIM
®
Use as a Center Channel Speaker
The AIM Monitor LCR has been designed to blend seam
lessly with SpeakerCraft architectural in-wall and
in-ceiling speakers, specifically the Mirror Image Technology
(MT) Series. With the cabinet positioned horizontally, place
the AIM Monitor LCR as close to the screen as possible.
This most often means it will need to be placed directly
on top of or just below the television with the front of the
cabinet as far forward as possible, preferably flush with the
screen. Vertically lining up the cabinet with the left and
right speakers while not necessary, will improve the perfor
mance. (Figure #1)
Use as Front Left and Right Speakers
When using the AIM Monitor
tweeter towards the screen. (Figure #2) Best results are achieved when the left, right and center channel speakers are all
the same distance away from the listener. The front left and right speakers should be placed so that they form an equilat
eral triangle, with the listener at one point and each speaker at the other two. (Figure #3)
LCR for front left and right speakers, the cabinets should be positioned vertically with the
-
-
Figure #1
Place Above
Or Below
-
SpeakerCraft
Figure #2 Figure #3
Page 2
Page 2 AIM Monitor LCR Owner’s Manual
Page 2 Eazy6 Owner’s Manual
SPEAKER ADJUSTMENTS
Uni-Pivot Midrange / Tweeter Module
The Uni-Pivot can be used to best direct the critical high frequencies towards the listener. The Uni-Pivot easily rotates and pivots
to almost any position desired. (See Diagram 8) Simply apply pressure with fingertips to the outer surface of the Uni-Pivot and
rotate to the desired position. The Uni-Pivot should never be rotated more than 90˚ in a clockwise or counterclockwise direction.
CAUTION: Be sure not to apply pressure to the tweeter dome, as permanent damage will probably occur.
Push here to
adjust Uni-Pivot
Midrange Tweeter Module
Figure #4
Rotates Left to Right
• If the speakers are being used as main front channels, the Uni-Pivot should be angled towards the listener.
• If the speakers are being used for rear surround channels, you may wish to point the Uni-Pivot away from
the listener to achieve a more diffused sound.
• If is mounted verticaly, the Uni-Pivot can be rotated to stand in an upright position. (See Diagram 5)
Rotates Down
Rotates Up
Diagram 5
SPEAKER INSTALLATION
Attaching Self-Adhesive Isolation Pads
Once you have decided on the placement of the LCR following the above guidelines, attach the enclosed pads at each corner
of the side that is placed down.
Wiring the Speaker
Attach the speaker cable (observing the proper polarity with your amplifier, + to + and - to -).
Page 3
AIM Monitor LCR Owner’s Manual Page 3
SPEAKER SPECIFICATIONS
Monitor One LCR
• Shelf Mounted cabinet speaker
• Black Ash Cabinet
• Two Each 6
Woofer
• One Each 2
Uni-Pivot
• One Each
Uni-Pivot Tweeter
• 5-way Gold Binding Posts
• Fully Shielded
• Timbre Matched to MT One and
One 6" and 8" Series Speakers
CRS
• Dimensions:
1
H8
⁄
4
• Power Recommendation: 5-120 watts
1
⁄2" Polypropylene
1
⁄2" Polypropylene
Midrange
3
⁄4" Treated Silk Dome
"w/Feet x D10
1
⁄
"w/Grille x L 20
4
Monitor Three LCR
• Shelf Mounted cabinet speaker
• Black Ash Cabinet
• Two Each 6
Woofer
• One Each 1" Aluminum Dome
Uni-Pivot
• One each 2
Uni-Pivot Midrange
• 5-way Gold Binding Posts
• Fully Shielded
• Timbre Matched to MT Three and
CRS
1
⁄2"
• Dimensions:
1
H8
⁄
4
• Power Recommendation: 5-140 watts
1
⁄2" Aluminum
Tweeter
1
⁄2" Aluminum Dome
Three 6" and 8" Series Speakers
1
"w/Feet x D10
⁄
"w/Grille x L 20
4
1
⁄2"
Monitor Four LCR
• Shelf Mounted cabinet speaker
• Black Ash Cabinet
• Two Each 8" Aluminum/Magnesium
Woofer
• One Each 1
Dome Uni-Pivot Tweeter
• One Each 2
Dome Uni-Pivot Midrange
• 5-way Gold Binding Posts
• Fully Shielded
• Timbre Matched to MT Three and
CRS Three 6" and 8" Series Speakers
• Dimensions:
1
H10
⁄
4
• Power Recommendation: 5- 220 watts
Aluminum/Magnesium
"
1
⁄2" Aluminum/Magnesium
1
"w/Feet x D10
⁄
"w/Grille x L 25"
4
• Impedance: 8 ohm
• Frequency Response:
44Hz - 20kHz ± 3dB
• Efficiency: 90dB
• Impedance: 8 ohm
• Frequency Response:
38Hz - 20kHz ± 3dB
• Efficiency: 91dB
• Impedance: 8 ohm
• Frequency Response:
35Hz - 20kHz ± 3dB
• Efficiency: 93dB
In our attempt to constantly improve our products, features and specifications are subject to change without notice.
