Spalding M88724C1 User Manual

1
08/06 ID# M88724C1
High End Residential
In-Ground Basketball System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
Toll-Free Customer Service Number for U.S: 1-800-334-9111
Write Model Number
From Box Here:
WARNING!
READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE USING THIS UNIT.
FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY.
This manual, accompanied by sales receipt, should be saved and kept on hand as a convenient reference, as it contains
important information about your model.
Adult Assembly Required.
2
ID# M88724C1 08/06
Owner must ensure that all players know and follow these rules
for safe operation of the system.
WARNING
DO NOT HANG on the rim or any part of the system including backboard, support braces or net.
During play, especially when performing dunk type activities, keep player's face away from the backboard, rim and net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.
Do not slide, climb, shake or play on base and/or pole.
When adjusting height or moving system, keep hands and fingers away from moving parts.
Do not allow children to move or adjust system.
During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net.
Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration.
Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace pole immediately.
Check system before each use for proper ballast, loose hardware, excessive wear and signs corrosion and repair before use.
Check system before each use for instability.
Never play on damaged equipment.
Keep pole top covered with cap at all times.
See instruction manual for proper installation and maintenance.
Read and understand warnings listed below before using this product.
Failure to follow these warnings may result in serious injury and/or property damage.
ID#: 588000 01/05
In the U.S.: 1-800-xxx-xxxx
Canada: 1-800-xxx-xxxx
In the U.S.: 1-800-xxx-xxxx
Canada: 1-800-xxx-xxxx
In the U.S.: 1-800-xxx-xxxx
Canada: 1-800-xxx-xxxx
In the U.S.: 1-800-xxx-xxxx
Canada: 1-800-xxx-xxxx
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this system.
• If using a ladder during assembly, use extreme caution.
• Three (3) capable adults are recommended for this operation.
• Before digging, contact utility company to locate underground power cables, gas, and water lines. Ensure there are no overhead power lines within 20 ft. (7 m) radius of pole location.
• Climate, corrosion, excessive use, or misuse could result in system failure.
• If technical assistance is required, contact Customer Service.
• Minimum operational height is 6'6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NOT excessive competitive play.
• Read and understand the warning label affixed to pole.
• The life of your basketball pole depends on many conditions. The climate, placement of the pole, the location of the pole, exposure to corrosives such as pesticides, herbicides or salts are all important.
• Adult supervision is recommended when adjusting height.
• Serious injury could occur if teeth/face come in contact with backboard, net, or rim.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and
follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. Check entire box and inside all packing material for parts and/or additional instructional material. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document.
For more information on assembly, placement, proper use and maintenance, visit The American Basketball Council website at http://www.smarthoops.com.
REQUIRED TOOLS AND MATERIALS:
• 3 Capable Adults
• Carpenter’s Level
• 15’ Tape Measure
• Shovel & Post Hole Digger
• Wood Board (scrap)
• (2) Stepladders 8 ft. (2.4 m)
• Safety Goggles
• Container to Mix
• (2 each) Wrenches and/or Socket Wrenches and Sockets (Deep-Well Sockets are Recommended).
1/2"
9/16"
3/4"
15/16"
• Optional: Large & Small Adjustable Wrenches
1/2" 9/16" 3/4"
15/16"
• (1) Utility Knife
• Phillips-Head Screwdriver
Item Qty.
Part No. Description
1 1 968880 Pole 2 1 908266 Tube, 8x8, Ground Anchor, Black 3 1 Rim Assembly 4 1 Net 5 4 203017 Nut, Hex, 3/8-16 6 4 203300 Washer, 3/8 Locking, .380 I.D., .63 O.D. 7 4 200512 Bolt, Hex, 3/8-16 x 3.5” Long 8 1 204922 Pin, Hitch
9 1 204923 Pin, Cotter, #8 10 3 204993 Rebar, .5” diameter, 18” Long 11 1 516000 Label, Height Adjustment 12 1 204940 Screw Jack 13 1 Backboard 14 1 80854501 Rod, Threaded Assembly, 5/8-11 x 19.8”, Zinc 15 4* 203309 Washer, Flat, 3/8” 16 1 Cover, Rim 17 1 978880 Yoke, Upper, Center, Pole 18 1 988883 Yoke, Lower, Center, Pole 19 26 204670A Bushing, Plastic 20 1 202900 Bolt, Hex, 1/2-13 x 5 21 16 202651 Washer, Flat, .053 I.D., 1.08 O.D. 22 9* 206340 Nut, Lock, Nylon Insert, 1/2-13 23 1* 220048 Bolt, Hex Head, 1/2”-13 x 6” 24 9 200704 Washer, 5/8 Flat, .656 I.D., 1.313 O.D. 25 8 265575 Nut, Hex, 5/8-11 26 1 215008 Nut, Hex, 5/8-11, Grade 8, Black Zinc 27 1 204921 Washer, Barrel 28 3 224728 Bolt, Hex, 1/2-13 x 9.25 29 4 204733 Screw, #8, 0.50 Long 30 2 204735 Height Indicator, Plastic 31 1 204741 Label, Height Indicator, Right 32 1 204742 Label, Height Indicator, Left 33 2* 206311 Spacer, .52 I.D. x .75 O.D. x .5” Long, Plastic 34 4 205830 Bolt, Hex, 1/2-13 x 2.5
* You May Have Extra Parts With This Model.
PARTS LIST
11
3
08/06 ID# M88724C1
ID# 516000 06/05
4
ID# M88724C1 08/06
Item #5 (4)
Item #34 (4)
Item #24 (9)
Item #7 (4)
Item #28 (3)
Item #20 (1)
Item #23 (1)*
Item #25 (8)
Item #26 (1)
Item #22 (9)*
Item #8 (1)
Item #9 (1)
HARDWARE IDENTIFIER (NUTS, WASHERS & SPACERS)
HARDWARE IDENTIFIER (BOLTS & SCREWS)
Item #27 (1)
Item #19 (26)
HARDWARE IDENTIFIER (OTHER—NOT ACTUAL SIZE)
Item #21 (16)
Item #6 (4)
Item #33 (2)*
Item #15 (4)*
Item #29 (4)
5
08/06 ID# M88724C1
Ensure ground is level with playing surface, then dig pole hole.
CONTACT UTILITIES BEFORE DIGGING.
WARNING!
24" (61 cm)
48" (121.9 cm)
PLAYING SURFACE
GROUND SURFACE
24" (61 cm)
48" (121.9 cm)
1.
2.
Install nuts (25) onto the ground tube bolts as shown.
Nuts on the top of the plate are used for leveling the pole after system is fully assembled.
NOTE:
2
25
6
ID# M88724C1 08/06
SIDE VIEW
DRAINAGE HILL
PLAYING SURFACE
Fill hole with concrete. Tamp down concrete to release air pockets and build drainage hill.
3.
Insert rebar (10) through holes in ground tube assembly (2) as shown.
4.
10
10
10
2
1" (2.54 cm)
Loading...
+ 14 hidden pages