Page 4
Page 4 AIM Monitor LCR Owner’s Manual
LIMITED LIFETIME WARRANTY
SpeakerCraft Inc. warrants to the original retail purchaser only that this SpeakerCraft product will be free from defects in materials and workmanship, provided the speaker was purchased from a SpeakerCraft Authorized Dealer.
Defective products must be shipped, together with proof of purchase, prepaid insured to the SpeakerCraft Authorized Dealer from whom
they were purchased, or to the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will
be refused. It is preferable to ship this product in the original shipping container to lessen the chance of transit damage. In any case, the
risk of loss or damage in transit is to be borne by the purchaser. If, upon examination at the Factory or SpeakerCraft Authorized Dealer, it is
determined that the unit was defective in materials or workmanship at any time during this warranty period, SpeakerCraft or the SpeakerCraft
Authorized Dealer will, at its option, repair or replace this product at no additional charge, except as set forth below. If this model is no longer
available and can not be repaired effectively, SpeakerCraft, at its sole option, may replace the unit with a current model of equal or greater
value. In some cases where a new model is substituted, a modification to the mounting surface may be required. If mounting surface modifi
cation is required, SpeakerCraft assumes no responsibility or liability for such modification. All replaced parts and product become the property
of SpeakerCraft Inc. Products replaced or repaired under this Warranty will be returned to the original retail purchaser, within a reasonable
time, freight prepaid.
This Warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing
or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or modification of the
product which has not been authorized or approved by SpeakerCraft. This Warranty also excludes normal cosmetic deterioration caused by
environmental conditions. This warranty will be void if the Serial Number on the product has been removed, tampered with or defaced.
This Warranty is in lieu of all other expressed warranties. If the product is defective in materials or workmanship as warranted above, the
purchaser’s sole remedy shall be repair or replacement as provided above. In no event will SpeakerCraft be liable for any incidental or conse
quential damages arising out of the use or inability to use the product, even if SpeakerCraft Inc. or a SpeakerCraft Inc. Authorized Dealer has
been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of
consequential damages, so the above limitation and exclusion may not apply.
-
-
All implied warranties on the product are limited to the duration of this expressed Warranty. Some states do not allow limitation on the length
of an implied warranty. If the original retail purchaser resides in such a state, this limitation does not apply.
SpeakerCraft offers a variety of accessories to make your installation of this and other SpeakerCraft products easy, economical, and
professional. Contact your authorized SpeakerCraft Dealer for more information.
Should you have any questions regarding this, or any other SpeakerCraft product, please call our toll-free service hotline at
1-800-448-0976. We are available to assist you every weekday, except holidays, between the hours of 7:00 a.m. and 5:00 p.m. PST.
940 Columbia Avenue, Riverside, CA 92507
(800) 448-0976 Fax (951) 787-8747
www.speakercraft.com
SpeakerCraft
®
LIT97605
Loading...